Balanced to Unbalanced: An Overview of Multifunctional Wideband Balanced-to-Unbalanced Four- and Five-Port Filtering Power Dividers

Fifth-generation (5G) communication techniques are growing in popularity, and 5G will become the commercial operation standard for mainland China in 2020 [1]. As the next-generation mobile communication network, 5G will not only greatly improve communication efficiency; it will also change the way people live and work. The 5G communication system contains the millimeter-wave and sub-6-GHz bands. For the sub-6-GHz band, circuits are becoming ever more compact and multifunction; thus, electromagnetic interference and multicoupling problems will greatly affect the entire system's performance [2]-[4]. In response, balanced circuits with higher immunity to environmental noises [5]-[8], lower electromagnetic interference [9]-[11], and better dynamic range [12]-[15] have attracted increasing attention in the past few years, and a large number of balanced circuits are being conceived [16], [17]. Currently, all feature differential-mode input and output terminals, so they cannot be connected directly to single-ended circuits. Balanced filters, antennas, and power dividers that can be cointegrated with balanced active circuits are required for the development of fully balanced transmitter and receiver RF chains, such as the balanced power dividers that can be connected to a Doherty power amplifier in a balanced system. In this case, balancing is only necessary at the input and output stages. It is expected that the transistor stage is still a single-ended structure, where only two amplifier devices are needed [18].

[1]  Eryk Dutkiewicz,et al.  An On-Chip Bandpass Filter Using a Broadside-Coupled Meander Line Resonator With a Defected-Ground Structure , 2017, IEEE Electron Device Letters.

[2]  Xin Gao,et al.  Wideband Balanced-to-Unbalanced Filtering Power Dividers Based on Coupled Lines , 2017, IEEE Transactions on Microwave Theory and Techniques.

[3]  Kaixue Ma,et al.  A 60-GHz Coplanar Waveguide-Based Bidirectional LNA in SiGe BiCMOS , 2017, IEEE Microwave and Wireless Components Letters.

[4]  Ching-Wen Tang,et al.  Design of Wide Passband/Stopband Microstrip Bandpass Filters With the Stepped Coupled Line , 2013, IEEE Transactions on Microwave Theory and Techniques.

[5]  Eryk Dutkiewicz,et al.  Compact On-Chip Bandpass Filter With Improved In-Band Flatness and Stopband Attenuation in 0.13- $\mu \text{m}$ (Bi)-CMOS Technology , 2017, IEEE Electron Device Letters.

[6]  Fadhel M. Ghannouchi,et al.  Novel Planar Compact Coupled-Line Single-Ended-to-Balanced Power Divider , 2017, IEEE Transactions on Microwave Theory and Techniques.

[7]  Feng Huang,et al.  A New Balanced-to-Unbalanced Filtering Power Divider With Dual Controllable Passbands and Enhanced In-Band Common-Mode Suppression , 2019, IEEE Transactions on Microwave Theory and Techniques.

[8]  Eryk Dutkiewicz,et al.  A Compact and Low-Loss Bandpass Filter Using Self-Coupled Folded-Line Resonator With Capacitive Feeding Technique , 2018, IEEE Electron Device Letters.

[9]  Wei Hong,et al.  Digital Beamforming-Based Massive MIMO Transceiver for 5G Millimeter-Wave Communications , 2018, IEEE Transactions on Microwave Theory and Techniques.

[10]  W. R. Eisenstadt,et al.  Microwave differential circuit design using mixed-mode S-parameters , 2006 .

[11]  Xin Gao,et al.  High Selectivity Wideband Balanced Filters With Multiple Transmission Zeros , 2017, IEEE Transactions on Circuits and Systems II: Express Briefs.

[12]  Quan Xue,et al.  The Proper Balance: Overview of Microstrip Wideband Balance Circuits with Wideband Common Mode Suppression , 2015, IEEE Microwave Magazine.

[13]  Ramesh K. Pokharel,et al.  Ultracompact CMOS 60-GHz Tapped-Line Combline BPF With Two Transmission Zeros Using Defected Ground Structures , 2018, IEEE Transactions on Components, Packaging and Manufacturing Technology.

