An AlN MEMS Piezoelectric Microphone for Aeroacoustic Applications

This paper describes the development of a micro- machined microphone for aircraft fuselage arrays that are utilized by aeroacousticians to help identify aircraft noise sources and/or assess the effectiveness of noise-reduction technologies. The developed microphone utilizes piezoelectric transduction via an integrated aluminum nitride layer in a thin-film composite diaphragm. A theoretical lumped element model and an associated noise model of the complete microphone system are developed and utilized in a formal design-optimization process. Optimal designs were fabricated using a variant of the film bulk acoustic resonator process at Avago Technologies. The experimental characterization of one design is presented here, and measured performance was in line with sponsor specifications, including a sensitivity of -39 μV/Pa, a minimum detectable pressure of 40.4 dB, a confirmed bandwidth up to 20 kHz, a 129.5-kHz resonant frequency, and a 3% distortion limit approaching 172 dB. With this performance-in addition to its small size-this microphone is shown to be a viable enabling technology for low-cost, high-resolution fuselage array measurements.

[1]  N. Maculan,et al.  Global optimization : from theory to implementation , 2006 .

[2]  Richard S. Muller,et al.  Improved IC-compatible piezoelectric microphone and CMOS process , 1991, TRANSDUCERS '91: 1991 International Conference on Solid-State Sensors and Actuators. Digest of Technical Papers.

[3]  Aaas News,et al.  Book Reviews , 1893, Buffalo Medical and Surgical Journal.

[4]  M. Royer,et al.  ZnO on Si integrated acoustic sensor , 1983 .

[5]  James R. Underbrink,et al.  Characterization of a Microelectromechanical Systems (MEMS) Microphone , 2008 .

[6]  Khalil Najafi,et al.  A silicon micromachined microphone for fluid mechanics research , 2002 .

[7]  D. Blackstock Fundamentals of Physical Acoustics , 2000 .

[8]  M. Sheplak,et al.  Development of a micromachined piezoelectric microphone for aeroacoustics applications. , 2007, The Journal of the Acoustical Society of America.

[9]  Richard M. White,et al.  Piezoelectric cantilever acoustic transducer , 1998 .

[10]  J. A. Connelly,et al.  Low noise electronic system design , 1993 .

[11]  Sang Choon Ko,et al.  Micromachined piezoelectric membrane acoustic device , 2003 .

[12]  T. B. Gabrielson,et al.  Fundamental noise limits for miniature acoustic and vibration sensors , 1991 .

[13]  Tian-Ling Ren,et al.  Fabrication of high-quality PZT-based piezoelectric microphone , 2003, TRANSDUCERS '03. 12th International Conference on Solid-State Sensors, Actuators and Microsystems. Digest of Technical Papers (Cat. No.03TH8664).

[14]  R. Haftka,et al.  Elements of Structural Optimization , 1984 .

[15]  J. N. Reddy,et al.  Theory and analysis of elastic plates , 1999 .

[16]  R. Muller,et al.  Integrated microphone with CMOS circuits on a single chip , 1989, International Technical Digest on Electron Devices Meeting.

[17]  R. Schellin,et al.  A silicon subminiature microphone based on piezoresistive polysilicon strain gauges , 1992 .

[18]  S. Trolier-McKinstry,et al.  Thin Film Piezoelectrics for MEMS , 2004 .

[19]  S. Senturia Microsystem Design , 2000 .

[20]  Bin Liu,et al.  A new measurement microphone based on MEMS technology , 2003 .

[21]  S. Franssila Introduction to microfabrication , 2004 .

[22]  M. Rossi,et al.  Acoustics and Electroacoustics , 1992 .

[23]  J. N. Reddy,et al.  On laminated composite plates with integrated sensors and actuators , 1999 .

[24]  Ronald G. Polcawich A Piezoelectric MEMS Microphone Based on Lead Zirconate Titanate (PZT) Thin Films , 2004 .

[25]  R.M. Fox,et al.  A Micromachined Dual-Backplate Capacitive Microphone for Aeroacoustic Measurements , 2007, Journal of Microelectromechanical Systems.

[26]  R. Muller,et al.  IC-Processed piezoelectric microphone , 1987, IEEE Electron Device Letters.

[27]  Tina L. Lamers,et al.  Analysis of Micromachined Piezoelectric Transducers Operating in a Flexural Mode , 2007 .

[28]  A. Goel,et al.  Design and Performance of Aluminum Nitride Piezoelectric Microphones , 2007, TRANSDUCERS 2007 - 2007 International Solid-State Sensors, Actuators and Microsystems Conference.

[29]  Richard M. White,et al.  Piezoelectric cantilever microphone and microspeaker , 1996 .

[30]  Louis N. Cattafesta,et al.  Analysis of a Composite Piezoelectric Circular Plate With Initial Stresses for MEMS , 2002 .

[31]  Tina L. Lamers,et al.  Accelerating Development of a MEMS Piezoelectric Microphone , 2007 .

[32]  M. Sheplak,et al.  Surface and bulk micromachined dual back-plate condenser microphone , 2005, 18th IEEE International Conference on Micro Electro Mechanical Systems, 2005. MEMS 2005..

[33]  K. Breuer,et al.  A MEMS microphone for aeroacoustics measurements , 1999 .

[34]  P. W. Barth,et al.  A theoretical study of transducer noise in piezoresistive and capacitive silicon pressure sensors , 1988 .

[35]  Stefan Uellenberg,et al.  The Quiet Technology Demonstrator Program: Flight Validation of Airplane Noise-Reduction Concepts , 2006 .

[36]  John D. Larson,et al.  Thin film bulk wave acoustic resonators (FBAR) for wireless applications , 2001, 2001 IEEE Ultrasonics Symposium. Proceedings. An International Symposium (Cat. No.01CH37263).

[37]  Josef Merhaut,et al.  Theory of electroacoustics , 1981 .

[38]  Richard S. Muller,et al.  Piezoelectric microphone with on-chip CMOS circuits , 1993 .

[39]  W. Marsden I and J , 2012 .

[40]  G. Hess,et al.  Micromachined silicon subminiature microphones with piezoelectric P(VDF/TRFE)-layers and silicon-nitride-membranes , 1994, Proceedings of 8th International Symposium on Electrets (ISE 8).

[41]  Mark Sheplak,et al.  Sources of excess noise in silicon piezoresistive microphones , 2004 .

[42]  Meng-Nian Niu,et al.  Piezoelectric bimorph microphone built on micromachined parylene diaphragm , 2003 .

[43]  Raphael T. Haftka,et al.  Piezoresistive Microphone Design Pareto Optimization: Tradeoff Between Sensitivity and Noise Floor , 2006 .

[44]  Robert John Littrell,et al.  High Performance Piezoelectric MEMS Microphones. , 2010 .

[45]  T. Gabrielson Mechanical-thermal noise in micromachined acoustic and vibration sensors , 1993 .

[46]  M. Sheplak,et al.  Piezoresistive Microphone Design Pareto Optimization: Tradeoff Between Sensitivity and Noise Floor , 2003, Journal of Microelectromechanical Systems.

[47]  Louis N. Cattafesta,et al.  Analytical Electroacoustic Model of a Piezoelectric Composite Circular Plate , 2006 .