Effect of mechanochemical treatment on structure and electrical properties of montmorillonite

Abstract This study investigates the effect of grinding on the structure of montmorillonite (MMT). Both XRD and IR analyses indicate a gradual breakdown of the mineral layers and a decrease of the crystallinity with grinding. The prolonged grinding is accompanied with an amelioration of oxidant capacity of MMT which could be attributed to the conversion of structural Fe 2+ to Fe 3+ cations caused by adsorbed atmospheric oxygen and/or to the exposition of more Fe 3+ cation to the surface of the mineral. The evolution of acidity of MMT during grinding has been carried out by determining the point of zero charge (pH pzc ) of MMT and the pH of the aqueous suspension of MMT. It was shown that pH pzc increases with grinding from 6.2 to 8.1 respectively for untreated MMT and that ground for 30 min. On the other side the pH of MMT suspension increases from 4.75 to 8.18 respectively for untreated MMT and that ground for 75 min. These two results indicate that acidity of MMT has been lost during grinding. TGA analysis shows that the thermal decomposition of the ground MMT for 90 min takes place in a single step. This behavior has been explained by the formation of less tightly bound hydroxyl groups. Electrical and dielectric properties have been studied using impedance spectroscopy. It has been established that grinding is accompanied by an increase of dc conductivity and dielectric constant in the range of MHz. Moreover, it has been observed a shift of bound water relaxation frequency to lower frequency. These changes could be attributed to the enhancement of mobility of interlayer cations and to the perturbation of the state of interlayer water which could be connected to the defects in the octahedral sheet rather than being entirely localized at the interlayer space of MMT.

[1]  H. Olphen.  An Introduction to Clay Colloid Chemistry , 1977 .

[2]  J. Pérez-Rodríguez,et al.  Effects of dry grinding on pyrophyllite , 1988, Clay Minerals.

[3]  E. Srasra,et al.  Green synthesis of polyaniline/clay/iron ternary nanocomposite by the one step solid state intercalation method , 2015 .

[4]  M. Haeckel,et al.  Reactive Fe(II) layers in deep-sea sediments , 1999 .

[5]  A. T. Perkins,et al.  Decomposition of Minerals By Grinding , 1950 .

[6]  J. A. Schwarz,et al.  Estimation of the point of zero charge of simple oxides by mass titration , 1989 .

[7]  J. Hrachová,et al.  The effect of mechanical treatment on the structure of montmorillonite , 2007 .

[8]  A. Esawi,et al.  Effect of ball milling on the structure of Na+-montmorillonite and organo-montmorillonite (Cloisite 30B) , 2010 .

[9]  A. Jonscher.  Dielectric relaxation in solids , 1983 .

[10]  Aiqin Wang,et al.  Effect of dry grinding on the microstructure of palygorskite and adsorption efficiency for methylene blue , 2012 .

[11]  Darui Liu,et al.  Wet grinding of montmorillonite and its effect on the properties of mesoporous montmorillonite , 2010 .

[12]  Dimos Triantis,et al.  Dielectric properties of non-swelling bentonite: The effect of temperature and water saturation , 2008 .

[13]  W. D. Keller.  Oxidation of montmorillonite during laboratory grinding , 1955 .

[14]  E. Morillo,et al.  Effect of grinding on the preparation of porous materials by acid-leached vermiculite , 2007 .

[15]  A. Hamzaoui,et al.  Electrical conductivity of 1 : 1 and 2 : 1 clay minerals , 2014 .

[16]  S. Ugbolue,et al.  Size Reduction of Clay Particles in Nanometer Dimensions , 2002 .

[17]  S. D. Logsdon,et al.  Dielectric spectra of bound water in hydrated Ca-smectite , 2002 .

[18]  L. Boudriche,et al.  Influence of different dry milling processes on the properties of an attapulgite clay, contribution of inverse gas chromatography , 2014 .

[19]  E. Suess,et al.  Iron reduction through the tan-green color transition in deep-sea sediments , 1997 .

[20]  K. Kyuma,et al.  Factors affecting zero point of charge (zpc) of variable charge soils , 1989 .

[21]  S. Škapin,et al.  The surface properties of clay minerals modified by intensive dry milling — revisited , 2010 .

[22]  E. Srasra,et al.  Solid state polymerization and intercalation of aniline in Fe rich montmorillonite , 2011 .

[23]  Ageetha Vanaamudan,et al.  Adsorption of Reactive Blue 21 from aqueous solutions onto clay, activated clay, and modified clay , 2014 .

[24]  Tatiana Batista,et al.  Effect of sonication on the particle size of montmorillonite clays. , 2008, Journal of colloid and interface science.

[25]  G. Christidis,et al.  Structural modifications of smectites mechanically deformed under controlled conditions , 2005, Clay Minerals.

[26]  Yi Huang,et al.  Radar frequency dielectric dispersion in sandstone: Implications for determination of moisture and clay content , 2003 .

[27]  E. Srasra,et al.  Characterization and AC conductivity of polyaniline–montmorillonite nanocomposites synthesized by mechanical/chemical reaction , 2010 .

[28]  Bu Vroonn.  DEHYDROXYLATION AND REHYDROXYLATION, OXIDATION AND REDUCTION OF MICAS , 2007 .

[29]  L. Pérez-Maqueda,et al.  Talc from Puebla de Lillo, Spain. II. Effect of dry grinding on particle size and shape , 1997 .

[30]  B. Číčel,et al.  Mechanism of montmorillonite structure degradation by percussive grinding , 1981, Clay Minerals.

[31]  J. L. Carter,et al.  The electronic properties of aluminum oxide and the chemisorption of water, hydrogen, and oxygen , 1968 .