Application of adhesives in MEMS and MOEMS assembly: a review

This paper presents a review of the recent literature on the use of adhesives in MEMS packaging applications. The aim of this review has been to establish the current applications of adhesives in MEMS and MOEMS assembly and to investigate the limitations and future requirements of these materials. The review has shown that while there is a wealth of information available on the packaging of MEMS devices, there is very limited detail available within the public domain regarding the specific uses of adhesives and in particular exactly which products are in use. The paper begins with an overview of the uses of adhesives in MEMS packaging, subdivided into sections on structural adhesives, adhesives for optical applications and other applications. The paper then describes methods for adhesive dispensing and issues with adhesive use which affect the reliability of the package. The reliability of MEMS devices assembled using adhesives is a challenging issue, being more than a simple combination of electrical, mechanical and material reliability. Many failure modes in MEMS devices can be attributed to the adhesives used in the assembly; for example, thermal expansion mismatches can cause stress in the die attach, while outgassing from epoxies can cause failure of sealed devices and contamination of optical surfaces.

[1]  S. D. Collins,et al.  A micromachined pressure sensor with fiber-optic interferometric readout , 1994 .

[2]  Review of conductive adhesives and inks for microengineered devices , 1997 .

[3]  Gerhard Klink,et al.  Wafer bonding with an adhesive coating , 1998, Photonics West - Micro and Nano Fabricated Electromechanical and Optical Components.

[4]  Jochen Kuhmann,et al.  Stacking Technology for a Space Constrained Microsystem , 1998, Proceedings MEMS 98. IEEE. Eleventh Annual International Workshop on Micro Electro Mechanical Systems. An Investigation of Micro Structures, Sensors, Actuators, Machines and Systems (Cat. No.98CH36176.

[5]  W.D. Brown,et al.  Challenges in the packaging of MEMS , 1999, Proceedings International Symposium on Advanced Packaging Materials. Processes, Properties and Interfaces (IEEE Cat. No.99TH8405).

[6]  S C Esener,et al.  Characterization of a polymer microlens fabricated by use of the hydrophobic effect. , 2000, Optics letters.

[7]  M. H. Tanielian,et al.  Evaluation and characterization of reliable non-hermetic conformal coatings for microelectromechanical system (MEMS) device encapsulation , 2000 .

[8]  R. Takahashi,et al.  2 Gbit/s small form factor fiber-optic transceiver for single mode optical fiber , 2000 .

[9]  M. Deeds,et al.  Test and evaluation of chip-to-chip attachment of MEMS devices , 2000, ITHERM 2000. The Seventh Intersociety Conference on Thermal and Thermomechanical Phenomena in Electronic Systems (Cat. No.00CH37069).

[10]  M. Wu,et al.  A substrate-independent wafer transfer technique for surface-micromachined devices , 2000, Proceedings IEEE Thirteenth Annual International Conference on Micro Electro Mechanical Systems (Cat. No.00CH36308).

[11]  Rao Tummala,et al.  Fundamentals of Microsystems Packaging , 2001 .

[12]  Mona E. Zaghloul,et al.  MEMS: micro technology, mega impact , 2001 .

[13]  A. Tseng,et al.  Low stress packaging of a micromachined accelerometer , 2001 .

[14]  Ken Gilleo,et al.  Getters — Molecular Scavengers for Packaging , 2001 .

[15]  3-D Microsystem Packaging for Interconnecting Electrical, Optical and Mechanical Microdevices to The Eexternal World. , 2001 .