Thermal behavior and energy saving analysis of a flat with different energy efficiency measures in six climates

This article aims at studying the impact of many construction parameters of a flat on its energy performance and thermal comfort. The studied parameters are: the envelope thermal insulation, the orientation, the floor level, the ground coupling, the roof and the external walls absorption coefficient and the controlled mechanical ventilation. The TRNSYS based numerical study is performed in six different climates ranging from cold to desert one. The numerical model has been validated against experimental results obtained from summer and winter long term monitoring campaigns of the flat located in the Marrakech city, Morocco. The apartment’s heating and cooling loads as well as thermal discomfort indexes are calculated for the possible eleven configurations combining the studied parameters. The results show that high thermal insulation of the walls leads to an apparent summer overheating with an increase in the flat’s total thermal load by up to 18% in all the considered climates, except for the cold one. It was found that the walls’ light thermal insulation resulting from the cavity wall technique is sufficient to reach an acceptable level of thermal comfort thus preventing summer overheating. Similarly, thermal insulation of the slab-on-grade floor was found to perform an increase in thermal load for hot and moderate climates by at least 67%. The best combination of all the studied energy efficiency measures for each climate conditions was evaluated via comparison to a reference case that represents the actual apartment.

[1]  Brahim Benhamou,et al.  Effect of thermal insulation and ground coupling on thermal load of a modern house in Marrakech , 2014, 2014 International Renewable and Sustainable Energy Conference (IRSEC).

[2]  Farraj F. Al-ajmi,et al.  Simulation of energy consumption for Kuwaiti domestic buildings , 2008 .

[3]  Lars Broman,et al.  TRNSYS The most complete solar energy system modeling and simulation software , 1994 .

[4]  Daisuke Sumiyoshi,et al.  Optimization of passive design measures for residential buildings in different Chinese areas , 2012 .

[5]  Baizhan Li,et al.  The effect of building envelope insulation on cooling energy consumption in summer , 2014 .

[6]  Brahim Benhamou,et al.  Energy Performances of a Passive Building in Marrakech: Parametric Study☆ , 2013 .

[7]  Dionysios I. Kolaitis,et al.  Comparative assessment of internal and external thermal insulation systems for energy efficient retrofitting of residential buildings , 2013 .

[8]  T. Kusuda,et al.  EARTH TEMPERATURE AND THERMAL DIFFUSIVITY AT SELECTED STATIONS IN THE UNITED STATES , 1965 .

[9]  Samar Jaber,et al.  Optimum, technical and energy efficiency design of residential building in Mediterranean region , 2011 .

[10]  Adel Mourtada,et al.  DYNAMIC BUILDING SIMULATIONS FOR THE ESTABLISHMENT OF A MOROCCAN THERMAL REGULATION FOR BUILDINGS , 2014 .

[11]  Marwa Dabaieh,et al.  Reducing cooling demands in a hot dry climate: A simulation study for non-insulated passive cool roof thermal performance in residential buildings , 2015 .

[12]  Omer Kaynakli,et al.  A review of the economical and optimum thermal insulation thickness for building applications , 2012 .

[13]  Hicham Mastouri,et al.  Thermal performance assessment of passive techniques integrated into a residential building in semi-arid climate , 2017 .

[14]  Hicham Mastouri,et al.  Pebbles Bed Thermal Storage for Heating and Cooling of Buildings , 2013 .

[15]  Baruch Givoni,et al.  Man climate and architecture , 1969 .

[16]  Yalçın Yaşar,et al.  The effects of window alternatives on energy efficiency and building economy in high-rise residential buildings in moderate to humid climates , 2012 .

[17]  van Taj Twan Hooff,et al.  On the predicted effectiveness of climate adaptation measures for residential buildings , 2014 .

[18]  E. Peterson,et al.  Effect of Roof Solar Reflectance on the Building Heat Gain in a Hot Climate , 2008 .

[19]  Ali Bolatturk,et al.  Optimum insulation thicknesses for building walls with respect to cooling and heating degree-hours in the warmest zone of Turkey , 2008 .

[20]  H. Hamdi,et al.  Thermomechanical characterization of a bio-composite building material: Mortar reinforced with date palm fibers mesh , 2017 .

[21]  Brahim Benhamou,et al.  ANALYSIS FOR THERMAL BEHAVIOR AND ENERGY SAVINGS OF A SEMI-DETACHED HOUSE WITH DIFFERENT INSULATION STRATEGIES IN A HOT SEMI-ARID CLIMATE , 2017 .

[22]  Cinzia Buratti,et al.  Unsteady simulation of energy performance and thermal comfort in non-residential buildings , 2013 .

[23]  Ashok Kumar,et al.  Experimental evaluation of insulation materials for walls and roofs and their impact on indoor thermal comfort under composite climate , 2013 .

[24]  A. N. Fried,et al.  Thermal properties of a variable cavity wall , 2001 .

[25]  Brahim Benhamou,et al.  Experimental and numerical study of an earth-to-air heat exchanger for air cooling in a residential building in hot semi-arid climate , 2016 .

[26]  Robert F. Boehm,et al.  Passive building energy savings: A review of building envelope components , 2011 .

[27]  B. Givoni.  Indoor temperature reduction by passive cooling systems , 2011 .

[28]  Eduardo L. Krüger,et al.  Effectiveness of indirect evaporative cooling and thermal mass in a hot arid climate , 2010 .

[29]  Bijan Farhanieh,et al.  Simulation of energy saving in Iranian buildings using integrative modelling for insulation , 2006 .

[30]  Khaled A. Al-Sallal.  Sizing windows to achieve passive cooling, passive heating, and daylighting in hot arid regions , 1998 .

[31]  Abdulsalam Ebrahimpour,et al.  Application of advanced glazing and overhangs in residential buildings , 2011 .

[32]  Meral Ozel,et al.  Determination of optimum insulation thickness based on cooling transmission load for building walls in a hot climate , 2013 .

[33]  Francesca Stazi,et al.  Super-insulated wooden envelopes in Mediterranean climate: Summer overheating, thermal comfort optimization, environmental impact on an Italian case study , 2017 .

[34]  Francesca Stazi,et al.  Experimental comparison between 3 different traditional wall constructions and dynamic simulations to identify optimal thermal insulation strategies , 2013 .

[35]  P. O. Fanger,et al.  Thermal comfort: analysis and applications in environmental engineering, , 1972 .

[36]  Muhammad Asim,et al.  TRNSYS Simulation of a Solar Cooling System for the Hot Climate of Pakistan , 2016 .

[37]  Anthony J. Robinson,et al.  Transient and quasi-steady thermal behaviour of a building envelope due to retrofitted cavity wall and ceiling insulation , 2013 .

[38]  Ke Li,et al.  Dynamic modeling of potentially conflicting energy reduction strategies for residential structures in semi-arid climates. , 2012, Journal of environmental management.