Characterization of Tiled Architecture for C-Band 1-Bit Beam-Steering Transmitarray

A new implementation of a beam-steering transmitarray is proposed based on the tiled array architecture. Each pixel of the transmitarray is manufactured as a standalone unit which can be hard-wired for specific transmission characteristics. A set of complementary units, providing reciprocal phase-shifts, can be assembled in a prescribed spatial phase-modulation pattern to perform beam steering and beam forming in a broad spatial range. A compact circuit model of the tiled unit cell is proposed and characterized with full-wave electromagnetic simulations. Waveguide measurements of a prototype unit cell have been carried out. A design example of a tiled 10 × 10-element 1-bit beam-steering transmitarray is presented and its performance benchmarked against the conventional single-panel, i.e., unibody, counterpart. Prototypes of the tiled and single-panel C-band transmitarrays have been fabricated and tested, demonstrating their close performance, good agreement with simulations and a weak effect of fabrication tolerances. The proposed transmitarray antenna configuration has great potential for fifth-generation (5G) communication systems.

[2]  L. Dussopt,et al.  Design and demonstration of 1-bit and 2-bit transmit-arrays at X-band frequencies , 2009, 2009 European Microwave Conference (EuMC).

[3]  L. Dussopt,et al.  A switched-beam linearly-polarized transmitarray antenna for V-band backhaul applications , 2016, 2016 10th European Conference on Antennas and Propagation (EuCAP).

[4]  Andrew J. Roscoe,et al.  Large finite array analysis using infinite array data , 1994 .

[5]  Jinyuan Liu,et al.  Impact of Element Pattern on the Performance of GNSS Power-Inversion Adaptive Arrays , 2019 .

[6]  D.F. Kelley,et al.  Embedded element patterns and mutual impedance matrices in the terminated phased array environment , 2005, 2005 IEEE Antennas and Propagation Society International Symposium.

[7]  Chan-Byoung Chae,et al.  Reconfigurable Intelligent Surface-Based Wireless Communications: Antenna Design, Prototyping, and Experimental Results , 2019, IEEE Access.

[8]  Xiangang Luo,et al.  Using Reconfigurable Transmitarray to Achieve Beam-Steering and Polarization Manipulation Applications , 2015, IEEE Transactions on Antennas and Propagation.

[9]  J. Kelly,et al.  Conformal Transmitarray for Scan Loss Mitigation with Thinned Reconfiguration , 2019, 2019 13th European Conference on Antennas and Propagation (EuCAP).

[10]  Nan Hu,et al.  A Novel 1-Bit Reconfigurable Transmitarray Antenna Using a C-Shaped Probe-Fed Patch Element With Broadened Bandwidth and Enhanced Efficiency , 2020, IEEE Access.

[11]  P. Turalchuk,et al.  A Study of C-Band 1-Bit Reconfigurable Dual-Polarized Transmitarray , 2019, 2019 13th European Conference on Antennas and Propagation (EuCAP).

[13]  J. Y. Lau,et al.  Reconfigurable Transmitarray Design Approaches for Beamforming Applications , 2012, IEEE Transactions on Antennas and Propagation.

[14]  David M. Pozar,et al.  Increasing the bandwidth of a microstrip antenna by proximity coupling , 1987 .

[15]  A. Tulino,et al.  Intelligent Reflecting and Transmitting Surface Aided Millimeter Wave Massive MIMO. , 2019 .

[16]  R. Sauleau,et al.  Design of a 2-bit unit-cell for electronically reconfigurable transmitarrays at Ka-band , 2017, 2017 European Radar Conference (EURAD).

[17]  R. Caldeirinha,et al.  Electronically Reconfigurable FSS-Inspired Transmitarray for 2-D Beamsteering , 2017, IEEE Transactions on Antennas and Propagation.

[18]  Fernando Las-Heras,et al.  A Simple Model for Analyzing Transmitarray Lenses , 2015, IEEE Antennas and Propagation Magazine.

[19]  Yang Chen,et al.  A C-Band Flat Lens Antenna With Double-Ring Slot Elements , 2013, IEEE Antennas and Wireless Propagation Letters.

[20]  Laurent Dussopt,et al.  Circularly-Polarized Reconfigurable Transmitarray in Ka-Band With Beam Scanning and Polarization Switching Capabilities , 2017, IEEE Transactions on Antennas and Propagation.