Reliability considerations of a fuel cell backup power system for telecom applications

Abstract A commercial fuel cell backup power unit is tested in real life operating conditions at a base station of a Turkish telecom operator. The fuel cell system responds to 256 of 260 electric power outages successfully, providing the required power to the base station. Reliability of the fuel cell backup power unit is found to be 98.5% at the system level. On the other hand, a qualitative reliability analysis at the component level is carried out. Implications of the power management algorithm on reliability is discussed. Moreover, integration of the backup power unit to the base station ecosystem is reviewed in the context of reliability. Impact of inverter design on the stability of the output power is outlined. Significant current harmonics are encountered when a generic inverter is used. However, ripples are attenuated significantly when a custom design inverter is used. Further, fault conditions are considered for real world case studies such as running out of hydrogen, a malfunction in the system, or an unprecedented operating scheme. Some design guidelines are suggested for hybridization of the backup power unit for an uninterrupted operation.

[1]  Denis Candusso,et al.  Power electronics interface for an hybrid PEMFC generating system with fault management strategies for transportation , 2009, 2009 13th European Conference on Power Electronics and Applications.

[2]  T. Meynard,et al.  Interactions Between Fuel Cells and Power Converters: Influence of Current Harmonics on a Fuel Cell Stack , 2007, IEEE Transactions on Power Electronics.

[3]  Fatiha Nejjari,et al.  On-line model-based fault detection and isolation for PEM fuel cell stack systems , 2014 .

[4]  S.K. Mazumder,et al.  A Ripple-Mitigating and Energy-Efficient Fuel Cell Power-Conditioning System , 2007, IEEE Transactions on Power Electronics.

[5]  Damien Guilbert,et al.  Investigation of the interactions between proton exchange membrane fuel cell and interleaved DC/DC boost converter in case of power switch faults , 2015 .

[6]  Philipp Dietrich,et al.  Fuel cell/battery passive hybrid power source for electric powertrains , 2011 .

[7]  R. Gemmen.  Analysis for the Effect of Inverter Ripple Current on Fuel Cell Operating Condition , 2001, Heat Transfer: Volume 4 — Combustion and Energy Systems.

[8]  Bo-Hyung Cho,et al.  Impedance-based diagnosis of polymer electrolyte membrane fuel cell failures associated with a low frequency ripple current , 2013 .

[9]  Mustafa Fazil Serincan.  Validation of hybridization methodologies of fuel cell backup power systems in real-world telecom applications , 2016 .

[10]  Angelika Heinzel,et al.  Power management optimization of fuel cell/battery hybrid vehicles with experimental validation , 2014 .

[11]  S. Sprik,et al.  Backup Power Cost of Ownership Analysis and Incumbent Technology Comparison , 2014 .

[12]  M. S. Arefeen,et al.  Analysis and minimization of input ripple current in PWM inverters for designing reliable fuel cell power systems , 2006 .

[13]  Eduardo de Teresa Galván,et al.  Power conditioning of fuel cell systems in portable applications , 2007 .

[14]  Mohammad Salah,et al.  Model development and analysis of a mid-sized hybrid fuel cell/battery vehicle with a representative driving cycle , 2014 .

[15]  Damien Guilbert,et al.  FPGA based fault-tolerant control on an interleaved DC/DC boost converter for fuel cell electric vehicle applications , 2015 .

[16]  Qi Li,et al.  Development of energy management system based on a power sharing strategy for a fuel cell-battery-supercapacitor hybrid tramway , 2015 .

[17]  Jenn-Jiang Hwang,et al.  Characteristic study on fuel cell/battery hybrid power system on a light electric vehicle , 2012 .

[18]  Nicu Bizon,et al.  A new topology of fuel cell hybrid power source for efficient operation and high reliability , 2011 .

[19]  Li Li,et al.  Performance comparison of input current ripple reduction methods in UPS applications with hybrid PEM fuel cell/supercapacitor power sources , 2015 .

[20]  A. Kirubakaran,et al.  A review on fuel cell technologies and power electronic interface , 2009 .

[21]  Azah Mohamed,et al.  A review on energy management system for fuel cell hybrid electric vehicle: Issues and challenges , 2015 .

[22]  José Manuel Bravo,et al.  Optimal sizing for UPS systems based on batteries and/or fuel cell , 2013 .

[23]  Jenn-Jong Shieh,et al.  A new control strategy for hybrid fuel cell-battery power systems with improved efficiency , 2012 .

[24]  K. Ghedamsi,et al.  Energy management and fault tolerant control strategies for fuel cell/ultra-capacitor hybrid electric vehicles to enhance autonomy, efficiency and life time of the fuel cell system , 2015 .

[25]  Mark L. Ayers,et al.  Telecommunications System Reliability Engineering, Theory, and Practice , 2012 .

[26]  Shuhai Quan,et al.  Fuel cell and lithium iron phosphate battery hybrid powertrain with an ultracapacitor bank using direct parallel structure , 2015 .

[27]  Hubertus Kehl.  Fault Analysis and Fault Tolerance of a Base Station System for Mobile Communications , 2000 .

[28]  Marcelo Godoy Simões,et al.  On-line fault diagnostic system for proton exchange membrane fuel cells , 2008 .

[29]  Yongdong Li,et al.  Fault detection and isolation for Polymer Electrolyte Membrane Fuel Cell systems by analyzing cell voltage generated space , 2015 .

[30]  Siew-Chong Tan,et al.  Mitigation of Low-Frequency Current Ripple in Fuel-Cell Inverter Systems Through Waveform Control , 2013, IEEE Transactions on Power Electronics.

[31]  D. W. Yu,et al.  Fault detection and isolation for PEM fuel cell stack with independent RBF model , 2014, Eng. Appl. Artif. Intell..

[32]  Damien Guilbert,et al.  Interactions between fuel cell and DC/DC converter for fuel cell electric vehicle applications: Influence of faults , 2013, IECON 2013 - 39th Annual Conference of the IEEE Industrial Electronics Society.

[33]  Byung-Moon Han,et al.  Battery ripple current reduction in a three-phase interleaved dc-dc converter for 5kW battery charger , 2011, 2011 IEEE Energy Conversion Congress and Exposition.

[34]  Damiano Rotondo,et al.  Fault Tolerant Control of a PEM Fuel Cell using qLPV Virtual Actuators , 2015 .

[35]  Yuedong Zhan,et al.  Power and energy management of grid/PEMFC/battery/supercapacitor hybrid power sources for UPS applications , 2015 .

[36]  Rosdiadee Nordin,et al.  Energy optimisation of hybrid off-grid system for remote telecommunication base station deployment in Malaysia , 2015, EURASIP J. Wirel. Commun. Netw..