Distributed fault-tolerant strategy for electric swing system of hybrid excavators under communication errors

A distributed fault-tolerant strategy for the controller area network based electric swing system of hybrid excavators is proposed to achieve good performance under communication errors based on the adaptive compensation of the delays and packet dropouts. The adverse impacts of communication errors are effectively reduced by a novel delay compensation scheme, where the feedback signal and the control command are compensated in each control period in the central controller and the swing motor driver, respectively, without requiring additional network bandwidth. The recursive least-squares algorithm with forgetting factor algorithm is employed to identify the time-varying model parameters due to pose variation, and a reverse correction law is embedded into the feedback compensation in consecutive packet dropout scenarios to overcome the impacts of the model error. Simulations and practical experiments are conducted. The results show that the proposed fault-tolerant strategy can effectively reduce the communication-error-induced overshoot and response time variation.

[1]  Asok Ray,et al.  Experimental verification of a delay compensation algorithm for integrated communication and control systems , 1994 .

[2]  Qingfeng Wang,et al.  Development of hybrid powered hydraulic construction machinery , 2010 .

[3]  Zhang Yanting,et al.  Control strategies of power system in hybrid hydraulic excavator , 2008 .

[4]  Tao Wang,et al.  An Energy-Saving Pressure-Compensated Hydraulic System With Electrical Approach , 2014, IEEE/ASME Transactions on Mechatronics.

[5]  Takao Nanjo,et al.  Development of New Hybrid Excavator , 2007 .

[6]  Massimo Bongiorno,et al.  Application of Recursive Least Squares Algorithm With Variable Forgetting Factor for Frequency Component Estimation in a Generic Input Signal , 2014, IEEE Transactions on Industry Applications.

[7]  Qingfeng Wang,et al.  Health monitoring of controller area network in hybrid excavator based on the message response time , 2014, 2014 IEEE/ASME International Conference on Advanced Intelligent Mechatronics.

[8]  Mo-Yuen Chow,et al.  Gain scheduler middleware: a methodology to enable existing controllers for networked control and teleoperation - part I: networked control , 2004, IEEE Transactions on Industrial Electronics.

[9]  Arianna Guidolin Networked Control System , 2013 .

[10]  Tomaž Katrašnik,et al.  Hybridization of powertrain and downsizing of IC engine – A way to reduce fuel consumption and pollutant emissions – Part 1 , 2007 .

[11]  Qingfeng Wang,et al.  Research on the energy regeneration systems for hybrid hydraulic excavators , 2010 .

[12]  Seung-Ki Sul,et al.  Power Control Algorithm for Hybrid Excavator with Super Capacitor , 2008, 2008 IEEE Industry Applications Society Annual Meeting.

[13]  Ji Huang,et al.  Robust Tracking Control of Networked Control Systems: Application to a Networked DC Motor , 2013, IEEE Transactions on Industrial Electronics.

[14]  Guo-Ping Liu,et al.  Networked Predictive Control of Uncertain Systems With Multiple Feedback Channels , 2013, IEEE Transactions on Industrial Electronics.

[15]  Yong Lei,et al.  Online Real-Time Estimation of Response Time for Periodic Messages in Controller Area Networks , 2015 .

[16]  Amir Hossein Davaie Markazi,et al.  Variable Selective Control Method for Networked Control Systems , 2013, IEEE Transactions on Control Systems Technology.

[17]  Xiao Lin,et al.  Performance analysis of hydraulic excavator powertrain hybridization , 2009 .

[18]  Jianqiu Li,et al.  Combined AFS and DYC Control of Four-Wheel-Independent-Drive Electric Vehicles over CAN Network with Time-Varying Delays , 2014, IEEE Transactions on Vehicular Technology.

[19]  Bo Yu,et al.  Robust mixed H2/H∞ control of networked control systems with random time delays in both forward and backward communication links , 2011, Autom..

[20]  Huijun Gao,et al.  Network-Induced Constraints in Networked Control Systems—A Survey , 2013, IEEE Transactions on Industrial Informatics.

[21]  Qingfeng Wang EVALUATION FOR ENERGY SAVING EFFECT AND SIMULATION RESEARCH ON ENERGY SAVING OF HYDRAULIC SYSTEM IN HYBRID CONSTRUCTION MACHINERY , 2005 .

[22]  K Jin,et al.  A control method to suppress the swing vibration of a hybrid excavator using sliding mode approach , 2012 .

[23]  Mo-Yuen Chow,et al.  Networked Control System: Overview and Research Trends , 2010, IEEE Transactions on Industrial Electronics.

[24]  Yujin Fan,et al.  MICRO CONTACT PROCESS ANALYSIS IN ABRASIVE WEAR BY FINITE ELEMENT METHOD , 2005 .

[25]  Yong Lei,et al.  Model-Based Detection and Monitoring of the Intermittent Connections for CAN Networks , 2014, IEEE Transactions on Industrial Electronics.

[26]  Dong Yue,et al.  H-Infinity Stabilization for Singular Networked Cascade Control Systems With State Delay and Disturbance , 2014, IEEE Transactions on Industrial Informatics.

[27]  David Levy,et al.  Compensation for control packet dropout in networked control systems , 2008, Inf. Sci..

[28]  Yuanqing Xia,et al.  Networked Predictive Control of Systems With Random Network Delays in Both Forward and Feedback Channels , 2007, IEEE Transactions on Industrial Electronics.

[29]  Asok Ray,et al.  An observer-based compensator for distributed delays , 1990, Autom..

[30]  Mo-Yuen Chow,et al.  Gain scheduler middleware: a methodology to enable existing controllers for networked control and teleoperation-part II: teleoperation , 2004, IEEE Transactions on Industrial Electronics.

[31]  Guo-Ping Liu,et al.  Predictive Output Feedback Control for Networked Control Systems , 2014, IEEE Transactions on Industrial Electronics.

[32]  Johan Nilsson,et al.  Real-Time Control Systems with Delays , 1998 .

[33]  Armand Toguyéni,et al.  A Switched System Approach to Exponential Stabilization Through Communication Network , 2012, IEEE Transactions on Control Systems Technology.

[34]  Jun Zhao,et al.  Construction of Lyapunov-Krasovskii functionals for switched nonlinear systems with input delay , 2014, Autom..

[35]  Kyongsu Yi,et al.  Development of supervisory control strategy for optimized fuel consumption of the compound hybrid excavator , 2012 .

[36]  Tae-Suk Kwon,et al.  Power Control Algorithm for Hybrid Excavator With Supercapacitor , 2010 .

[37]  Qingfeng Wang,et al.  The control strategy for improving the stability of a powertrain for a compound hybrid power excavator , 2015 .