KIT-5-Assisted Synthesis of Mesoporous SnO2 for High-Performance Humidity Sensors with a Swift Response/Recovery Speed

Developing highly efficient semiconductor metal oxide (SMOX) sensors capable of accurate and fast responses to environmental humidity is still a challenging task. In addition to a not so pronounced sensitivity to relative humidity change, most of the SMOXs cannot meet the criteria of real-time humidity sensing due to their long response/recovery time. The way to tackle this problem is to control adsorption/desorption processes, i.e., water-vapor molecular dynamics, over the sensor’s active layer through the powder and pore morphology design. With this in mind, a KIT-5-mediated synthesis was used to achieve mesoporous tin (IV) oxide replica (SnO2-R) with controlled pore size and ordering through template inversion and compared with a sol-gel synthesized powder (SnO2-SG). Unlike SnO2-SG, SnO2-R possessed a high specific surface area and quite an open pore structure, similar to the KIT-5, as observed by TEM, BET and SWAXS analyses. According to TEM, SnO2-R consisted of fine-grained globular particles and some percent of exaggerated, grown twinned crystals. The distinctive morphology of the SnO2-R-based sensor, with its specific pore structure and an increased number of oxygen-related defects associated with the powder preparation process and detected at the sensor surface by XPS analysis, contributed to excellent humidity sensing performances at room temperature, comprised of a low hysteresis error (3.7%), sensitivity of 406.8 kΩ/RH% and swift response/recovery speed (4 s/6 s).

[1]  G. Gayathri,et al.  A sensitive humidity sensor at low pressure with SnO2 QDs , 2022, Sensors and Actuators A: Physical.

[2]  L. P. Purohit,et al.  Sb incorporated SnO2 nanostructured thin films for CO2 gas sensing and humidity sensing applications , 2022, Journal of Alloys and Compounds.

[3]  Hongyan Zhang,et al.  Preparation and Research of a High-Performance ZnO/SnO2 Humidity Sensor , 2021, Sensors.

[4]  Peng Wu,et al.  Advances in SnO2-based perovskite solar cells: from preparation to photovoltaic applications , 2021, Journal of Materials Chemistry A.

[5]  M. Spreitzer,et al.  Microstructure development in (Co,Ta)-doped SnO2-based ceramics with promising varistor and dielectric properties , 2020 .

[6]  A. Gavriilidis,et al.  Co-precipitation synthesis of stable iron oxide nanoparticles with NaOH: New insights and continuous production via flow chemistry , 2020, Chemical Engineering Journal.

[7]  N. Daneu,et al.  Twinning in SnO2-based ceramics doped with CoO- and Nb2O5: morphology of multiple twins revealed by electron backscatter diffraction , 2020, Acta crystallographica Section B, Structural science, crystal engineering and materials.

[8]  Gang Wang,et al.  Quantum-Sized SnO2 Nanoparticles with Upshifted Conduction Band: A Promising Electron Transportation Material for Quantum Dot Light-Emitting Diodes. , 2020, Langmuir : the ACS journal of surfaces and colloids.

[9]  Y. Song,et al.  Dopant‐Free, Amorphous–Crystalline Heterophase SnO2 Electron Transport Bilayer Enables >20% Efficiency in Triple‐Cation Perovskite Solar Cells , 2020, Advanced Functional Materials.

[10]  Hong Xia,et al.  Fast-response humidity sensor based on laser printing for respiration monitoring , 2020, RSC advances.

[11]  Honeywell,et al.  Humidity Sensors , 2002 .

[12]  A. Walcarius,et al.  Mesoporous Silica-Based Materials for Electronics-Oriented Applications , 2019, Molecules.

[13]  G. Branković,et al.  From titania to titanates: Phase and morphological transition in less alkaline medium under mild conditions , 2019, Journal of Alloys and Compounds.

[14]  M. Rumyantseva,et al.  Nanocomposites SnO2/SiO2 for CO Gas Sensors: Microstructure and Reactivity in the Interaction with the Gas Phase , 2019, Materials.

[15]  B. Vlahovic,et al.  Humidity sensing properties of nanocrystalline pseudobrookite (Fe2TiO5) based thick films , 2018, Sensors and Actuators B: Chemical.

[16]  Z. Samardz̆ija,et al.  Twinning and charge compensation in Nb2O5–doped SnO2–CoO ceramics exhibiting promising varistor characteristics , 2018 .

[17]  N. Bârsan,et al.  Ambient Humidity Influence on CO Detection with SnO2 Gas Sensing Materials. A Combined DRIFTS/DFT Investigation , 2017 .

[18]  Wei Li,et al.  Fabrication of Ordered SnO2 Nanostructures with Enhanced Humidity Sensing Performance , 2017, Sensors.

[19]  Vijay K. Tomer,et al.  An excellent humidity sensor based on In–SnO2 loaded mesoporous graphitic carbon nitride , 2017 .

[20]  Chang-Wei Xu,et al.  Three-dimensional ordered mesoporous Co3O4 enhanced by Pd for oxygen evolution reaction , 2017, Scientific Reports.

[21]  H. Tüysüz,et al.  Protocol for the Nanocasting Method: Preparation of Ordered Mesoporous Metal Oxides , 2017 .

[22]  E. Pellicer,et al.  Nanocasting synthesis of mesoporous SnO2 with a tunable ferromagnetic response through Ni loading , 2016 .

[23]  E. Domashevskaya,et al.  Investigations of the composition of macro-, micro- and nanoporous silicon surface by ultrasoft X-ray spectroscopy and X-ray photoelectron spectroscopy , 2015 .

