Decoupling of heat generated from ejected and non-ejected contents of 18650-format lithium-ion cells using statistical methods

Abstract Effective thermal management systems, designed to handle the impacts of thermal runaway (TR) and to prevent cell-to-cell propagation, are key to safe operation of lithium-ion (Li-ion) battery assemblies. Critical factors for optimizing these systems include the total energy released during a single cell TR event and the fraction of the total energy that is released through the cell casing versus through the ejecta material. A unique fractional thermal runaway calorimeter (FTRC), designed to characterize said critical factors, was utilized to examine the TR behavior of 18650-format Li-ion cells representing a variety of manufacturers, chemistries, capacities, and safety features. Primarily, the impacts of bottom vent (BV) safety features, varied cell casing thickness, and Dreamweaver cellulose based separators were assessed for select cell types. A subset of cells also had an imbedded internal short circuiting (ISC) device to allow examination of TR behavior initiated at lower temperatures (i.e. closer to field failure conditions). The impact of bottom rupture on TR behavior was also examined for experiments that resulted in this non-standard failure mechanism. Statistical analysis of the results for each cell configuration reveals that a lognormal distribution effectively characterizes the variation of total TR energy release. Typically 20%–30% of the total energy yield is released through the cell casing with the remainder through the ejecta material. Higher energy cells tend to exhibit more violent ejections and less predictable TR events. Inclusion of a BV feature reduces the overall severity of the TR event and can increase the predictability. Results also suggest that the magnitude of the TR event may not be directly proportional to the stored electrical energy, but rather has additional dependence on other design and failure mode factors.

[1]  Viktor Hacker,et al.  Thermal-runaway experiments on consumer Li-ion batteries with metal-oxide and olivin-type cathodes , 2014 .

[2]  Xuan Liu,et al.  Comprehensive calorimetry of the thermally-induced failure of a lithium ion battery , 2015 .

[3]  J. Dahn,et al.  Accelerating Rate Calorimetry Study on the Thermal Stability of Lithium Intercalated Graphite in Electrolyte. II. Modeling the Results and Predicting Differential Scanning Calorimeter Curves , 1999 .

[4]  Eric Darcy,et al.  18650 Cell Bottom Vent: Preliminary Evaluation into its Merits for Preventing Side Wall Rupture , 2016 .

[5]  T. Fuller,et al.  A Critical Review of Thermal Issues in Lithium-Ion Batteries , 2011 .

[6]  M. Armand,et al.  Building better batteries , 2008, Nature.

[7]  Diego Lisbona,et al.  A review of hazards associated with primary lithium and lithium-ion batteries , 2011 .

[8]  Eric Darcy,et al.  Characterising thermal runaway within lithium-ion cells by inducing and monitoring internal short circuits. , 2017 .

[9]  Daniel H. Doughty,et al.  A General Discussion of Li Ion Battery Safety , 2012 .

[10]  E. Darcy.  Challenges With Achieving >180Wh/kg Li-ion Battery Modules that Don't Propagate Thermal Runaway or Emit Flames/Sparks , 2015 .

[11]  Chuck Haynes.  NASA Alternative Orion Small Cell Battery Design Support , 2016 .

[12]  Eric Darcy,et al.  On-Demand Internal Short Circuit Device Reveals Li-Ion Cell Design Vulnerabilities and Enables Verification of Safer, Higher Performing Battery Designs , 2016 .

[13]  Ahmad Pesaran,et al.  NREL/NASA Internal Short-Circuit Instigator in Lithium Ion Cells , 2013 .

[14]  G. Blomgren.  The development and future of lithium ion batteries , 2017 .

[15]  E. Darcy.  Thermal Runaway Severity Reduction Assessment For EVA Li-Ion Batteries , 2014 .

[16]  Jiyun Zhao,et al.  Thermal issues about Li-ion batteries and recent progress in battery thermal management systems: A review , 2017 .

[17]  Eric Darcy,et al.  Identifying the Cause of Rupture of Li‐Ion Batteries during Thermal Runaway , 2017, Advanced science.

[18]  James B. Robinson,et al.  In-operando high-speed tomography of lithium-ion batteries during thermal runaway , 2015, Nature Communications.

[19]  Ganesan Nagasubramanian,et al.  Effects of additives on thermal stability of Li ion cells , 2005 .

[20]  Zhibo Wu,et al.  Heat release during thermally-induced failure of a lithium ion battery: Impact of cathode composition , 2016 .

[21]  Considerations for the Thermal Modeling of Lithium-Ion Cells for Battery Analysis , 2016 .

[22]  Richard E Lyon,et al.  Energetics of lithium ion battery failure. , 2016, Journal of hazardous materials.

[23]  Judith A. Jeevarajan,et al.  Crewed Space Vehicle Battery Safety Requirements , 2014 .

[24]  E. Roth,et al.  Thermal abuse performance of high-power 18650 Li-ion cells , 2004 .

[25]  D. Doughty,et al.  New Understanding of Energy Distributions Exhibited during Thermal Runaway of Commercial Lithium Ion Batteries used for Human Spaceflight Applications , 2016 .

[26]  J. Dahn,et al.  Accelerating Rate Calorimetry Study on the Thermal Stability of Lithium Intercalated Graphite in Electrolyte. I. Experimental , 1999 .

[27]  Qingsong Wang,et al.  Thermal runaway caused fire and explosion of lithium ion battery , 2012 .

[28]  D. Aurbach,et al.  The use of accelerating rate calorimetry (ARC) for the study of the thermal reactions of Li-ion battery electrolyte solutions , 2003 .

[29]  E. P. Roth,et al.  Thermal characterization of Li-ion cells using calorimetric techniques , 2000, Collection of Technical Papers. 35th Intersociety Energy Conversion Engineering Conference and Exhibit (IECEC) (Cat. No.00CH37022).