[14]  Liguo Sun,et al.  A design of single-ended to differential-ended power divider for X band application , 2015 .

[15]  Jun-Fa Mao,et al.  Balanced-to-Balanced Gysel Power Divider With Bandpass Filtering Response , 2013, IEEE Transactions on Microwave Theory and Techniques.

[16]  Petar Popovski,et al.  The METIS 5G System Concept: Meeting the 5G Requirements , 2016, IEEE Communications Magazine.

[17]  Yuanan Liu,et al.  A Novel Balanced-to-Unbalanced Complex Impedance-Transforming In-Phase Power Divider , 2017, IEEE Access.

[18]  Kai Xu,et al.  A Balanced-to-Unbalanced Microstrip Power Divider With Filtering Function , 2015, IEEE Transactions on Microwave Theory and Techniques.

[19]  Sofie Pollin,et al.  IEEE 5G Spectrum Sharing Challenge: A Practical Evaluation of Learning and Feedback , 2016, IEEE Communications Magazine.

[20]  Uwe Fink,et al.  Microwave Differential Circuit Design Using Mixed Mode S Parameters , 2016 .

[21]  Yi-Hsin Pang,et al.  A Planar Balanced Crossover , 2016, IEEE Transactions on Microwave Theory and Techniques.

[22]  Quan Xue,et al.  Compact Wideband Differential Bandpass Filters Using Half-Wavelength Ring Resonator , 2013, IEEE Microwave and Wireless Components Letters.

[23]  Kaixue Ma,et al.  Miniaturized 40–60 GHz On-Chip Balun With Capacitive Loading Compensation , 2014, IEEE Electron Device Letters.

[24]  Wenjie Feng,et al.  Balanced filters with wideband common mode suppression using dual-mode ring resonators , 2015, IEEE Transactions on Circuits and Systems I: Regular Papers.

[25]  Yu Zhao,et al.  Single-Ended-to-Balanced Filtering Power Dividers With Wideband Common-Mode Suppression , 2018, IEEE Transactions on Microwave Theory and Techniques.

[26]  Quan Xue,et al.  Unbalanced-to-Balanced and Balanced-to-Unbalanced Diplexer With High Selectivity and Common-Mode Suppression , 2011, IEEE Transactions on Microwave Theory and Techniques.

[27]  Roberto Gómez-García,et al.  Multi-Functional Balanced-to-Unbalanced Filtering Power Dividers With Extended Upper Stopband , 2019, IEEE Transactions on Circuits and Systems II: Express Briefs.

[28]  Quan Xue,et al.  Wideband Balanced Network with High Isolation Using Double-Sided Parallel-Strip Line , 2015, IEEE Transactions on Microwave Theory and Techniques.

[29]  Jen-Tsai Kuo,et al.  Design of Compact Symmetric Four-Port Crossover Junction , 2009, IEEE Microwave and Wireless Components Letters.

[30]  Yuanan Liu,et al.  Wideband Single-Ended and Differential Bandpass Filters Based on Terminated Coupled Line Structures , 2017, IEEE Transactions on Microwave Theory and Techniques.

[31]  Theodore S. Rappaport,et al.  Overview of Millimeter Wave Communications for Fifth-Generation (5G) Wireless Networks—With a Focus on Propagation Models , 2017, IEEE Transactions on Antennas and Propagation.

[32]  Zabih Ghassemlooy,et al.  Design Methodology for Six-Port Equal/Unequal Quadrature and Rat-Race Couplers With Balanced and Unbalanced Ports Terminated by Arbitrary Resistances , 2018, IEEE Transactions on Microwave Theory and Techniques.

[33]  Wenquan Che,et al.  High-Selectivity Wideband Balanced Filters Using Coupled Lines With Open/Shorted Stubs , 2017, IEEE Microwave and Wireless Components Letters.

[34]  Fadhel M. Ghannouchi,et al.  A Wideband Balanced-to-Unbalanced Coupled-Line Power Divider , 2016, IEEE Microwave and Wireless Components Letters.