Surface-enhanced Raman scattering (SERS) system for continuous measurements of chemicals in sea-water

A laboratory-based system for measurement of chemicals in sea-water with sol–gel-derived surface-enhanced Raman scattering (SERS) substrates is presented. The motivation behind this work was the development of a marinized prototype sensor. A long-term spectral stability of better than 1 cm−1 over a period of several months was observed. Photodegradation of the SERS layer was avoided by the choice of optical components and layout. Dielectric edge filters and holographic notch filters were compared. Coated fibres were tested and results are discussed in terms of fibre choice, reduction of background signal, sensitivity and time response. Continuous analysis was performed with two flow-through cells, the first a modification to a standard glass cuvette and the second an improved in-house-constructed aluminium cell. SERS investigations on samples whose turbidity ranged from 0 to 400 NTU were performed with both cells. These tests show the suitability of the developed system for continuous monitoring of real samples and possible application in on-line process control. Copyright © 2000 John Wiley & Sons, Ltd.

[1]  Harry Owen,et al.  Performance of a Holographic Supernotch Filter , 1993 .

[2]  David L. Stokes,et al.  Surface-enhanced Raman fiber optic sensors for remote monitoring , 1995, Other Conferences.

[3]  Andreas Hoffmann,et al.  Near-infrared Fourier transform Raman spectroscopy : facing absorption and background , 1991 .

[4]  Michael L. Myrick,et al.  Elimination of Background in Fiber-Optic Raman Measurements , 1990 .

[5]  M. Fleischmann,et al.  Raman spectra of pyridine adsorbed at a silver electrode , 1974 .

[6]  W. S. Sutherland,et al.  Normal Raman and surface‐enhanced Raman scattering (SERS) spectra of some fungicides and related chemical compounds , 1992 .

[7]  Jeanne E. Pemberton,et al.  Frequency/Wavelength Calibration of Multipurpose Multichannel Raman Spectrometers. Part I: Instrumental Factors Affecting Precision , 1995 .

[8]  I. R. Lewis,et al.  Raman Spectrometry with Fiber-Optic Sampling , 1996 .

[9]  Ying-sing Li,et al.  Optical-Fiber Raman Probe with Low Background Interference by Spatial Optimization , 1994 .

[10]  Keith T. Carron,et al.  Surface-enhanced Raman spectroscopy with abrasively modified fiber optic probes , 1991 .

[11]  Tuan Vo-Dinh,et al.  SERS chemical sensors and biosensors: new tools for environmental and biological analysis☆ , 1995 .

[12]  Charles K. Mann,et al.  Raman spectroscopy: what do we need for field measurements? , 1995, Other Conferences.

[13]  T. Murphy,et al.  Development of a SERS optode for the in-situ detection of chemicals in sea water , 1999, Optics East.

[14]  Heinz-Detlef Kronfeldt,et al.  Use of sol-gel techniques in the development of surface-enhanced Raman scattering (SERS) substrates suitable for in situ detection of chemicals in sea-water , 1999 .

[15]  Mark A. Arnold.  Fiber-Optic Chemical Sensors , 1992 .

[16]  T. Murphy,et al.  Detection of chemicals in seawater using surface-enhanced Raman scattering (SERS) , 1997, Other Conferences.

[17]  R. Lieberman.  Recent progress in intrinsic fiber-optic chemical sensing II , 1993 .

[18]  M. Delhaye,et al.  Raman confocal microprobing, imaging and fibre‐optic remote sensing: A further step in molecular analysis , 1994 .

[19]  C. K. Chong,et al.  Raman spectroscopy with a fiber-optic probe , 1992 .

[20]  Shiv k. Sharma,et al.  Determination of Low Concentrations of the Azo-Dye Complex of Nitrite in Fresh Water and Seawater Using Surface-Enhanced Resonance Raman Spectroscopy (SERRS) , 1992 .

[21]  S. Angel,et al.  THE UTILIZATION OF DIODE LASERS FOR RAMAN SPECTROSCOPY , 1995 .

[22]  Adolfas K. Gaigalas,et al.  Moving spectroelectrochemical cell for surface Raman spectroscopy , 1997 .