High-Frequency-Link DC Transformer Based on Switched Capacitor for Medium-Voltage DC Power Distribution Application

This paper proposes a practical solution of high-frequency-link dc transformer based on switched capacitor (SCDCT) for medium-voltage dc (MVDC) power distribution application. Compared to the traditional dc transformer scheme, the proposed SCDCT can disconnect from MVDC distribution grid effectively as a dc breaker when a short fault occurs in the distribution, can enhance power transfer capacity, and always ensures high-frequency-link voltage match to improve current impact and efficiency performances, and the redundancy design can be achieved when some submodules fail to improve the reliability. In the paper, the topology, voltage and power characterization, control strategy, startup, and fault solution of SCDCT are presented and analyzed comprehensively. At last, an SCDCT prototype is built and the experimental results verify the correctness and effectively of the proposed solution.

[1]  Wenhua Liu,et al.  A Steady-State Analysis Method for a Modular Multilevel Converter , 2013, IEEE Transactions on Power Electronics.

[2]  Guowei Liu,et al.  Universal High-Frequency-Link Characterization and Practical Fundamental-Optimal Strategy for Dual-Active-Bridge DC-DC Converter Under PWM Plus Phase-Shift Control , 2015, IEEE Transactions on Power Electronics.

[3]  Mansour Tabari,et al.  Stability of a dc Distribution System for Power System Integration of Plug-In Hybrid Electric Vehicles , 2014, IEEE Transactions on Smart Grid.

[4]  Ahmed M. Massoud,et al.  Multiple-Module High-Gain High-Voltage DC–DC Transformers for Offshore Wind Energy Systems , 2011, IEEE Transactions on Industrial Electronics.

[5]  H. Kakigano,et al.  Distribution Voltage Control for DC Microgrids Using Fuzzy Control and Gain-Scheduling Technique , 2013, IEEE Transactions on Power Electronics.

[6]  Wenhua Liu,et al.  Overview of Dual-Active-Bridge Isolated Bidirectional DC–DC Converter for High-Frequency-Link Power-Conversion System , 2014, IEEE Transactions on Power Electronics.

[7]  K.S. Tang,et al.  A ZCS bidirectional flyback DC/DC converter , 2004, IEEE Transactions on Power Electronics.

[8]  Amit Patra,et al.  Control Scheme for Reduced Cross-Regulation in Single-Inductor Multiple-Output DC–DC Converters , 2013, IEEE Transactions on Industrial Electronics.

[9]  Jing Sun,et al.  Power Flow Characterization of a Bidirectional Galvanically Isolated High-Power DC/DC Converter Over a Wide Operating Range , 2010, IEEE Transactions on Power Electronics.

[10]  P. Zumel,et al.  Control strategy for modular Dual Active Bridge input series output parallel , 2013, 2013 IEEE 14th Workshop on Control and Modeling for Power Electronics (COMPEL).

[11]  Tsai-Fu Wu,et al.  DC-Bus Voltage Control With a Three-Phase Bidirectional Inverter for DC Distribution Systems , 2013, IEEE Transactions on Power Electronics.

[12]  Heung-Geun Kim,et al.  Effective Test Bed of 380-V DC Distribution System Using Isolated Power Converters , 2015, IEEE Transactions on Industrial Electronics.

[13]  Stefano Bifaretti,et al.  Advanced Power Electronic Conversion and Control System for Universal and Flexible Power Management , 2011, IEEE Transactions on Smart Grid.

[14]  Hui Li,et al.  High-Frequency Transformer Isolated Bidirectional DC–DC Converter Modules With High Efficiency Over Wide Load Range for 20 kVA Solid-State Transformer , 2011, IEEE Transactions on Power Electronics.

[15]  P. Alou,et al.  DC transformer for DC/DC connection in HVDC network , 2013, 2013 15th European Conference on Power Electronics and Applications (EPE).

[16]  Harish S. Krishnamoorthy,et al.  Wind Turbine Generator–Battery Energy Storage Utility Interface Converter Topology With Medium-Frequency Transformer Link , 2014, IEEE Transactions on Power Electronics.

[17]  C. L. Kala-Konga,et al.  Multilevel switched-capacitor DC-DC converter with reduced capacitor bank , 2010, IECON 2010 - 36th Annual Conference on IEEE Industrial Electronics Society.

[18]  Liangzong He High-Performance Bridge Modular Switched-Capacitor Converter With Small Component Requirement Based on Output Impedance Analysis for Low Loss , 2013, IEEE Transactions on Power Electronics.

[19]  Yuen-Haw Chang,et al.  Modeling and implementation of high-gain switched-inductor switched-capacitor converter , 2014, 2014 International Symposium on Integrated Circuits (ISIC).

[20]  Wenhua Liu,et al.  Efficiency Characterization and Optimization of Isolated Bidirectional DC–DC Converter Based on Dual-Phase-Shift Control for DC Distribution Application , 2013, IEEE Transactions on Power Electronics.

[21]  Robert C. Youngquist,et al.  A DC Transformer , 2014, IEEE Transactions on Power Electronics.

[22]  Daolian Chen Novel Current Mode AC/AC Converters with High Frequency AC Link , 2008, 2005 IEEE 36th Power Electronics Specialists Conference.

[23]  Zhe Zhang,et al.  Analysis and Design of a Bidirectional Isolated DC–DC Converter for Fuel Cells and Supercapacitors Hybrid System , 2012, IEEE Transactions on Power Electronics.

[24]  Gilsung Byeon,et al.  Energy Management Strategy of the DC Distribution System in Buildings Using the EV Service Model , 2013, IEEE Transactions on Power Electronics.

[25]  Leila Parsa,et al.  Series-Input Parallel-Output Modular-Phase DC–DC Converter With Soft-Switching and High-Frequency Isolation , 2016, IEEE Transactions on Power Electronics.

[26]  D.J. Hammerstrom,et al.  AC Versus DC Distribution SystemsDid We Get it Right? , 2007, 2007 IEEE Power Engineering Society General Meeting.