Electrical characterization of thermomechanically stable YSZ membranes for micro solid oxide fuel cells applications

Abstract Yttria-stabilized zirconia free-standing membranes were fabricated by pulsed laser deposition on Si/SiO 2 /Si 3 N 4 structures for developing silicon-based micro devices for micro solid oxide fuel cell applications. Their mechanical stability under working conditions was evaluated satisfactorily by applying thermal cycling to the membranes. Membranes mechanically stable at operating temperatures as high as 700 °C were obtained for deposition temperatures in the range between 400 and 700 °C. Thermomechanical behavior as measured by X-ray microdiffraction was correlated with the evolution of the microstructure with the temperature from TEM analysis, comparing as-deposited and post-deposition annealed membranes. Electrical properties of both yttria-stabilized zirconia films and membranes were studied by DC conductivity and impedance spectroscopy, respectively. A difference of almost one order of magnitude was measured between bulk and stressed films while conductivities close to the bulk were observed for YSZ membranes. Values of area specific resistance of 0.15 Ωcm 2 were measured at temperatures below 450 °C for 240 nm thick YSZ membranes deposited at 600 °C and annealed at the same temperature for 2.5 h.

[1]  John B. Goodenough.  Oxide-ion electrolytes , 2003 .

[2]  A. Nagata,et al.  Characterization of solid oxide fuel cell device having a three-layer film structure grown by RF magnetron sputtering , 2002 .

[3]  G. Barucca,et al.  Excimer pulsed laser deposition and annealing of YSZ nanometric films on Si substrates , 2005 .

[4]  M. Kakihana,et al.  Determination of tetragonal-cubic phase boundary of Zr1-XRXO2-X/2 (R = Nd, Sm, Y, Er and Yb) BY Raman scattering , 1996 .

[5]  Fritz B. Prinz,et al.  Atomic layer deposition of yttria-stabilized zirconia for solid oxide fuel cells , 2007 .

[6]  Hui Xiong,et al.  An experimental investigation into micro-fabricated solid oxide fuel cells with ultra-thin La0.6Sr0.4Co0.8Fe0.2O3 cathodes and yttria-doped zirconia electrolyte films , 2009 .

[7]  E. R. Bradley,et al.  Correlation between the stress and microstructure in bias-sputtered ZrO2-Y2O3 films , 1984 .

[8]  L. Gauckler,et al.  Microstructures of CGO and YSZ Thin Films by Pulsed Laser Deposition , 2008 .

[9]  Christopher M. Rouleau,et al.  Nanoscale effects on the ionic conductivity in highly textured YSZ thin films , 2005 .

[10]  E. Wachsman,et al.  Ionic conduction in zirconia films of nanometer thickness , 2005 .

[11]  Chris R. M. Grovenor,et al.  The development of grain structure during growth of metallic films , 1984 .

[12]  B. Stoner,et al.  The effect of deposition parameters on the properties of yttria-stabilized zirconia thin films , 2003 .

[13]  Jennifer L. M. Rupp,et al.  Review on microfabricated micro-solid oxide fuel cell membranes , 2009 .

[14]  G. Choi,et al.  Electrical conductivity of YSZ film grown by pulsed laser deposition , 2006 .

[15]  M. Döbeli,et al.  Microstructure and electrical conductivity of YSZ thin films prepared by pulsed laser deposition , 2008 .

[16]  S. Spearing,et al.  Residual stress and microstructure of as-deposited and annealed, sputtered yttria-stabilized zirconia thin films , 2008 .

[17]  E. Voelkl,et al.  Phase Formation and Stability in Reactively Sputter Deposited Yttria-Stabilized Zirconia Coatings , 2001 .

[18]  E. Wachtel,et al.  Elasticity of Solids with a Large Concentration of Point Defects , 2006 .

[19]  S J Pennycook,et al.  Colossal Ionic Conductivity at Interfaces of Epitaxial ZrO2:Y2O3/SrTiO3 Heterostructures , 2008, Science.

[20]  Mario Birkholz,et al.  Thin Film Analysis by X-Ray Scattering , 2005 .

[21]  Klavs F. Jensen,et al.  Fabrication and structural characterization of self-supporting electrolyte membranes for a micro solid-oxide fuel cell , 2004 .

[22]  P. Gasser,et al.  Crystallization of amorphous ceria solid solutions , 2007 .

[23]  Carlone.  Raman spectrum of zirconia-hafnia mixed crystals. , 1992, Physical review. B, Condensed matter.

[24]  Dimos Poulikakos,et al.  A micro-solid oxide fuel cell system as battery replacement , 2008 .

[25]  Y. Estrin,et al.  Grain growth in thin metallic films , 2001 .

[26]  B. Stoner,et al.  Evaluation of crystallinity and film stress in yttria-stabilized zirconia thin films , 2005 .

[27]  H. Windischmann.  An intrinsic stress scaling law for polycrystalline thin films prepared by ion beam sputtering , 1987 .

[28]  M. Döbeli,et al.  Yttria-stabilized zirconia thin films by pulsed laser deposition: Microstructural and compositional control , 2010 .

[29]  W. Pawlewicz,et al.  Microstructure control for sputter-deposited ZrO2, ZrO2·CaO and ZrO2·Y2O3 , 1982 .

[30]  R. D. Gryse,et al.  Yttria-stabilized zirconia thin films grown by reactive r.f. magnetron sputtering , 1996 .

[31]  M. Kilo,et al.  Mechanical loss, creep, diffusion and ionic conductivity of ZrO2-8 mol%Y2O3 polycrystals , 2000 .