Evaluation of SAR in a human body model due to wireless power transmission in the 10 MHz band

This study discusses a computational method for calculating the specific absorption rate (SAR) due to a wireless power transmission system in the 10 MHz frequency band. A two-step quasi-static method comprised of the method of moments and the scalar potential finite-difference method are proposed. The applicability of the quasi-static approximation for localized exposure in this frequency band is discussed by comparing the SAR in a lossy dielectric cylinder computed with a full-wave electromagnetic analysis and the quasi-static approximation. From the computational results, the input impedance of the resonant coils was affected by the existence of the cylinder. On the other hand, the magnetic field distribution in free space and considering the cylinder and an impedance matching circuit were in good agreement; the maximum difference in the amplitude of the magnetic field was 4.8%. For a cylinder-coil distance of 10 mm, the difference between the peak 10 g averaged SAR in the cylinder computed with the full-wave electromagnetic method and our quasi-static method was 7.8%. These results suggest that the quasi-static approach is applicable for conducting the dosimetry of wireless power transmission in the 10 MHz band. With our two-step quasi-static method, the SAR in the anatomically based model was computed for different exposure scenarios. From those computations, the allowable input power satisfying the limit of a peak 10 g averaged SAR of 2.0 W kg(-1) was 830 W in the worst case exposure scenario with a coil positioned at a distance of 30 mm from the chest.

[1]  Osamu Hashimoto,et al.  Numerical study on an equivalent source model for inhomogeneous magnetic field dosimetry in the low-frequency range , 2004, IEEE Transactions on Biomedical Engineering.

[2]  A. Faraone,et al.  Comparisons of computed mobile phone induced SAR in the SAM phantom to that in anatomically correct models of the human head , 2006, IEEE Transactions on Electromagnetic Compatibility.

[3]  N. Shinohara,et al.  Power without wires , 2011, IEEE Microwave Magazine.

[4]  A. Hirata,et al.  Intercomparison of whole-body averaged SAR in European and Japanese voxel phantoms , 2008, Physics in medicine and biology.

[5]  R. W. Lau,et al.  The dielectric properties of biological tissues: III. Parametric models for the dielectric spectrum of tissues. , 1996, Physics in medicine and biology.

[6]  A. Hirata,et al.  Dipole Antenna Above EBG Substrate for Local SAR Reduction , 2011, IEEE Antennas and Wireless Propagation Letters.

[7]  Dagang Wu,et al.  Possible overexposure of pregnant women to emissions from a walk through metal detector , 2007, Physics in medicine and biology.

[8]  M. Soljačić,et al.  Wireless Power Transfer via Strongly Coupled Magnetic Resonances , 2007, Science.

[9]  Sami Ilvonen,et al.  Comparison of SAR calculation algorithms for the finite-difference time-domain method. , 2010, Physics in medicine and biology.

[10]  Nobuyoshi Kikuma,et al.  A consideration of electro-magnetic-resonant coupling mode in wireless power transmission , 2009, IEICE Electron. Express.

[11]  T. Nagaoka,et al.  Development of realistic high-resolution whole-body voxel models of Japanese adult males and females of average height and weight, and application of models to radio-frequency electromagnetic-field dosimetry. , 2004, Physics in medicine and biology.

[12]  A. Ahlbom Guidelines for limiting exposure to time-varying electric, magnetic, and electromagnetic fields (up to 300 GHz) , 1998 .

[13]  J. Herbertz Comment on the ICNIRP guidelines for limiting exposure to time-varying electric, magnetic, and electromagnetic fields (up to 300 GHz) , 1998, Health physics.

[14]  O. Gandhi,et al.  A 3-D impedance method to calculate power deposition in biological bodies subjected to time varying magnetic fields , 1988, IEEE Transactions on Biomedical Engineering.

[15]  Jianming Jin The Finite Element Method , 2010 .

[16]  P. Dimbylow,et al.  Induced current densities from low-frequency magnetic fields in a 2 mm resolution, anatomically realistic model of the body. , 1998, Physics in medicine and biology.

[17]  Paul A Bottomley,et al.  Designing passive MRI-safe implantable conducting leads with electrodes. , 2010, Medical physics.