High-efficiency compressive-mode energy harvester enhanced by a multi-stage force amplification mechanism

Abstract Harnessing ambient vibration energy using piezoelectric materials is a promising alternative solution to batteries to inexhaustibly power small-scale mobile devices. This paper presents an innovative energy harvester, named high-efficiency compressive-mode piezoelectric energy harvester (HC-PEH). It consists of a pair of elastic beams and a flex-compressive center where the piezoelectric element bears a dynamic compressive load. The compressive mode is preferred than the commonly-used bending mode and tensile mode due to the superior compressive strength of piezoceramics. To cater to the characteristic of piezoceramics: large ultimate stress, but extremely small ultimate strain, a multi-stage force amplification mechanism is developed in the design. The HC-PEH shows superior capability of high power output and favorable nonlinear phenomena at low frequency range. Under an acceleration of 0.5 g (g = 9.8 m/s 2 ), a maximum power of 19 mW is produced at 21 Hz, which is about one order of magnitude higher than the power output of energy harvesters previously reported. The capability of high power output of the HC-PEH demonstrates the practicability of using energy harvesters to power most of wireless sensors.

[1]  D. Inman,et al.  Comparison of Piezoelectric Energy Harvesting Devices for Recharging Batteries , 2005 .

[2]  Daniel J. Inman,et al.  Powering pacemakers from heartbeat vibrations using linear and nonlinear energy harvesters , 2012 .

[3]  Ryan L. Harne,et al.  A review of the recent research on vibration energy harvesting via bistable systems , 2013 .

[4]  Ping Li,et al.  A two-dimensional broadband vibration energy harvester using magnetoelectric transducer , 2013 .

[5]  S. Priya.  Advances in energy harvesting using low profile piezoelectric transducers , 2007 .

[6]  Z. Zhong,et al.  Analysis of the displacement amplification ratio of bridge-type flexure hinge , 2006 .

[7]  B. H. Stark,et al.  Review of Power Conditioning for Kinetic Energy Harvesting Systems , 2012, IEEE Transactions on Power Electronics.

[8]  D. Guyomar,et al.  Toward energy harvesting using active materials and conversion improvement by nonlinear processing , 2005, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[9]  Kohji Yamamoto,et al.  Tensile Stress-Strain Behavior of Piezoelectric Ceramics , 1993 .

[10]  Timothy C. Green,et al.  Energy Harvesting From Human and Machine Motion for Wireless Electronic Devices , 2008, Proceedings of the IEEE.

[11]  Charles R. Farrar,et al.  Energy Harvesting for Structural Health Monitoring Sensor Networks , 2008 .

[12]  Xiaobiao Shan,et al.  Modeling and Improvement of a Cymbal Transducer in Energy Harvesting , 2010 .

[13]  Sang-Gook Kim,et al.  Ultra-wide bandwidth piezoelectric energy harvesting , 2011 .

[14]  Jaeyun Lee,et al.  Development of a piezoelectric energy harvesting system for implementing wireless sensors on the tires , 2014 .

[15]  Siu Wing Or,et al.  Energy harvesting using a modified rectangular cymbal transducer based on 0.71Pb(Mg1/3Nb2/3)O3–0.29PbTiO3 single crystal , 2010 .

[16]  C. Van Hoof,et al.  Micropower energy harvesting , 2009, ESSDERC 2009.

[17]  Daniel J. Inman,et al.  Strength analysis of piezoceramic materials for structural considerations in energy harvesting for UAVs , 2010, Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[18]  Theo Fett,et al.  Tensile and bending strength of piezoelectric ceramics , 1999 .

[19]  Peng Zeng,et al.  Kinetic Energy Harvesting Using Piezoelectric and Electromagnetic Technologies—State of the Art , 2010, IEEE Transactions on Industrial Electronics.

[20]  Jari Juuti,et al.  Energy harvesting with a cymbal type piezoelectric transducer from low frequency compression , 2012, Journal of Electroceramics.

[21]  Daniel J. Inman,et al.  An experimentally validated bimorph cantilever model for piezoelectric energy harvesting from base excitations , 2009 .

[22]  D. Markley,et al.  Energy Harvesting Using a Piezoelectric “Cymbal” Transducer in Dynamic Environment , 2004 .

[23]  Yaowen Yang,et al.  Toward Broadband Vibration-based Energy Harvesting , 2010 .

[24]  Paul M. Weaver,et al.  Charge redistribution in piezoelectric energy harvesters , 2012 .

[25]  G. Gautschi.  Piezoelectric Sensorics: Force Strain Pressure Acceleration and Acoustic Emission Sensors Materials and Amplifiers , 2002 .

[26]  D. Peroulis,et al.  Low-frequency meandering piezoelectric vibration energy harvester , 2012, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[27]  Daniel J. Inman,et al.  Piezoelectric Energy Harvesting , 2011 .