[24]  Lu Wang,et al.  Highly sensitive surface acoustic wave (SAW) humidity sensors based on sol–gel SiO2 films: Investigations on the sensing property and mechanism , 2015 .

[25]  A. Abdullah,et al.  Mesoporous SnO2 by Nanocasting Route Using Various Silica Templates for Gas Sensing Application , 2015 .

[26]  Vijay K. Tomer,et al.  In-situ synthesis of SnO2/SBA-15 hybrid nanocomposite as highly efficient humidity sensor , 2015 .

[27]  Muthusamy Poomalai Pachamuthu,et al.  Characterizations of tin (SnO2) doped KIT-5 by direct synthesis , 2015 .

[28]  M. Fantini,et al.  Structural studies of mesoporous ZrO2-CeO2 and ZrO2-CeO2/SiO2 mixed oxides for catalytical applications , 2015, 1503.01963.

[29]  A. Srivastava,et al.  Growth of thermally evaporated SnO2 nanostructures for optical and humidity sensing application , 2014 .

[30]  Abdullah,et al.  Nanocasting Route for the Synthesis of Ordered Mesoporous Sn02 with Highly Crystalline Framework , 2014 .

[31]  Yun Wang,et al.  Facile fabrication of a well-ordered porous Cu-doped SnO2 thin film for H2S sensing. , 2014, ACS applied materials & interfaces.

[32]  Mohd Nizar Hamidon,et al.  Humidity Sensors Principle, Mechanism, and Fabrication Technologies: A Comprehensive Review , 2014, Sensors.

[33]  B. Liu,et al.  High-temperature humidity sensors based on WO3–SnO2 composite hollow nanospheres , 2014 .

[34]  Subi J. George,et al.  Ultrafast response humidity sensor using supramolecular nanofibre and its application in monitoring breath humidity and flow , 2014, Scientific Reports.

[35]  F. Qu,et al.  Synthesis of mesoporous SnO2 nanomaterials with selective gas-sensing properties , 2013, Journal of Sol-Gel Science and Technology.

[36]  D. Zhao,et al.  Ordered Mesoporous Materials: ZHAO:MESOPOROUS MATERIALS O-BK , 2013 .

[37]  J. Khinast,et al.  Small- and wide-angle X-ray scattering (SWAXS) for quantification of aspirin content in a binary powder mixture. , 2012, International journal of pharmaceutics.

[38]  J. Khinast,et al.  Effect of process variables on the Small and Wide Angle X-ray Scattering (SWAXS) patterns of powders, granules and pharmaceutical tablets , 2012 .

[39]  N. Daneu,et al.  Grain-Growth Phenomena in ZnO Ceramics in the Presence of Inversion Boundaries , 2011 .

[40]  Thorsten Wagner,et al.  Ordered nanoporous SnO2 gas sensors with high thermal stability , 2010 .

[41]  Li Zhang,et al.  Electrospun Nanofibers of ZnO−SnO2 Heterojunction with High Photocatalytic Activity , 2010 .

[42]  Huijuan Zhang,et al.  Morphology-controlled synthesis of SnO(2) nanotubes by using 1D silica mesostructures as sacrificial templates and their applications in lithium-ion batteries. , 2010, Small.

[43]  P. Bruce,et al.  Synthesis of ordered mesoporous NiO with crystalline walls and a bimodal pore size distribution. , 2008, Journal of the American Chemical Society.

[44]  Nicolae Barsan,et al.  Direct formation of highly porous gas-sensing films by in situ thermophoretic deposition of flame-made Pt/SnO2 nanoparticles , 2006 .

[45]  Chi-En Lu,et al.  Humidity Sensors: A Review of Materials and Mechanisms , 2005 .

[46]  Kengo Shimanoe,et al.  Nanotubular SnO2 Templated by Cellulose Fibers: Synthesis and Gas Sensing , 2005 .

[47]  P. Faia,et al.  AC impedance spectroscopy: a new equivalent circuit for titania thick film humidity sensors , 2005 .

[48]  F. Kleitz,et al.  Large Cage Face-Centered-Cubic Fm3m Mesoporous Silica: Synthesis and Structure , 2003 .

[49]  Makoto Egashira,et al.  Gas-sensing properties of ordered mesoporous SnO2 and effects of coatings thereof , 2003 .

[50]  Makoto Egashira,et al.  Preparation and gas-sensing properties of thermally stable mesoporous SnO2 , 2002 .

[51]  Norio Miura,et al.  Gas sensing properties of tin oxide thin films fabricated from hydrothermally treated nanoparticles: Dependence of CO and H2 response on film thickness , 2001 .

[52]  Elson Longo,et al.  A New Method to Control Particle Size and Particle Size Distribution of SnO2 Nanoparticles for Gas Sensor Applications , 2000 .

[53]  L. D Pedersen,et al.  Assessment of sensors used in the food industry , 1991 .

[54]  K. Sing Reporting physisorption data for gas/solid systems with special reference to the determination of surface area and porosity (Recommendations 1984) , 1985 .

[55]  Tara Betts Humidity , 1912, Buffalo medical journal.

[56]  Vijay K. Tomer,et al.  Fast response with high performance humidity sensing of Ag–SnO2/SBA-15 nanohybrid sensors , 2016 .

[57]  Jinjuan Xue,et al.  Nanocasting synthesis of an ordered mesoporous CeO2-supported Pt nanocatalyst with enhanced catalytic performance for the reduction of 4-nitrophenol , 2016 .

[58]  J. S. Reed,et al.  Principles of ceramics processing , 1995 .

[59]  D. Kohl,et al.  Physical and Chemical Aspects of Oxidic Semiconductor Gas Sensors , 1988 .