Application of the Hilbert-Huang Transform for Identification of Changes in Boundary Conditions of a Bridge Using Vibration Data due to Traffic

The translational restraints associated to pin and rocker bearings are typically idealized in the form of fixed and free conditions. However, elastomeric bearings need to be represented with springs to reasonably predict the time- and frequency-domain response of bridges under traffic-induced vibrations. Therefore, changes in the response of these bearings are common as a result of aging, deterioration, variation in loading levels and/or environmental changes. The latter makes difficult to discern if changes in the frequency content of the structural response to ambient vibration are due to changes in temperature, changes in normal operational loads or the occurrence of damage. In this paper, the bridge is idealized by a beam model supported on a hysteretic translational sprung support. The purpose is twofold: (a) to gather a better understanding of the variations of the bridge response with bearing performance; and (b) to be able to quickly identify an anomaly in the bearing. Empirical Mode Decomposition and the Hilbert-Huang Transform are employed to capture changes in the bearing stiffness from the bridge response.

[1]  R. Nickel,et al.  On the stability of approximation operators in problems of structural dynamics , 1971 .

[2]  Arturo González,et al.  A wavelet-based damage detection algorithm based on bridge acceleration response to a vehicle , 2012 .

[3]  D. M. McFarland,et al.  Toward a Fundamental Understanding of the Hilbert-Huang Transform in Nonlinear Structural Dynamics , 2006 .

[4]  Matthew J. Whelan,et al.  Assessment of Simplified Linear Dynamic Analysis of a Multispan Skew Bridge on Steel-Reinforced Elastomeric Bearings , 2012 .

[5]  I. D. Aiken,et al.  ANALYTICAL MODELING OF ELASTOMERIC ISOLATION BEARINGS UNDER SEVERE AXIAL LOAD AND SHEAR DEFORMATIONS , 2008 .

[6]  Fabio Casciati,et al.  Experimental investigation on the aging of the base isolator elastomeric component , 2012 .

[7]  Ian D. Aiken,et al.  AN ANALYTICAL HYSTERESIS MODEL FOR ELASTOMERIC SEISMIC ISOLATION BEARINGS , 1997 .

[8]  Hai Huang,et al.  Speech pitch determination based on Hilbert-Huang transform , 2006, Signal Process..

[9]  R. Clough,et al.  Dynamics Of Structures , 1975 .

[10]  Hoon Sohn,et al.  Environmental variability of modal properties , 1999 .

[11]  N. Huang,et al.  The empirical mode decomposition and the Hilbert spectrum for nonlinear and non-stationary time series analysis , 1998, Proceedings of the Royal Society of London. Series A: Mathematical, Physical and Engineering Sciences.

[12]  S. V. Bakre,et al.  Performance of Non-Linear Elastomeric Base-Isolated building structure , 2011 .

[13]  Yen-Po Wang,et al.  Physical system identification of an isolated bridge using seismic response data , 2009 .

[14]  John L. Tassoulas,et al.  Analysis of elastomeric bridge bearings , 1995 .

[15]  Tso Chien Pan,et al.  A mathematical hysteretic model for elastomeric isolation bearings , 2002 .

[16]  D. K. Paul,et al.  Force-Deformation Behavior of Isolation Bearings , 2007 .

[17]  Ratneshwar Jha,et al.  Damage detection in an experimental bridge model using Hilbert–Huang transform of transient vibrations , 2013 .

[18]  Michael Feldman,et al.  Non-linear system vibration analysis using Hilbert transform--I. Free vibration analysis method 'Freevib' , 1994 .

[19]  Roy R. Craig,et al.  Structural Dynamics: An Introduction to Computer Methods , 1981 .

[20]  Susendar Muthukumar,et al.  A Contact Element Approach with Hysteresis Damping for the Analysis and Design of Pounding in Bridges , 2003 .