Development of micro-scale axial and radial turbines for low-temperature heat source driven organic Rankine cycle

Abstract Most studies on the organic Rankine cycle (ORC) focused on parametric studies and selection working fluids to maximize the performance of organic Rankine cycle but without attention for turbine design features which are crucial to achieving them. The rotational speed, expansion ratio, mass flow rate and turbine size have markedly effect on turbine performance. For this purpose organic Rankine cycle modeling, mean-line design and three-dimensional computational fluid dynamics analysis were integrated for both micro axial and radial-inflow turbines with five organic fluids (R141b, R1234yf, R245fa, n -butane and n -pentane) for realistic low-temperature heat source R17 -CFX where three-dimensional Reynolds-averaged Navier-Stokes equations are solved with k-omega shear stress transport turbulence model. Both configurations of turbines are designed at wide range of mass flow rate (0.1–0.5) kg/s for each working fluid. The results showed that n -pentane has the highest performance at all design conditions where the maximum total-to-total efficiency and power output of radial-inflow turbine are 83.85% and 8.893 kW respectively. The performance of the axial turbine was 83.48% total-to-total efficiency and 8.507 kW power output. The maximum overall size of axial turbine was 64.685 mm compared with 70.97 mm for radial-inflow turbine. R245fa has the lowest overall size for all cases. The organic Rankine cycle thermal efficiency was about 10.60% with radial-inflow turbine and 10.14% with axial turbine. Such results are better than other studies in the literature and highlight the potential of the integrated approach for accurate prediction of the organic Rankine cycle performance based on micro-scale axial and radial-inflow turbines.

[1]  Xiaomin Liu,et al.  Parametric optimization and range analysis of Organic Rankine Cycle for binary-cycle geothermal plant , 2014 .

[2]  David Gordon Wilson,et al.  The design of high-efficiency turbomachinery and gas turbines , 1984 .

[3]  He Weifeng,et al.  Experimental study on Organic Rankine cycle for low grade thermal energy recovery. , 2016 .

[4]  Ronald H. Aungier,et al.  Turbine Aerodynamics: Axial-Flow and Radial-Flow Turbine Design and Analysis , 2006 .

[5]  Ingo Jahn,et al.  Design and testing process fora 7kw radial inflow refrigerant turbine at the University of Queensland , 2016 .

[6]  Khalil M. Khalil,et al.  Development of Efficient Small Scale Axial Turbine for Solar Driven Organic Rankine Cycle , 2016 .

[7]  Yiping Dai,et al.  Off-design performance analysis of a solar-powered organic Rankine cycle , 2014 .

[8]  A. Whitfield,et al.  Design of radial turbomachines , 1990 .

[9]  Chun-wei Gu,et al.  Parametric design and off-design analysis of organic Rankine cycle (ORC) system , 2016 .

[10]  Daniele Fiaschi,et al.  Design of micro radial turboexpanders for ORC power cycles: From 0D to 3D , 2016 .

[11]  Ingo Jahn,et al.  [Retracted publication] Design and Testing Process for a 7Kw Radial Inflow Refrigerant Turbine At the University of Queensland , 2016 .

[12]  Matteo Pini,et al.  Centrifugal Turbines for Mini-Organic Rankine Cycle Power Systems , 2014 .

[13]  Daniele Fiaschi,et al.  Design and performance prediction of radial ORC turboexpanders , 2015 .

[14]  Christos N. Markides,et al.  An assessment of solar-powered organic Rankine cycle systems for combined heating and power in UK domestic applications , 2015 .

[15]  Tao Guo,et al.  Selection of working fluids for a novel low-temperature geothermally-powered ORC based cogeneration system , 2011 .

[16]  Li Zhao,et al.  An experimental study on the recuperative low temperature solar Rankine cycle using R245fa , 2012 .

[17]  Andrea Lazzaretto,et al.  Predicting the optimum design of single stage axial expanders in ORC systems: Is there a single efficiency map for different working fluids? , 2016 .

[18]  Emilie Sauret,et al.  Three-dimensional off-design numerical analysis of an organic Rankine cycle radial-inflow turbine , 2014 .

[19]  Soo-Yong Cho,et al.  Experiment and cycle analysis on a partially admitted axial-type turbine used in the organic Rankine cycle , 2015 .

[20]  Dieter Peitsch,et al.  Validation and Development of Loss Models for Small Size Radial Turbines , 2010 .

[21]  Guo Tao,et al.  Performance comparison and parametric optimization of subcritical Organic Rankine Cycle (ORC) and transcritical power cycle system for low-temperature geothermal power generation , 2011 .

[22]  Daniele Fiaschi,et al.  An innovative ORC power plant layout for heat and power generation from medium- to low-temperature geothermal resources , 2014 .

[23]  Li Jing,et al.  Optimization of low temperature solar thermal electric generation with Organic Rankine Cycle in different areas , 2010 .

[24]  Raya Al-Dadah,et al.  Modelling and optimization of organic Rankine cycle based on a small-scale radial inflow turbine , 2015 .

[25]  Laura Schaefer,et al.  Performance evaluation of a PVT/ORC (photovoltaic thermal/organic Rankine cycle) system with optimization of the ORC and evaluation of several PV (photovoltaic) materials , 2015 .

[26]  Cheng Zhou,et al.  Hybridisation of solar and geothermal energy in both subcritical and supercritical Organic Rankine Cycles , 2014 .

[27]  Jing Li,et al.  Analysis of low temperature solar thermal electric generation using regenerative Organic Rankine Cycle , 2010 .

[28]  Leonid Moroz,et al.  Axial Turbine Flow Path Design for an Organic Rankine Cycle Using R-245fa , 2013 .

[29]  N. Baines.  Axial and Radial Turbines , 2003 .

[30]  A. J. Glassman,et al.  Computer program for design analysis of radial-inflow turbines , 1976 .

[31]  Joaquín Navarro-Esbrí,et al.  Experimental evaluation of HCFO-1233zd-E as HFC-245fa replacement in an Organic Rankine Cycle system for low temperature heat sources , 2016 .

[32]  Saili Li,et al.  Preliminary design and off-design performance analysis of an Organic Rankine Cycle for geothermal sources , 2015 .

[33]  Jie Ji,et al.  Construction and dynamic test of a small-scale organic rankine cycle , 2011 .

[34]  Mohammad Nazri Mohd. Jaafar,et al.  Thermo-economic optimization of RSORC (regenerative solar organic Rankine cycle) considering hourly analysis , 2015 .

[35]  S. L. Dixon,et al.  Fluid mechanics, thermodynamics of turbomachinery , 1966 .

[36]  Raya Al-Dadah,et al.  Parametric analysis and optimization of a small-scale radial turbine for Organic Rankine Cycle , 2015 .

[37]  Yiping Dai,et al.  Thermodynamic analysis and optimization of a solar-driven regenerative organic Rankine cycle (ORC) based on flat-plate solar collectors , 2013 .

[38]  Rene Pecnik,et al.  Performance improvement of a radial organic Rankine cycle turbine by means of automated computational fluid dynamic design , 2013 .

[39]  He Weifeng,et al.  Thermal matching performance of a geothermal ORC system using zeotropic working fluids , 2015 .

[40]  Jiang Wang,et al.  Performance evaluation of a low-temperature solar Rankine cycle system utilizing R245fa , 2010 .

[41]  Lourdes García-Rodríguez,et al.  Analysis and optimization of the low-temperature solar organic Rankine cycle (ORC) , 2010 .

[42]  Peter A. Jacobs,et al.  Preliminary Design and Performance Estimation of Radial Inflow Turbines: An Automated Approach , 2012 .