Influence of crank length and crank width on maximal hand cycling power and cadence

The effect of different crank lengths and crank widths on maximal hand cycling power, cadence and handle speed were determined. Crank lengths and crank widths were adapted to anthropometric data of the participants as the ratio to forward reach (FR) and shoulder breadth (SB), respectively. 25 able-bodied subjects performed maximal inertial load hand cycle ergometry using crank lengths of 19, 22.5 and 26% of FR and 72, 85 and 98% of SB. Maximum power ranged from 754 (246) W for the crank geometry short wide (crank length × crank width) to 873 (293) W for the combination long middle. Every crank length differed significantly (P < 0.05) from each other, whereas no significant effect of crank width to maximum power output was revealed. Optimal cadence decreased significantly (P < 0.001) with increasing crank length from 124.8 (0.9) rpm for the short to 107.5 (1.6) rpm for the long cranks, whereas optimal handle speed increased significantly (P < 0.001) with increasing crank length from 1.81 (0.01) m/s for the short to 2.13 (0.03) m/s for the long cranks. Crank width did neither influence optimal cadence nor optimal handle speed significantly. From the results of this study, for maximum hand cycling power, a crank length to FR ratio of 26% for a crank width to SB ratio of 85% is recommended.

[1]  F. Anderson,et al.  A governing relationship for repetitive muscular contraction. , 2000, Journal of biomechanics.

[2]  Danny Too,et al.  The effect of pedal crank arm length on joint angle and power production in upright cycle ergometry , 2000, Journal of sports sciences.

[3]  Victoria L. Goosey-Tolfrey,et al.  The influence of crank length and cadence on mechanical efficiency in hand cycling , 2007, European Journal of Applied Physiology.

[4]  C. A. Dairaghi,et al.  Crank inertial load has little effect on steady-state pedaling coordination. , 1996, Journal of biomechanics.

[5]  W. Herzog,et al.  Moment-length relations of rectus femoris muscles of speed skaters/cyclists and runners. , 1991, Medicine and science in sports and exercise.

[6]  Erik W Faria,et al.  The Science of Cycling , 2005, Sports medicine.

[7]  J. Patton,et al.  Maximal Power Outputs During the Wingate Anaerobic Test , 1985, International journal of sports medicine.

[8]  Daniel Theisen,et al.  Influence of crank rate in hand cycling. , 2004, Medicine and science in sports and exercise.

[9]  A. Lucia,et al.  Preferred pedalling cadence in professional cycling. , 2001, Medicine and science in sports and exercise.

[10]  L. Mcnaughton,et al.  Peak power output, the lactate threshold, and time trial performance in cyclists. , 2001, Medicine and science in sports and exercise.

[11]  A J Dallmeijer,et al.  Submaximal physical strain and peak performance in handcycling versus handrim wheelchair propulsion , 2004, Spinal Cord.

[12]  Z Dvir,et al.  The effect of bicycle crank-length variation upon power performance. , 1983, Ergonomics.

[13]  P. D. di Prampero Cycling on Earth, in space, on the Moon , 2000, European journal of applied physiology.

[14]  Jacob Cohen Statistical Power Analysis for the Behavioral Sciences , 1969, The SAGE Encyclopedia of Research Design.

[15]  K M Baldwin,et al.  Determinants of work produced by skeletal muscle: potential limitations of activation and relaxation. , 1997, The American journal of physiology.

[16]  D. Bentley,et al.  Correlations between peak power output, muscular strength and cycle time trial performance in triathletes. , 1998, The Journal of sports medicine and physical fitness.

[17]  W. Herzog,et al.  Optimal design parameters of the bicycle-rider system for maximal muscle power output. , 1990, Journal of biomechanics.

[18]  T. Noakes,et al.  Peak power output predicts maximal oxygen uptake and performance time in trained cyclists , 2005, European Journal of Applied Physiology and Occupational Physiology.

[19]  A J Dallmeijer,et al.  Alternative Modes of Manual Wheelchair Ambulation: An Overview , 2001, American journal of physical medicine & rehabilitation.

[20]  G. Marsh,et al.  Anaerobic Power of the Arms and Legs of Young and Older Men , 1999, Experimental physiology.

[21]  J. Martin,et al.  Determinants of maximal cycling power: crank length, pedaling rate and pedal speed , 2001, European Journal of Applied Physiology.

[22]  L. Dupont,et al.  Spontaneously chosen crank rate variations in submaximal arm exercise with inexperienced subjects. Effects on cardiorespiratory and efficiency parameters. , 2002, International journal of sports medicine.

[23]  W Herzog,et al.  Maximal muscle power output in cycling: a modelling approach. , 1996, Journal of sports sciences.

[24]  Philippe Gorce,et al.  The effects of crank adjustments on handbike propulsion: A kinematic model approach , 2008 .

[25]  G Mukherjee,et al.  Physiological response to the ambulatory performance of hand-rim and arm-crank propulsion systems. , 2001, Journal of rehabilitation research and development.

[26]  O. Bar-or,et al.  Load optimization for the wingate anaerobic test , 2004, European Journal of Applied Physiology and Occupational Physiology.

[27]  F Hintzy,et al.  Muscular efficiency during arm cranking and wheelchair exercise: a comparison. , 2002, International journal of sports medicine.

[28]  J. McDaniel,et al.  Determinants of metabolic cost during submaximal cycling. , 2002, Journal of applied physiology.

[29]  W. Bertucci,et al.  Muscular activity level during pedalling is not affected by crank inertial load , 2005, European Journal of Applied Physiology.

[30]  P. Gorce,et al.  Effects of backrest positioning and gear ratio on nondisabled subjects' handcycling sprinting performance and kinematics. , 2008, Journal of rehabilitation research and development.

[31]  Urs Boutellier,et al.  The generalized force–velocity relationship explains why the preferred pedaling rate of cyclists exceeds the most efficient one , 2005, European Journal of Applied Physiology.

[32]  E. Coyle,et al.  Inertial-load method determines maximal cycling power in a single exercise bout. , 1997, Medicine and science in sports and exercise.

[33]  R. Candau,et al.  Level ground and uphill cycling efficiency in seated and standing positions. , 2002, Medicine and science in sports and exercise.

[34]  Ricardo Mora-Rodríguez,et al.  Validity of cycling peak power as measured by a short-sprint test versus the Wingate anaerobic test. , 2006, Applied physiology, nutrition, and metabolism = Physiologie appliquee, nutrition et metabolisme.