A Prototype Intraoral Periapical Sensor with High Frame Rates for a 2.5D Periapical Radiography System

X-ray radiography is currently used in dentistry and can be divided into two categories: two-dimensional (2D) radiographic images (e.g., using periapical film, cephalometric film, and panoramic X-ray) and three-dimensional (3D) radiographic images (e.g., using dental cone-beam computed tomography (CBCT)). Among them, 2D periapical film images are most commonly used. However, 2D periapical film compresses 3D image information into a 2D image, which means that depth cannot be identified from the image. Such compressed images lose a considerable amount of information, reducing their clinical applicability. A 2.5D periapical radiography system prototype was developed by our research team. Our previous study indicated that this prototype could be used to capture images at different depths of an object. However, the prototype was limited by its commercially available intraoral periapical sensor, which had a low temporal resolution and could not capture multiple images in a short period of time. Therefore, the total time required for image capture was too long for practical clinical application. The present study developed a high-frame-rate intraoral periapical sensor with a sensor imaging speed of up to 15 Hz. The primary components of the developed intraoral periapical sensor include a scintillator, complementary metal oxide semiconductor chip, component circuit board, and video processing board. The external dimensions of the sensor are 41 × 26 × 6.6 mm3. The performance of the developed high-frame-rate intraoral periapical sensor was verified through qualified and quantified analyses using line pairs. The results showed that the resolution of the developed intraoral periapical sensor could reach 18 lp/mm. The sensor was further installed in our 2.5D periapical radiography system to conduct image capturing. The results indicated that the developed sensor could be used for high-frame-rate imaging to incorporate tomosynthesis to obtain reconstructed slice images of different depths. The developed sensor has the potential for clinical dentistry applications in the future.

[1]  C E Ravin,et al.  Principles of digital radiography with large-area, electronically readable detectors: a review of the basics. , 1999, Radiology.

[2]  Tao Wu,et al.  A comparison of reconstruction algorithms for breast tomosynthesis. , 2004, Medical physics.

[3]  D. G. Grant.  Tomosynthesis: a three-dimensional radiographic imaging technique. , 1972, IEEE transactions on bio-medical engineering.

[4]  S Rudin,et al.  Region-of-interest cone beam computed tomography (ROI CBCT) with a high resolution CMOS detector , 2015, Medical Imaging.

[5]  Ziran Zhao,et al.  X-ray digital intra-oral tomosynthesis for quasi-three-dimensional imaging: system, reconstruction algorithm, and experiments , 2013 .

[6]  D. Holdsworth,et al.  Micro-CT in small animal and specimen imaging , 2002 .

[7]  R Peng,et al.  A dynamic micro-CT scanner based on a carbon nanotube field emission x-ray source , 2009, Physics in medicine and biology.

[8]  W. Kalender,et al.  Flat-detector computed tomography (FD-CT) , 2007, European Radiology.

[9]  Montse Garcia,et al.  Assessment of the effects of decision aids about breast cancer screening: a systematic review and meta-analysis , 2017, BMJ Open.

[10]  J B Ludlow,et al.  Comparison of film, direct digital, and tuned-aperture computed tomography images to identify the location of crestal defects around endosseous titanium implants. , 1996, Oral surgery, oral medicine, oral pathology, oral radiology, and endodontics.

[11]  K. Ueda,et al.  Using a flat-panel detector in high resolution cone beam CT for dental imaging. , 2004, Dento maxillo facial radiology.

[12]  Otto Zhou,et al.  Stationary intraoral tomosynthesis for dental imaging , 2017, Medical Imaging.

[13]  Jui-Ting Hsu,et al.  PROTOTYPE OF A 2.5D PERIAPICAL RADIOGRAPHY SYSTEM USING AN INTRAORAL COMPUTED TOMOSYNTHESIS APPROACH , 2018 .

[14]  D. Kopans,et al.  Digital tomosynthesis in breast imaging. , 1997, Radiology.

[15]  H. Bosmans,et al.  Modern dental imaging: a review of the current technology and clinical applications in dental practice , 2010, European Radiology.

[16]  J Anthony Seibert,et al.  Digital adiography: The bottom line comparison of CR and DR technology , 2009 .

[17]  C J D'Orsi,et al.  Evaluation of linear and nonlinear tomosynthetic reconstruction methods in digital mammography. , 2001, Academic radiology.

[18]  Peter C Gøtzsche,et al.  Cochrane review on screening for breast cancer with mammography , 2001, The Lancet.

[19]  A. Logani,et al.  Recent advances in imaging technologies in dentistry. , 2014, World journal of radiology.

[20]  Otto Zhou,et al.  Characterization and preliminary imaging evaluation of a clinical prototype stationary intraoral tomosynthesis system , 2018, Medical physics.

[21]  Marja Ekholm,et al.  Quality assurance in digital dental imaging: a systematic review , 2014, Acta odontologica Scandinavica.

[22]  Joachim Mühling,et al.  Digital tomosynthesis—experiences with a new imaging device for the dental field , 2003, Clinical Oral Investigations.

[23]  M Abreu,et al.  Comparative diagnostic performance of TACT slices and its multiple source images: an in vitro study. , 2004, Dento maxillo facial radiology.

[24]  M. Pharoah,et al.  Imaging techniques and image interpretation for dental implant treatment. , 1998, The International journal of prosthodontics.

[25]  E Platin,et al.  Stationary intraoral digital tomosynthesis using a carbon nanotube X-ray source array. , 2015, Dento maxillo facial radiology.

[26]  M. Kortesniemi,et al.  Dental cone beam CT: A review. , 2015, Physica medica : PM : an international journal devoted to the applications of physics to medicine and biology : official journal of the Italian Association of Biomedical Physics.

[27]  J. Siewerdsen,et al.  Modeling and evaluation of a high‐resolution CMOS detector for cone‐beam CT of the extremities , 2018, Medical physics.