Microfabricated electrostatic actuators for hard disk drives

A dual-stage servo system which utilizes a high-bandwidth secondary actuator has been proposed for magnetic hard disk drives. Microfabricated actuators are promising candidates for this secondary actuator, since they offer the benefits of extremely small size and weight and may be batch fabricated for reduced production cost. This paper presents the design of an electrostatic microactuator which produces sufficient output force to move a 1.6-mg picoslider from a conventional disk drive at frequencies above 2 kHz. A linear second-order actuation model is developed and fit to experimental data. The prototype device is shown to have an open-loop resonance frequency of 532 Hz when loaded with the picoslider, and a DC-voltage-to-position gain of 0.12 /spl mu/m/V. A closed-loop bandwidth of 2.5 kHz is achieved using a simple PD controller.

[1]  K.E. Petersen,et al.  Silicon as a mechanical material , 1982, Proceedings of the IEEE.

[2]  R. Howe.  Surface micromachining for microsensors and microactuators , 1988 .

[3]  Long-Sheng Fan,et al.  Magnetic recording-head positioning at very high track densities using a microactuator-based, two-stage servo system , 1995, IEEE Trans. Ind. Electron..

[4]  Yu-Chong Tai,et al.  Silicon micromachined electromagnetic microactuators for rigid disk drives , 1995 .

[5]  V. Speriosu,et al.  Spin-valve RAM cell , 1995 .

[6]  T. Imamura,et al.  Transverse mode electrostatic microactuator for MEMS-based HDD slider , 1996, Proceedings of Ninth International Workshop on Micro Electromechanical Systems.

[7]  C. Mee,et al.  Magnetic Storage Handbook , 1996 .

[8]  P. Favrat,et al.  A 1.5 V supplied, CMOS ASIC for the actuation of an electrostatic micromotor , 1996, Proceedings of Ninth International Workshop on Micro Electromechanical Systems.

[9]  J. Bustillo,et al.  Embedded interconnect and electrical isolation for high-aspect-ratio, SOI inertial instruments , 1997, Proceedings of International Solid State Sensors and Actuators Conference (Transducers '97).

[10]  H. Ashraf,et al.  DRY SILICON ETCHING FOR MEMS , 1997 .

[11]  R. L. Edwards,et al.  Measurements of Young's modulus, Poisson's ratio, and tensile strength of polysilicon , 1997, Proceedings IEEE The Tenth Annual International Workshop on Micro Electro Mechanical Systems. An Investigation of Micro Structures, Sensors, Actuators, Machines and Robots.

[12]  R. Horowitz,et al.  Angular micropositioner for disk drives , 1997, Proceedings IEEE The Tenth Annual International Workshop on Micro Electro Mechanical Systems. An Investigation of Micro Structures, Sensors, Actuators, Machines and Robots.

[13]  Masayoshi Tomizuka,et al.  Pivot Friction Compensation Using an Accelerometer and a Disturbance Observer for Hard Disk Drives , 1997, 8th International Symposium on Information Storage and Processing Systems.