Experimental prototype and simulation optimization of micro-radial milliwatt-power radioisotope thermoelectric generator

Abstract To satisfy the flexible power demand of the low power dissipation devices in the independent space electric system, a micro-radial milliwatt-power radioisotope thermoelectric generator (RTG) was prepared and optimized in this research. The overall geometrical dimension of the RTG in the experiment was 65 mm (diameter) × 40 mm (height). The RTG, which was built and tested using simulated radioisotope source, eventually obtained an open-circuit voltage of 92.72 mV, an electric power of 149.0 μW, and an energy conversion efficiency of 0.015% at the ambient temperature of 293.15 K and heat source power from 0.1 W to 1 W. On the basis of the structure used in the experiment, the length and cross-sectional area of the thermoelectric leg and the number of thermoelectric modules were effectively optimized through the COMSOL Multiphysics. With the optimized length of 35 mm and cross-sectional area of 1.2 mm 2 , the RTG with four thermoelectric modules achieved a 15.8 mW output power under 1 W heat source power. The maximum conversion efficiency calculated using COMSOL code increased to 1.58%. According to the optimized electrical output, the micro-radial RTG is expected to be a reliable space power supply for micro components and could satisfy the low power requirements of space missions.

[1]  A. Pustovalov.  Nuclear thermoelectric power units in Russia, USA and European space agency research programs , 1997, XVI ICT '97. Proceedings ICT'97. 16th International Conference on Thermoelectrics (Cat. No.97TH8291).

[2]  Chin‐Hsiang Cheng,et al.  A three-dimensional numerical modeling of thermoelectric device with consideration of coupling of temperature field and electric potential field , 2012 .

[3]  P. Detemple,et al.  Coin-size coiled-up polymer foil thermoelectric power generator for wearable electronics , 2006 .

[4]  Zhiheng Xu,et al.  Parameter optimization and experiment verification for a beta radioluminescence nuclear battery , 2014, Journal of Radioanalytical and Nuclear Chemistry.

[5]  D. Astrain,et al.  Optimized design for flexible polymer thermoelectric generators , 2016 .

[6]  Alan H. Epstein,et al.  AN INFORMAL SURVEY OF POWER MEMS , 2003 .

[7]  Xiaodong Jia,et al.  Optimal design of a novel thermoelectric generator with linear-shaped structure under different operating temperature conditions , 2015 .

[8]  F. Rahmani,et al.  An approach to design a 90Sr radioisotope thermoelectric generator using analytical and Monte Carlo methods with ANSYS, COMSOL, and MCNP. , 2017, Applied radiation and isotopes : including data, instrumentation and methods for use in agriculture, industry and medicine.

[9]  Thomas George.  Overview of MEMS/NEMS technology development for space applications at NASA/JPL , 2003, SPIE Microtechnologies.

[10]  A. Pustovalov.  Mini-RTGs on plutonium-238: development and application , 1999, Eighteenth International Conference on Thermoelectrics. Proceedings, ICT'99 (Cat. No.99TH8407).

[11]  George R. Schmidt,et al.  NASA’s Program for Radioisotope Power System Research and Development , 2005 .

[12]  Chang Chung Yang,et al.  Modeling and simulation for the design of thermal-concentrated solar thermoelectric generator , 2014 .

[13]  Dennison,et al.  Measurement of Effects of Long Term Ionizing Radiation on High Efficiency Solar Arrays , 2015 .

[14]  Zhiheng Xu,et al.  Experimental and theoretical investigation of temperature effects on an interbedded betavoltaic employing epitaxial Si and bidirectional (63)Ni. , 2014, Applied radiation and isotopes : including data, instrumentation and methods for use in agriculture, industry and medicine.

[15]  Wei-Hsin Chen,et al.  Performance analysis and optimum operation of a thermoelectric generator by Taguchi method , 2015 .

[16]  Xinxin Zhang,et al.  Multi-objective and multi-parameter optimization of a thermoelectric generator module , 2014 .

[17]  Baolin Wang.  A finite element computational scheme for transient and nonlinear coupling thermoelectric fields and the associated thermal stresses in thermoelectric materials , 2017 .

[18]  S.P. Buchner,et al.  The Impact of the Space Radiation Environment on Micro Electro Mechanical Systems (MEMS) and Microstructures , 2005, 2005 8th European Conference on Radiation and Its Effects on Components and Systems.

[19]  Phillip M. Brooks,et al.  Final Safety Analysis: Ten-Watt Strontium-90 Fueled Generator for an Unattended Meteorological Station, SNAP-7C , 1962 .

[20]  A. Pustovalov,et al.  Experimental confirmation of milliwatt power source concept , 1999, Eighteenth International Conference on Thermoelectrics. Proceedings, ICT'99 (Cat. No.99TH8407).

[21]  Jing-Hui Meng,et al.  Characteristics analysis and parametric study of a thermoelectric generator by considering variable material properties and heat losses , 2015 .

[22]  C.E. Peterson,et al.  Multi-mission radioisotope thermoelectric generator (MMRTG) program overview , 2004, 2004 IEEE Aerospace Conference Proceedings (IEEE Cat. No.04TH8720).

[23]  D. Rowe.  CRC Handbook of Thermoelectrics , 1995 .

[24]  Christopher A. Apblett,et al.  Improving Power Density and Efficiency of Miniature Radioisotopic Thermoelectric Generators. , 2008 .

[25]  Bihong Lin,et al.  Optimal design of a multi-couple thermoelectric generator , 2000 .

[26]  T. F. Hursen,et al.  NUCLEAR ENERGY SOURCES * , 1969, Annals of the New York Academy of Sciences.

[27]  Nigel P. Bannister,et al.  A conceptual spacecraft radioisotope thermoelectric and heating unit (RTHU) , 2012 .

[28]  H. Atkinson,et al.  Safe radioisotope thermoelectric generators and heat sources for space applications , 2008 .