Thermodynamic analyses of municipal solid waste gasification plant integrated with solid oxide fuel cell and Stirling hybrid system

Abstract Municipal solid waste (MSW) can be considered a valid biomass to be used in a power plant. The major advantage is the reduction of pollutants and greenhouse gases emissions not only within large cities but also globally. Another advantage is that by their use it is possible to reduce the waste storage in landfills and devote these spaces to other human activities. It is also important to point out that this kind of renewable energy suffers significantly less availability which characterizes other type of renewable energy sources such as in wind and solar energy. In a gasification process, waste is subject to chemical treatments through air or/and steam utilization; the result is a synthesis gas, called “Syngas” which is principally composed of hydrogen and carbon monoxide. Traces of hydrogen sulfide could also be present which can easily be separated in a desulfurization reactor. The gasification process is usually based on an atmospheric-pressure circulating fluidized bed gasifier coupled to a tar-cracking vessel. Syngas can be used as fuel in different kind of power plant such as gas turbine cycle, steam cycle, combined cycle, internal and external combustion engine and Solid Oxide Fuel Cell (SOFC). In the present study, a MSW gasification plant integrated with SOFC is combined with a Stirling engine to recover the energy of the off-gases from the topping SOFC cycle. Detailed plant design is proposed and thermodynamic analysis is performed. Relevant parameters have been studied to optimize the plant efficiency in terms of operating conditions. Compared with modern waste incinerators with heat recovery, the gasification process integrated with SOFC and Stirling engine permits an increase in electricity output up of 50%, which means that the solid waste gasification process can compete with incineration technologies. Moreover waste incinerators require the installation of sophisticated exhaust gas cleaning equipment that can be large and expensive and are not necessary in the studied plant.

[1]  S. Mori,et al.  Combustion of refuse derived fuel in a fluidized bed , 1998 .

[2]  Ricardo Chacartegui,et al.  Stirling based fuel cell hybrid systems: An alternative for molten carbonate fuel cells , 2009 .

[3]  R. Kee,et al.  A general mathematical model for analyzing the performance of fuel-cell membrane-electrode assemblies , 2003 .

[4]  David Kennedy,et al.  Computer simulation of a biomass gasification-solid oxide fuel cell power system using Aspen Plus , 2010 .

[5]  Valerio Cozzani,et al.  Devolatilization and pyrolysis of refuse derived fuels: characterization and kinetic modelling by a thermogravimetric and calorimetric approach , 1995 .

[6]  Francesco Calise,et al.  Simulation and exergy analysis of a hybrid Solid Oxide Fuel Cell (SOFC)–Gas Turbine System , 2006 .

[7]  Masoud Rokni,et al.  Thermodynamic and thermoeconomic analysis of a system with biomass gasification, solid oxide fuel cell (SOFC) and Stirling engine , 2014 .

[8]  M Morris,et al.  Energy recovery from solid waste fuels using advanced gasification technology , 1998 .

[9]  Masoud Rokni,et al.  Thermodynamic analysis of SOFC (solid oxide fuel cell)–Stirling hybrid plants using alternative fuels , 2013 .

[10]  S. Campanari,et al.  A SOFC-based integrated gasification fuel cell cycle with CO2 capture , 2010 .

[11]  Mogens Bjerg Mogensen,et al.  Reaction of CO/CO2 gas mixtures on Ni–YSZ cermet electrodes , 1999 .

[12]  Dieter Froning,et al.  Clean combined-cycle SOFC power plant — cell modelling and process analysis , 2000 .

[13]  D. Meissner,et al.  Stability of Micro Tubular SOFCs Operated with Synthetic Wood Gases and Wood Gas Components , 2007, 2007 International Conference on Clean Electrical Power.

[14]  Yoshio Matsuzaki,et al.  Electrochemical Oxidation of H 2 and CO in a H 2 ‐ H 2 O ‐ CO ‐ CO 2 System at the Interface of a Ni‐YSZ Cermet Electrode and YSZ Electrolyte , 2000 .

[15]  Hermann Hofbauer,et al.  Coupling of Biomass Steam Gasification and an SOFC-Gas Turbine Hybrid System for Highly Efficient Electricity Generation , 2004 .

