Full-scale measurements of wind effects and modal parameter identification of Yingxian wooden tower

The Yingxian wooden tower in China is currently the tallest wooden tower in the world. It was built in 1056 AD and is 65.86 m high. Field measurements of wind speed and wind-induced response of this tower are conducted. The wind characteristics, including the average wind speed, wind direction, turbulence intensity, gust factor, turbulence integral length scale and velocity spectrum are investigated. The power spectral density and the root-mean-square wind-induced acceleration are analyzed. The structural modal parameters of this tower are identified with two different methods, including the Empirical Mode Decomposition (EMD) combined with the Random Decrement Technique (RDT) and Hilbert transform technique, and the stochastic subspace identification (SSI) method. Results show that strong wind is coming predominantly from the West-South of the tower which is in the same direction as the inclination of the structure. The Von Karman spectrum can describe the spectrum of wind speed well. Wind-induced torsional vibration obviously occurs in this tower. The natural frequencies identified by EMD, RDT and Hilbert Transform are close to those identified by SSI method, but there is obvious difference between the identified damping ratios for the first two modes.

[1]  Kenny C. S Kwok,et al.  Full-scale measurements of wind-induced acceleration response of Sydney Tower , 1990 .

[2]  N. Huang,et al.  The empirical mode decomposition and the Hilbert spectrum for nonlinear and non-stationary time series analysis , 1998, Proceedings of the Royal Society of London. Series A: Mathematical, Physical and Engineering Sciences.

[3]  Yukio Tamura,et al.  Wind characteristics of a strong typhoon , 2009 .

[4]  Cheng-Hsin Chang,et al.  The influence of model surface roughness on wind loads of the RC chimney by comparing the full-scale measurements and wind tunnel simulations , 2013 .

[5]  G. Solari,et al.  Probabilistic 3-D turbulence modeling for gust buffeting of structures , 2001 .

[6]  Darryll J. Pines,et al.  Structural health monitoring using empirical mode decomposition and the Hilbert phase , 2006 .

[7]  J. R. Wu,et al.  Field measurements of boundary layer wind characteristics and wind-induced responses of super-tall buildings , 2008 .

[8]  Theodore Stathopoulos,et al.  Full-scale measurements of wind pressures on flat roof corners , 1990 .

[9]  B. Peeters,et al.  Stochastic System Identification for Operational Modal Analysis: A Review , 2001 .

[10]  Y. Tamura,et al.  Measurement of Wind-induced Response of Buildings using RTK-GPS , 2001 .

[11]  S. R. Ibrahim.  Random Decrement Technique for Modal Identification of Structures , 1977 .

[12]  Qiusheng Li,et al.  Full-scale measurements of wind effects on the Jin Mao building , 2007 .

[13]  Wei-Xin Ren,et al.  EMD-based stochastic subspace identification of structures from operational vibration measurements , 2005 .

[14]  Nicholas P. Jones,et al.  Analysis of full-scale wind and pressure measurements on a low-rise building , 2009 .

[15]  John H G Macdonald,et al.  Evaluation of buffeting predictions of a cable-stayed bridge from full-scale measurements , 2003 .

[16]  Hilmi Luş,et al.  Ambient Vibration Analysis with Subspace Methods and Automated Mode Selection: Case Studies , 2008 .

[17]  Piotr Górski,et al.  Monitoring of tall slender structures by GPS measurements , 2009 .

[18]  N. Roveri,et al.  Damage detection in structures under traveling loads by Hilbert–Huang transform , 2012 .