Three-dimensional solid element analysis and the membrane approximated analysis employing the hyperelastic material model have been developed for the simulation of the thermoforming process. For the free inflation test of a rectangular sheet, these two analyses showed the same behavior when the sheet thickness was thin, and they deviated more and more as the sheet thickness increased. In this research, we made a guideline for the accuracy range of sheet thickness for the membrane analysis to be applied. The simulations were performed for both vacuum forming and the plug-assisted forming process. To compare the simulation results with experiments, laboratory scale thermoforming experiments were performed with acrylonitrile-butadiene-styrene (ABS). The material parameters of the hyperelastic model were obtained by uni-directional hot tensile tests, and the thickness distributions obtained from experiments corresponded well with the numerical results. Non-isothermal analysis that took into account the sheet, temperature distribution measured directly from the experiments was also performed. It was found that the non-isothermal analysis greatly improved the predictability of the numerical simulation, and it is important to take into account the sheet temperature distribution for a more reliable simulation of the thermoforming process.
[1]
Mohamed S. Gadala,et al.
Alternative methods for the solution of hyperelastic problems with incompressibility
,
1992
.
[2]
Stress analysis of short weld toe cracks
,
1993
.
[3]
J. Oden.
Finite Elements of Nonlinear Continua
,
1971
.
[4]
John Vlachopoulos,et al.
Computer simulation of thermoforming in complex shapes
,
1992
.
[5]
J. W. Lee,et al.
Finite Element Analysis of the Effect of Processing Conditions on Thermoforming
,
1999
.
[6]
J. Williams.
A method of calculation for thermoforming plastics sheets
,
1970
.
[7]
Z. Tadmor,et al.
Principles of Polymer Processing
,
1979
.
[8]
J. Vlachopoulos,et al.
Finite element analysis of inflation of an axisymmetric sheet of finite thickness
,
1991
.
[9]
N. G. Zamani,et al.
Status of the finite element method in the thermoforming process
,
1989
.
[10]
L. R. Schmidt,et al.
Biaxial stretching of heat‐softened plastic sheets: Experiments and results
,
1975
.
[11]
H. F. Nied,et al.
Three-dimensional finite element simulation of thermoforming
,
1990
.
[12]
M. O. Ghafur,et al.
Simulation of Thermoforming and Blowmolding — Theory and Experiments
,
1995
.