[16]  J. Smith,et al.  Introduction to chemical engineering thermodynamics , 1949 .

[17]  B. Xiao,et al.  Steam catalytic gasification of municipal solid waste for producing tar-free fuel gas , 2009 .

[18]  Sudip Ghosh,et al.  Energy analysis of a cogeneration plant using coal gasification and solid oxide fuel cell , 2006 .

[19]  Masoud Rokni,et al.  Thermodynamic Performance Study of Biomass Gasification, Solid Oxide Fuel Cell and Micro Gas Turbine Hybrid Systems , 2010 .

[20]  G. Reader.  The Pseudo Stirling cycle - A suitable performance criterion , 1978 .

[21]  Torben Kvist Jensen,et al.  Validation of a continuous combined heat and power (CHP) operation of a two-stage biomass gasifier , 2006 .

[22]  Harry A. Curtis,et al.  Chemical Engineering Thermodynamics (Dodge, Barnett F.) , 1945 .

[23]  A. Dalai,et al.  Gasification of refuse derived fuel in a fixed bed reactor for syngas production. , 2009, Waste management.

[24]  G. Naterer,et al.  Thermodynamic modeling of a gas turbine cycle combined with a solid oxide fuel cell , 2008 .

[25]  Masoud Rokni,et al.  Plant characteristics of an integrated solid oxide fuel cell cycle and a steam cycle , 2010 .

[26]  D. Rubenstein,et al.  Introduction to heat transfer , 2022 .

[27]  L. Fiori,et al.  Experimental and modeling analysis of a batch gasification/pyrolysis reactor , 2009 .

[28]  S Galvagno,et al.  Steam gasification of tyre waste, poplar, and refuse-derived fuel: a comparative analysis. , 2009, Waste management.

[29]  Kevin R. Keegan,et al.  Analysis of a Planar Solid Oxide Fuel Cell Based Automotive Auxiliary Power Unit , 2002 .

[30]  Masoud Rokni,et al.  Thermodynamic Investigation of an Integrated Gasification Plant with Solid Oxide Fuel Cell and Steam Cycles , 2012 .

[31]  S. Channiwala,et al.  A UNIFIED CORRELATION FOR ESTIMATING HHV OF SOLID, LIQUID AND GASEOUS FUELS , 2002 .

[32]  Shigekatsu Mori,et al.  Combustion test of refuse derived fuel in a fluidized bed , 2000 .

[33]  Paola Costamagna,et al.  Electrochemical model of the integrated planar solid oxide fuel cell (IP-SOFC) , 2004 .

[34]  F. R. Foulkes,et al.  Fuel Cell Handbook , 1989 .

[35]  Eric Liese,et al.  Comparison of Preanode and Postanode Carbon Dioxide Separation for IGFC Systems , 2010 .

[36]  V. Sharifi,et al.  Combustion of refuse-derived fuel in a fluidised bed , 2007 .

[37]  Kalyan Annamalai,et al.  Adiabatic fixed bed gasification of dairy biomass with air and steam , 2010 .

[38]  Henriksen,et al.  The Design , Construction and Operation of a 75 kW Two-Stage , 2004 .

[39]  Masoud Rokni,et al.  Thermodynamic analysis of an integrated solid oxide fuel cell cycle with a rankine cycle , 2010 .

[40]  M. Rokni.  Biomass gasification integrated with a solid oxide fuel cell and Stirling engine , 2014 .

[41]  U. Hohenwarter,et al.  High temperature electrolyte supported Ni-GDC/YSZ/LSM SOFC operation on two-stage Viking gasifier product gas , 2007 .

[42]  Brian Elmegaard,et al.  DNA – A General Energy System Simulation Tool , 2005 .

[43]  Paul T. Williams,et al.  Characterization of Products from the Pyrolysis of Municipal Solid Waste , 2007 .

[44]  Mogens Bjerg Mogensen,et al.  Solid oxide fuel cell development at Topsoe Fuel Cell and Risø , 2006 .

[45]  Petr Stehlík,et al.  Analysis of using gasification and incineration for thermal processing of wastes , 2005 .

[46]  Barnett F. Dodge,et al.  Chemical engineering thermodynamics , 1944 .