Frequency response of in-plane coupled resonators for investigating the acceleration sensitivity of MEMS tuning fork gyroscopes

The frequency response of in-plane coupled resonators is used for investigating the acceleration sensitivity of a MEMS tuning fork gyroscope (TFG) and a new method of suppressing the acceleration output is presented. The unbalancing of two sense resonators in the TFG caused by fabrication errors converted an external vibration into anti-phase mode excitation. To reduce the acceleration output, decoupling between in- and anti-phase modal frequencies [decoupling ratio (DR)] is crucial, since coupled resonators may cause large anti-phase vibrations from the acceleration. The acceleration output model was verified using two coupled resonators with 1 and 5 % stiffness unbalance. FEM simulation results showed a 25 % reduction in the anti-phase vibration by increasing the decoupling ratio from 0.09 to 0.29, irrespective of the coupled resonators designs. Quantitative analysis of a TFG based on coupled resonators with 1 % stiffness unbalance showed the acceleration output decreased from 5.65 to 1.43 deg/s/g.

[1]  J. Bernstein,et al.  A micromachined comb-drive tuning fork rate gyroscope , 1993, [1993] Proceedings IEEE Micro Electro Mechanical Systems.

[2]  G.A. Geen.  Progress in integrated gyroscopes , 2004, IEEE Aerospace and Electronic Systems Magazine.

[3]  R. Neul,et al.  Micromachined gyros for automotive applications , 2005, IEEE Sensors, 2005..

[4]  A.A. Trusov,et al.  Multi-Degree of Freedom Tuning Fork Gyroscope Demonstrating Shock Rejection , 2007, 2007 IEEE Sensors.

[5]  Y. Kato,et al.  Precise MEMS Gyroscope with Ladder Structure , 2007, TRANSDUCERS 2007 - 2007 International Solid-State Sensors, Actuators and Microsystems Conference.

[6]  Sang Won Yoon,et al.  Vibration Sensitivity of MEMS Tuning Fork Gyroscopes , 2007, 2007 IEEE Sensors.

[7]  K. Najafi,et al.  Single-crystal-silicon vibratory cylinderical rate integrating gyroscope (CING) , 2011, 2011 16th International Solid-State Sensors, Actuators and Microsystems Conference.

[8]  Farrokh Ayazi,et al.  Multi-DOF inertial MEMS: From gaming to dead reckoning , 2011, 2011 16th International Solid-State Sensors, Actuators and Microsystems Conference.

[9]  S. A. Zotov,et al.  Sub-degree-per-hour silicon MEMS rate sensor with 1 million Q-factor , 2011, 2011 16th International Solid-State Sensors, Actuators and Microsystems Conference.