Calculating the interior permanent-magnet motor

This paper describes the calculation of torque in a brushless permanent-magnet line-start AC motor by means of the flux-MMF diagram in combination with the finite-element method. Results are compared with measured flux-MMF diagrams, with shaft torque measurements, and with torque calculated using the classical phasor diagram.

[1]  Thomas M. Jahns,et al.  Flux-Weakening Regime Operation of an Interior Permanent-Magnet Synchronous Motor Drive , 1987, IEEE Transactions on Industry Applications.

[2]  Shigeo Morimoto,et al.  Rotor design optimisation of a multi-layer interior permanent-magnet synchronous motor , 1998 .

[3]  Hans-Peter Nee,et al.  Determination of d and q reactances of permanent-magnet synchronous motors without measurements of the rotor position , 2000 .

[4]  T.J.E. Miller,et al.  Torque prediction using the flux-MMF diagram in AC, DC, and reluctance motors , 1996 .

[5]  Calum Cossar,et al.  Line-start permanent magnet motor-single-phase steady-state performance analysis , 2003 .

[6]  N. Bianchi,et al.  Unified approach to the analysis and design of an AC motor drive for flux-weakening operations , 1998, Conference Record of 1998 IEEE Industry Applications Conference. Thirty-Third IAS Annual Meeting (Cat. No.98CH36242).

[7]  Dan M. Ionel,et al.  Design considerations for permanent magnet synchronous motors for flux weakening applications , 1998 .

[8]  N. Bianchi,et al.  Magnetic models of saturated interior permanent magnet motors based on finite element analysis , 1998, Conference Record of 1998 IEEE Industry Applications Conference. Thirty-Third IAS Annual Meeting (Cat. No.98CH36242).

[9]  T.J.E. Miller,et al.  Design of a new axially-laminated interior permanent magnet motor , 1993, Conference Record of the 1993 IEEE Industry Applications Conference Twenty-Eighth IAS Annual Meeting.