An Approach to Voltage Quality Enhancement by Introduction of CWVM for Distribution System

This paper presented with problems related with voltage flicker in power system networks. Several international standard issued to control the voltage flicker are briefly described and some important methods to analyse electrical circuits with sinusoidal and non-sinusoidal waveforms are introduced and evaluated. One of these methods – Cockcroft Walton Voltage Multiplier (CWVM) has been used to increase the voltage of a filter, which is also described in this paper as a practical application. The filter can compensate for harmonic currents, power factor, and unbalance voltage. The simulation results using Multisim are presented, showing that good dynamic and steady-state response can be achieved with this approach . Full Text: PDF DOI: http://dx.doi.org/10.11591/ijpeds.v7.i4.pp1276-1282

[1]  Rajesh Damaraju,et al.  A Fuzzy Controller for Compensation of Voltage Sag/ Swell Problems using Reduced Rating Dynamic Voltage Restorer , 2015 .

[2]  Mathias Noe,et al.  High-temperature superconductor fault current limiters: concepts, applications, and development status , 2007 .

[3]  Zhong-Ping Jiang,et al.  Analysis of Voltage Profile Problems Due to the Penetration of Distributed Generation in Low-Voltage Secondary Distribution Networks , 2012, IEEE Transactions on Power Delivery.

[4]  Zainul Abdin Jaffery,et al.  Quality Assessment of a Single-phase resonant inverter , 2012 .

[5]  Mladen Kezunovic,et al.  Sensitivity Analysis of Voltage Sag Based Fault Location With Distributed Generation , 2015, IEEE Transactions on Smart Grid.

[6]  Shigeyuki Sugimoto,et al.  Principle and characteristics of a fault current limiter with series compensation , 1996 .

[7]  N.D. Hatziargyriou,et al.  Analytical calculation and stochastic assessment of voltage sags , 2006, IEEE Transactions on Power Delivery.

[8]  Yasuyuki Shirai,et al.  Experimental study on limiting operation of superconducting fault current limiter in double circuit transmission line model system , 2002 .

[9]  Dong Keun Park,et al.  Study on a Series Resistive SFCL to Improve Power System Transient Stability: Modeling, Simulation, and Experimental Verification , 2009, IEEE Transactions on Industrial Electronics.

[10]  Gilsoo Jang,et al.  Assessment of system voltage sag performance based on the concept of area of severity , 2010 .

[11]  K. Yokoyama,et al.  Single DC reactor type fault current limiter for 6.6 kV power system , 2001 .

[12]  Sowmya,et al.  Superconducting Fault Current Limiters for Micro Grid Application , 2014 .

[13]  Liangzhen Lin,et al.  Application studies of superconducting fault current limiters in electric power systems , 2002 .

[14]  Prashant Kumar.  Application of Distribution Power Electronic Transformer for Medium Voltage , 2014 .