Abstract This paper reports on about an analytical and experimental study of a Variable Conductance Heat Pipe (VCHP) applied to vehicle thermal management. The reduction of engine energy consumption after a cold start by controlling heating–cooling cycle of oil is the objective of the present study. A theoretical model based on a nodal method and an experimental test bench was developed to study the performance of a copper/water VCHP, using nitrogen as a non-condensable gas. VCHP operate as a thermal switch, with a start-up temperature of 80 °C. The effect of the inclination angle (i.e., adverse-gravity, horizontal position or gravity-aided) was studied. The results allowed us to identify the effect of the air mass flow rate on the condenser and the effect inclination angle on the performance of the VCHP. Our results show that the VCHP performance improves with a small inclination angle aiding liquid return to the evaporator.
[1]
Ioan Sauciuc,et al.
Temperature control using variable conductance closed two-phase heat pipe
,
1996
.
[2]
Jacques Padet.
Convection thermique et massique - Nombre de Nusselt : partie 2
,
2015,
Physique énergétique.
[3]
Amir Faghri,et al.
Heat Pipe Science And Technology
,
1995
.
[4]
Souad Harmand,et al.
Transient thermal and hydrodynamic model of flat heat pipe for the cooling of electronics components
,
2008
.
[5]
Souad Harmand,et al.
Transient Cooling of Electronic Components by Flat Heat Pipes
,
2011
.