Novel solid oxide fuel cell system controller for rapid load following

Abstract A novel SOFC system control strategy has been developed for rapid load following. The strategy was motivated from the performance of a baseline control strategy developed from control concepts in the literature. The basis for the fuel cell system control concepts are explained by a simplified order of magnitude time scale analysis. The control concepts are then investigated in a detailed quasi-two-dimensional integrated dynamic system model that resolves the physics of heat transfer, chemical kinetics, mass convection and electrochemistry within the system. The baseline control strategy is based on the standard operating method of constant utilization with no control of the combustor temperature. Simulation indicates that with this control strategy large combustor transients can take place during load transients because the fuel flow to the combustor increases faster than the air flow. To alleviate this problem, a novel control structure that maintains the combustor temperature within acceptable ranges without any supplementary hardware was introduced. The combustor temperature is controlled by manipulating the current to change the combustor inlet stoichiometry. The load following capability of SOFC systems is inherently limited by anode compartment fuel depletion during the time of fuel delivery delay. This research indicates that future SOFC systems with proper system and control configurations can exhibit excellent load following characteristics.

[1]  Yamato Asakura,et al.  Prospect of hydrogen technology using proton-conducting ceramics , 2004 .

[2]  H. Matsumoto,et al.  A solid electrolyte hydrogen sensor with an electrochemically-supplied hydrogen standard , 2001 .

[3]  Rory A. Roberts,et al.  Control Design for a Bottoming Solid Oxide Fuel Cell Gas Turbine Hybrid System , 2006 .

[4]  Rory A. Roberts,et al.  Dynamic Simulation of a Pressurized 220kW Solid Oxide Fuel-Cell–Gas-Turbine Hybrid System: Modeled Performance Compared to Measured Results , 2006 .

[5]  Jack Brouwer,et al.  Control design of an atmospheric solid oxide fuel cell/gas turbine hybrid system: Variable versus fixed speed gas turbine operation , 2006 .

[6]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.

[7]  Lars Imsland,et al.  Control strategy for a solid oxide fuel cell and gas turbine hybrid system , 2006 .

[8]  Anna G. Stefanopoulou,et al.  Control of Fuel Cell Power Systems: Principles, Modeling, Analysis and Feedback Design , 2004 .

[9]  Donato Aquaro,et al.  High temperature heat exchangers for power plants : Performance of advanced metallic recuperators , 2007 .

[10]  G. Froment,et al.  Methane steam reforming, methanation and water‐gas shift: I. Intrinsic kinetics , 1989 .

[11]  Bjarne A. Foss,et al.  Modeling and control of a SOFC-GT-based autonomous power system , 2007 .

[12]  Miriam Kemm,et al.  Steady state and transient thermal stress analysis in planar solid oxide fuel cells , 2005 .

[13]  Fabian Mueller,et al.  Dynamic Simulation of an Integrated Solid Oxide Fuel Cell System Including Current-Based Fuel Flow Control , 2005 .

[14]  S. Singhal,et al.  Polarization Effects in Intermediate Temperature, Anode‐Supported Solid Oxide Fuel Cells , 1999 .

[15]  J. Mathiak,et al.  Dynamics of H2 production by steam reforming , 2004 .

[16]  Faryar Jabbari,et al.  Analysis of a molten carbonate fuel cell: Numerical modeling and experimental validation , 2006 .

[17]  Y. Inui,et al.  Analytical investigation on cell temperature control method of planar solid oxide fuel cell , 2006 .

[18]  G. Froment,et al.  Methane steam reforming: II. Diffusional limitations and reactor simulation , 1989 .

[19]  Kevin Tomsovic,et al.  Development of models for analyzing the load-following performance of microturbines and fuel cells , 2002 .

[20]  Keith R. Williams,et al.  An Introduction to Fuel Cells , 1966 .

[21]  Alberto Traverso,et al.  Influence of the anodic recirculation transient behaviour on the SOFC hybrid system performance , 2005 .

[22]  Li Wang,et al.  Solid-state amperometric hydrogen sensor based on polymer electrolyte membrane fuel cell , 2005 .

[23]  David Brewer,et al.  HSR/EPM combustor materials development program , 1999 .

[24]  S. K. Hazra,et al.  High sensitivity and fast response hydrogen sensors based on electrochemically etched porous titania thin films , 2006 .

[25]  W. Weppner,et al.  Development of a hydrogen sensor based on solid polymer electrolyte membranes , 2006 .

[26]  A. Nakajo,et al.  Modeling of thermal stresses and probability of survival of tubular SOFC , 2006 .

[27]  G. S. Samuelsen,et al.  Power and temperature control of fluctuating biomass gas fueled solid oxide fuel cell and micro gas turbine hybrid system , 2006 .