Innovative waste heat recovery systems in rotorcrafts

Research in modern helicopters is targeted into the increase of their efficiency due to economical and ecological pressures. This paper introduces two innovative methods of absorbing a ratio of the energy remains of the main engine exhaust gases and converting it to electrical energy. The recovered power is then injected to the electrical bus of the helicopter through power electronics converters. The first one uses thermoelectric generators whereas the second one an electromechanical generator. Both of these systems are analyzed, candidate power converter configurations and topologies are depicted and the results of simulations using SABER are evaluated.

[1]  Chongming Qiao,et al.  A general three-phase PFC controller for rectifiers with a parallel-connected dual boost topology , 2002 .

[2]  S. Ben-Yaakov,et al.  Modeling and Analysis of Thermoelectric Modules , 2005, IEEE Transactions on Industry Applications.

[3]  P. Barrade,et al.  A supercapacitor-based energy storage system for elevators with soft commutated interface , 2001, Conference Record of the 2001 IEEE Industry Applications Conference. 36th IAS Annual Meeting (Cat. No.01CH37248).

[4]  M. Kazimierczuk.  Pulse-Width Modulated DC-DC Power Converters: Kazimierczuk/Pulse-width Modulated DC-DC Power Converters , 2008 .

[5]  S. Waffler,et al.  25kW 3-Phase Unity Power Factor Buck Boost Rectifier with Wide Input and Output Range for Pulse Load Applications , 2007, 2007 IEEE 34th International Conference on Plasma Science (ICOPS).

[6]  Chih Wu.  Analysis of waste-heat thermoelectric power generators , 1996 .

[7]  G. Superti-Furga,et al.  Discussion on Instantaneous $p$ – $q$ Strategiesfor Control of Active Filters , 2008 .

[8]  Slobodan Cuk.  A new zero-ripple switching dc-to-dc converter and integrated magnetics , 1980, 1980 IEEE Power Electronics Specialists Conference.

[9]  Zhang Yi-cheng,et al.  Design of supercapacitor-based energy storage system for metro vehicles and its control rapid implementation , 2008, 2008 IEEE Vehicle Power and Propulsion Conference.

[10]  K. T. Chau,et al.  Thermoelectric automotive waste heat energy recovery using maximum power point tracking , 2009 .

[11]  M. A. Karri,et al.  THERMOELECTRICAL ENERGY RECOVERY FROM THE EXHAUST OF A LIGHT TRUCK , 2003 .

[12]  J. I. Ghojel,et al.  Waste heat recovery from the exhaust of low-power diesel engine using thermoelectric generators , 2001, Proceedings ICT2001. 20 International Conference on Thermoelectrics (Cat. No.01TH8589).

[13]  J. C. Salmon.  Reliable 3-phase PWM boost rectifiers employing a stacked dual boost converter subtopology , 1996 .

[14]  Philippe Delarue,et al.  Energy Storage System With Supercapacitor for an Innovative Subway , 2010, IEEE Transactions on Industrial Electronics.

[15]  Ian Moir,et al.  Aircraft Systems: Mechanical, Electrical, and Avionics Subsystems Integration , 2008 .

[16]  J.A. Ortega,et al.  Moving towards a more electric aircraft , 2007, IEEE Aerospace and Electronic Systems Magazine.

[17]  V.G. Agelidis,et al.  Comparative study of maximum power point tracking algorithms for thermoelectric generators , 2008, 2008 Australasian Universities Power Engineering Conference.

[18]  Dragan Maksimovic,et al.  Switching converters with wide DC conversion range , 1991 .

[19]  Keiko Ikoma,et al.  Thermoelectric module and generator for gasoline engine vehicles , 1998, Seventeenth International Conference on Thermoelectrics. Proceedings ICT98 (Cat. No.98TH8365).

[20]  Y. Nishida,et al.  Three-phase PWM-current-source type PFC rectifier (theory and practical evaluation of 12kW real product) , 2002, Proceedings of the Power Conversion Conference-Osaka 2002 (Cat. No.02TH8579).

[21]  Keng C. Wu.  Pulse width modulated DC/DC converters , 1997 .

[22]  Slobodan Cuk,et al.  A general unified approach to modelling switching-converter power stages , 1977 .

[23]  Pavel Drabek,et al.  The energy storage system with supercapacitor for public transport , 2009, 2009 IEEE Vehicle Power and Propulsion Conference.