Three-dimensional modelling of knots and pith location in Norway spruce boards using tracheid-effect scanning

Knots and the orientation of fibres in timber are decisive for the stiffness and strength of boards. Due to large property variations between members, strength grading is necessary. High resolution information of the orientation of fibres, both on surfaces and within members, would enable development of more accurate grading methods than those available today. A step towards three-dimensional (3D) models of the fibre orientation of the entire board volume is the establishment of 3D knot models based on scanning. The light from a dot laser illuminating the surface of a softwood board will, due to the tracheid effect, spread more along the fibres than across resulting in the dot entering an elliptical shape. In this investigation both the shape of the ellipse and the direction of its major axis were used to estimate the 3D fibre orientation on board surfaces. Knot surfaces were identified where the angle between the estimated 3D fibre direction and an approximated direction of the board’s pith exceeded a threshold value. By means of algorithms based on polar coordinates, knot surfaces which belonged to the same physical knot visible on different sides of the board were identified and as a result the position, orientation and volume of each knot were determined. Based on this information, a more accurate position of the board’s pith along the board was calculated. The established models showed good agreement with physical boards. The models constitute a promising starting point for further development of strength grading methods based on tracheid-effect scanning.

[1]  Raimo Silvennoinen,et al.  Determination of wood grain direction from laser light scattering pattern , 2004 .

[2]  Anders Olsson,et al.  Three dimensional fibre orientation models for wood based on laser scanning utilizing the tracheid effect , 2014 .

[3]  Manuel Guaita,et al.  A three-dimensional wood material model to simulate the behavior of wood with any type of knot at the macro-scale , 2012, Wood Science and Technology.

[4]  C. Foley,et al.  A three-dimensional paradigm of fiber orientation in timber , 2001, Wood Science and Technology.

[5]  Hans Petersson,et al.  Use of optical and laser scanning techniques as tools for obtaining improved FE-input data for strength and shape stability analysis of wood and timber. , 2010 .

[6]  M. Kaliske,et al.  Description of inhomogeneities in wooden structures: modelling of branches , 2013, Wood Science and Technology.

[7]  Christina Foley,et al.  Modeling the effects of knots in Structural Timber , 2003 .

[8]  A. Shigo A New Tree Biology: Facts, Photos, and Philosophies on Trees and Their Problems and Proper Care , 1989 .

[9]  A. Olsson,et al.  Localized modulus of elasticity in timber and its significance for the accuracy of machine strength grading , 2014 .

[10]  Josef Eberhardsteiner,et al.  Discussion of common and new indicating properties for the strength grading of wooden boards , 2015, Wood Science and Technology.

[11]  Alfred J. Stamm,et al.  Principles of Wood Science and Technology , 2013, Springer Berlin Heidelberg.

[12]  Anders Olsson,et al.  Prediction of timber bending strength and in-member cross-sectional stiffness variation on the basis of local wood fibre orientation , 2013, European Journal of Wood and Wood Products.

[13]  Koji Murata,et al.  Strain analysis of lumber containing a knot during tensile failure , 2011, Journal of Wood Science.

[14]  Sigurdur Ormarsson,et al.  Numerical Analysis of Moisture-Related Distortion in Sawn Timber , 1999 .