Collector cum storage solar water heaters with and without transparent insulation material

Abstract The integrated collector–storage solar water heaters are less expensive and can offer the best alternative for domestic applications particularly to small families to meet hot water requirements. The top heat losses of such solar water heaters are quite high during the night and the temperature of stored hot water is considerably reduced unless covered with extra insulating cover in the evening which is a cumbersome job. The transparent insulation material widely used in Europe for space heating can also minimize top heat losses, if used in such solar water heaters. For this purpose, two units of solar collector cum storage water heaters have been designed to study the relative effect of TI for retaining solar heated hot water for a night duration. Both units were identical in all respects except one of them was covered with TIM. The theoretical exercise was carried out to evaluate design parameters of ISC which revealed total heat loss factor ( U L ) 1.03 W/m 2 K with TIM glazed against 7.06 W/m 2 K with glass glazed. The TIM glazed has been found to be quite effective as compared to glass glazed SWH and yielded hot water at higher temperature by 8.5 to 9.5°C the next morning. The storage efficiency of such solar water heaters has been found to be 39.8% with TIM glazed as compared to 15.1% without TIM. The TIM glazing means not having to cover the ISC solar water heater with a separate insulator cover in the evening and thus makes its operation much simpler.

[1]  Brian Norton,et al.  A design nomogram for direct thermosyphon solar-energy water heaters , 1989 .

[2]  N. M. Nahar,et al.  Studies on collector‐cum‐storage type solar water heaters under arid zone conditions of india , 1988 .

[3]  Cameron Johnstone,et al.  Strathclyde University's passive solar, low-energy, residences with transparent insulation , 1994 .

[4]  Volker Wittwer,et al.  TRANSLUCENT INSULATION MATERIALS , 1986 .

[5]  Volker Wittwer,et al.  A new transparently insulated, bifacially irradiated solar flat-plate collector , 1992 .

[6]  Anne Grete Hestnes,et al.  The use of transparent insulation in low energy dwellings in cold climates , 1997 .

[7]  P. Chaurasia.  Transparent insulation material in solar system for candle production , 2000 .

[8]  N. D. Kaushika,et al.  Global radiation transmittance of transparent insulation materials , 1994 .

[9]  S. Klein,et al.  Analysis of solar domestic hot water heaters , 1980 .

[10]  P.B.L. Chaurasia.  Solar water heaters based on concrete collectors , 2000 .

[11]  W. Beckman,et al.  Solar Engineering of Thermal Processes , 1985 .

[12]  Bruno Peuportier,et al.  Comparative analysis of active and passive solar heating systems with transparent insulation , 1995 .

[13]  A. Goetzberger,et al.  Prospects for integrated storage collector systems in central Europe , 1987 .

[14]  Volker Wittwer,et al.  Transparent Insulation System for Passive Solar Energy Utilization in Buildings , 1984 .

[15]  H. P. Garg,et al.  Theoretical and experimental studies on collector/storage type solar water heater , 1982 .

[16]  S. Klein.  Calculation of Flat-Plate Collector Loss Coefficients , 1975, Renewable Energy.

[17]  H. P. Garg.  Year round performance studies on a built-in storage type solar water heater at Jodhpur, India , 1975 .

[18]  M Janak,et al.  Assessing the overall performance of advanced glazing systems , 1998 .

[19]  B. Goldberg,et al.  Solar radiation over India , 1983 .

[20]  Volker Wittwer,et al.  Transparent insulation materials , 1992, Other Conferences.

[21]  W. Read,et al.  Advances in solar water heating for domestic use in Australia , 1978 .