CFD Analysis of a Centrifugal Fan for Performance Enhancement using Converging Boundary Layer Suction Slots

Generally flow behavior in centrifugal fan is observed to be in a state of instability with flow separation zones on suction surface as well as near the front shroud. Overall performance of the diffusion process in a centrifugal fan could be enhanced by judiciously introducing the boundary layer suction slots. With easy accessibility of CFD as an analytical tool, an extensive numerical whole field analysis of the effect of boundary layer suction slots in discrete regions of suspected separation points is possible. This paper attempts to explore the effect of boundary layer suction slots corresponding to various geometrical locations on the impeller with converging configurations for the slots. The analysis shows that the converging suction slots located on the impeller blade about 25% from the trailing edge, significantly improves the static pressure recovery across the fan. Also it is found that Slots provided at a radial distance of about 12% from the leading and trailing edges marginally improve the static pressure recovery across the fan.

[1]  Hiroshi Tsukamoto,et al.  Numerical Study of Pressure Fluctuations Caused by Impeller-Diffuser Interaction in a Diffuser Pump Stage , 2001 .

[2]  Peter Ott,et al.  BOUNDARY LAYER SUCTION VIA A SLOT IN A TRANSONIC COMPRESSOR - NUMERICAL PARAMETER STUDY AND FIRST EXPERIMENTS , 2004 .

[3]  Chia-Jung Hsu.  Numerical Heat Transfer and Fluid Flow , 1981 .

[4]  Effect of suction on boundary-layer flow over a 2-D slot , 1982 .

[5]  C. R. Smith,et al.  The control of turbulent end-wall boundary layers using surface suction , 1999 .

[7]  Koen Hillewaert,et al.  Numerical Simulation of Impeller–Volute Interaction in Centrifugal Compressors , 1998 .

[8]  R. A. Van den Braembussche,et al.  Three-Dimensional Unsteady Flow and Forces in Centrifugal Impellers With Circumferential Distortion of the Outlet Static Pressure , 1997 .

[9]  Farid Bakir,et al.  Flow Study in the Impeller–Diffuser Interface of a Vaned Centrifugal Fan , 2005 .

[10]  Tom Hynes,et al.  Control of Three-Dimensional Separations in Axial Compressors by Tailored Boundary Layer Suction , 2008 .

[11]  James M. Sorokes,et al.  Investigation of the Circumferential Static Pressure Non-Uniformity Caused by a Centrifugal Compressor Discharge Volute , 1998 .

[12]  S. Raghunathan,et al.  Passive boundary layer control with slots in short diffusers , 2000 .

[13]  L. V. Dommelen,et al.  Boundary-layer separation control on a thin airfoil using local suction , 2005, Journal of Fluid Mechanics.

[14]  A. R. Noorpoor,et al.  Numerical Investigation of Flow Control by Suction and Injection on a Subsonic Airfoil , 2005 .

[15]  Seung O Park,et al.  A Study of Impeller-Diffuser-Volute Interaction in a Centrifugal Fan , 2005 .

[16]  F. Smith,et al.  Vortices and flow reversal due to suction slots , 2005, Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences.