Wall insulation measures for residential villas in Dubai: A case study in energy efficiency

Abstract Over the past decade Dubai's energy demand has increased in sync with the rapid urban development and population growth of the UAE. In particular the residential villa stock has grown by more than 300% from 20,000 villas in 2000 to over 60,000 villas in 2009. In order to limit energy consumption, the local authorities introduced building legislation (2001 and 2003) that prescribes minimum insulation levels for external walls and roofs. The resulting constructive solutions focus on the use of a mid-plane insulated prefabricated block to attain the prescribed maximum wall U value (0.57 W/m 2  K), however the reinforced concrete frame typically remains non-insulated, and thus introduces significant thermal bridges in the building envelope. This work investigates the impact of this thermal bridging effect on the building's energy consumption by modeling (hourly simulation using DesignBuilder/EnergyPlus) the energetic performance of a series of typically applied insulation strategies, both for buildings in the initial design stage, and in retrofit mode. The simulation model is calibrated against collected consumption data and experimental infiltration measurements of the actual building. Simulation results show that with appropriate external wall insulation strategies alone, energy savings of up to 30% are realized.

[1]  Steve Sharples,et al.  Paper No 142: Energy Performance Benchmarking (EPB): A system to measure building energy efficiency , 2008 .

[2]  Stephen Sharples,et al.  Will energy regulations in the Gulf States make buildings more comfortable - A scoping study of residential buildings , 2009 .

[3]  Theodoros Theodosiou,et al.  The impact of thermal bridges on the energy demand of buildings with double brick wall constructions , 2008 .

[4]  Elizabeth Kossecka,et al.  Multi-dimensional heat transfer through complex building envelope assemblies in hourly energy simulation programs , 2002 .

[5]  L. J. Grobler,et al.  A new and innovative look at anti-insulation behaviour in building energy consumption , 2008 .

[6]  Michael J. Witte,et al.  Analytical and comparative testing of EnergyPlus using IEA HVAC BESTEST E100-E200 test suite , 2004 .

[7]  Mohammad. Rasul,et al.  Thermal-comfort analysis and simulation for various low-energy cooling-technologies applied to an office building in a subtropical climate , 2008 .

[8]  A. Kazim.  Assessments of primary energy consumption and its environmental consequences in the United Arab Emirates , 2007 .

[9]  H. Radhi,et al.  Can envelope codes reduce electricity and CO2 emissions in different types of buildings in the hot climate of Bahrain , 2009 .

[10]  Keith J. Moss.  Energy Management in Buildings , 2005 .

[11]  Lina Yang,et al.  Cooling load reduction by using thermal mass and night ventilation , 2008 .

[12]  Mohsen M. Aboulnaga,et al.  Environmental sustainability assessment of buildings in hot climates: the case of the UAE , 2001 .

[13]  Andrea Gasparella,et al.  Analysis and modelling of window and glazing systems energy performance for a well insulated residential building , 2011 .

[14]  R. Judkoff,et al.  Lessons Learned from Case Studies of Six High-Performance Buildings , 2006 .

[15]  Hassan Radhi,et al.  Evaluating the potential impact of global warming on the UAE residential buildings – A contribution to reduce the CO2 emissions , 2009 .