The effect of selected parameters of the honing process on cylinder liner surface topography

Many truck cylinder liners made from gray cast iron were machined. Ceramic and diamond honing stones were used in the last stages of operation: coarse honing and plateau honing. The effect of honing parameters on the cylinder liner surface topography was studied. Selected surface topography parameters were response variables. It was found that parameters from the Sq group were sensitive to honing parameter change. When plateau honing time varied, the Smq parameter increased, while the other parameters, Spq and Svq, were stable.

[1]  Pawel Pawlus,et al.  Effects of honed cylinder surface topography on the wear of piston-piston ring-cylinder assemblies under artificially increased dustiness conditions , 1993 .

[2]  Hassan Zahouani,et al.  Multiscale study of finish-honing process in mass production of cylinder liner , 2011 .

[3]  Pawel Pawlus,et al.  The study of cylinder liner plateau honing process , 2009 .

[4]  Bengt-Göran Rosén,et al.  Optimization of cylinder liner surface finish by slide honing , 2012 .

[5]  F. Giusti,et al.  A Study on the Functional Properties of a Honed Surface , 1982 .

[6]  Sabeur Mezghani,et al.  Running-in wear modeling of honed surface for combustion engine cylinderliners , 2013 .

[7]  Eduardo Tomanik,et al.  Friction and wear bench tests of different engine liner surface finishes , 2008 .

[8]  Zlate Dimkovski,et al.  Surfaces of Honed Cylinder Liners , 2011 .

[9]  J. C. Campbell,et al.  Cylinder bore surface roughness in internal combustion engines: Its appreciation and control , 1972 .

[10]  Bengt-Göran Rosén,et al.  New cylinder liner surfaces for low oil consumption , 2008 .

[11]  G. Haasis,et al.  NEW HONING TECHNIQUE REDUCES OIL CONSUMPTION , 1999 .

[12]  Pawel Pawlus,et al.  A study on the functional properties of honed cylinders surface during running-in , 1994 .

[13]  Bengt-Göran Rosén,et al.  Quantification of the cold worked material inside the deep honing grooves on cylinder liner surfaces and its effect on wear , 2009 .

[14]  Pawel Pawlus,et al.  Alternative descriptions of roughness for cylinder liner production , 2009 .

[15]  E. Tomanik.  Liner Honing Quality Main Characteristics , 1992 .

[16]  S. Tung,et al.  Impacts of Bore Surface Finish and Coating Treatment on Tribological Characteristics of Engine Cylinder Bores , 2002 .