Stress analysis on centric through hole PCB

In this study, the bending process of PCB during depaneling is simulated. The stress response during the bending process is evaluated using a computational program Ansys. Two PCB plate model were developed: One of the model with centric through hole and other model without hole. The stress response of the two models are compared. From the simulation, it has been observed that the value of stress response of the PCB increases with increasing displacement height. The without hole PCB model exhibited a slightly higher stress response compared to the with centric through hole PCB model. Highest stress response for both models were recorded at the displacement height of 5cm.

[1]  Rao Tummala,et al.  Fundamentals of Microsystems Packaging , 2001 .

[2]  S. W. Ricky Lee,et al.  Correlation Between the Strain on the Printed Circuit Board and the Stress in Chips for the Failure Prediction of Passive Components , 2005 .

[3]  D. Lau,et al.  Experimental testing and computational stress analysis of printed circuit board for the failure prediction of passive components under the depaneling load condition , 2005, Proceedings Electronic Components and Technology, 2005. ECTC '05..

[4]  R.C. Mata,et al.  Reverse engineering for obsolete single layer printed circuit board (PCB) , 2006, 2006 International Conference on Computing & Informatics.

[5]  Zhaowei Zhong,et al.  Novel numerical and experimental analysis of dynamic responses under board level drop test , 2004, 5th International Conference on Thermal and Mechanical Simulation and Experiments in Microelectronics and Microsystems, 2004. EuroSimE 2004. Proceedings of the.

[6]  F.R. Leta,et al.  Computational system to detect defects in mounted and bare PCB Based on connectivity and image correlation , 2008, 2008 15th International Conference on Systems, Signals and Image Processing.