Reinforcement layout design of RC structures under multiple load cases using truss-like material model

[1]  Xiaoming Wang,et al.  A level set method for structural topology optimization , 2003 .

[2]  M. Bendsøe.  Optimal shape design as a material distribution problem , 1989 .

[3]  Jianhua Zhou,et al.  Structural Topology Optimization Through Explicit Boundary Evolution , 2017 .

[4]  Y. Xie,et al.  A simple evolutionary procedure for structural optimization , 1993 .

[5]  Michael Yu Wang,et al.  Topology optimization of reinforced concrete structures considering control of shrinkage and strength failure , 2015 .

[6]  Hyo-Gyoung Kwak,et al.  Determination of Strut-and-Tie Models using Evolutionary Structural Optimization , 2002 .

[7]  M. Zhou,et al.  Generalized shape optimization without homogenization , 1992 .

[8]  Osvaldo M. Querin,et al.  Generation of strut-and-tie models by topology design using different material properties in tension and compression , 2011 .

[9]  Yi Min Xie,et al.  Topology Optimization of Strut-and-Tie Models in Reinforced Concrete Structures Using an Evolutionary Procedure , 2000 .

[10]  Ole Sigmund,et al.  Reinforcement layout design for concrete structures based on continuum damage and truss topology optimization , 2013 .

[11]  Matteo Bruggi,et al.  A numerical method to generate optimal load paths in plain and reinforced concrete structures , 2016 .

[12]  K. Zhou,et al.  Topology optimization of structures under multiple load cases using a fiber-reinforced composite material model , 2006 .

[13]  Xu Guo,et al.  Doing Topology Optimization Explicitly and Geometrically—A New Moving Morphable Components Based Framework , 2014 .

[14]  Liang-Jenq Leu,et al.  Strut-and-Tie Design Methodology for Three-Dimensional Reinforced Concrete Structures , 2006 .

[15]  Zhan Kang,et al.  Layout design of reinforced concrete structures using two-material topology optimization with Drucker–Prager yield constraints , 2013 .

[16]  M. Bendsøe,et al.  Generating optimal topologies in structural design using a homogenization method , 1988 .

[17]  Matteo Bruggi,et al.  Generating strut-and-tie patterns for reinforced concrete structures using topology optimization , 2009 .