Experimental prediction on the performance and propagation of ceiling jets under the influence of wall confinement

Abstract Characteristics of ceiling jets propagation are very significant for energy detecting and controlling once an undesirable energy source releasing flame and toxic pollutant emissions is erupted in a building. In many cases, the impinging ceiling jet flame will be affected by the nearby wall, especially for the energy source very close to or immediately against a wall. Four sets of experiments were conducted with energy source in open space, confined by an unbounded ceiling, confined by a wall-ceiling configuration and confined by two parallel walls (a corridor-like structure). Results show that the impinging ceiling jet-flame behaves very differently in different wall-ceiling configurations, the ceiling flame extension and the heat flux to nearby field increases dramatically with increasing confinement strength, from unbounded ceiling to narrow confined corridor-like structure. Based on the limits of flame extension, the temperature distribution under the ceiling can be divided into the near-field region within the ceiling flame and the far-field region beyond the ceiling flame. Predictive correlations of ceiling flame and temperature distribution are proposed to account for different wall-ceiling configurations. The results of this study have implications to optimize the design and arrangement of the ceiling-mounted heat and energy detection, protection and controlling systems.

[1]  J. Ji,et al.  Effects of ambient pressure on transport characteristics of thermal-driven smoke flow in a tunnel , 2018 .

[2]  D. Drysdale.  An Introduction to Fire Dynamics , 2011 .

[3]  Daniel Gross,et al.  Measurement of flame lengths under ceilings , 1988 .

[4]  Pengfei Jie,et al.  Optimizing the insulation thickness of walls and roofs of existing buildings based on primary energy consumption, global cost and pollutant emissions , 2018, Energy.

[5]  Haukur Ingason,et al.  Fire Spread and Flame Length in Large-Scale Tunnel Fires , 2006 .

[6]  C. Cheung,et al.  Heat transfer optimization of an impinging port-array inverse diffusion flame jet , 2013 .

[7]  Chandra Sekhar,et al.  Ceiling mounted personalized ventilation system in hot and humid climate—An energy analysis , 2010 .

[8]  P.L. Hinkley,et al.  THE CONTRIBUTION OF FLAMES UNDER CEILINGS TO FIRE SPREAD IN COMPARTMENTS PART II. COMBUSTIBLE CEILING LININGS , 1968 .

[9]  Philip Haves,et al.  Experimentally-determined characteristics of radiant systems for office buildings , 2018, Applied Energy.

[10]  J. Ji,et al.  Experimental study on horizontal gas temperature distribution of two propane diffusion flames impinging on an unconfined ceiling , 2019, International Journal of Thermal Sciences.

[11]  Yuji Hasemi,et al.  Some Experimental Aspects of Turbulent Diffusion Flames and Buoyant Plumes from Fire Sources Against a Wall and in a Corner of Walls , 1984 .

[12]  J. Ji,et al.  An experimental study on combustion performance and flame spread characteristics over liquid diesel and ethanol-diesel blended fuel , 2019, Energy.

[13]  J. Quintiere,et al.  An integral model for turbulent flame radial lengths under a ceiling , 2012 .

[14]  S. Atallah.  FIRES IN A MODEL CORRIDOR WITH A SIMULATED COMBUSTIBLE CEILING. PART I - RADIATION, TEMPERATURE AND EMISSIVITY MEASUREMENTS , 1966 .

[15]  T. Kubota,et al.  Visible structure of buoyant diffusion flames , 1985 .

[16]  William J. Rinkinen,et al.  Some Observations on the Shape of Impinging Diffusion Flames. , 1987 .

[17]  A. Veeraragavan.  On flame propagation in narrow channels with enhanced wall thermal conduction , 2015 .

[18]  Gerard M. Faeth,et al.  Ceiling heat transfer during fire plume and fire impingement , 1979 .

[19]  Jie Ji,et al.  An investigation of the detailed flame shape and flame length under the ceiling of a channel , 2015 .

[20]  Jin Guo,et al.  One Extended OTSU Flame Image Recognition Method Using RGBL and Stripe Segmentation , 2011 .

[21]  Lin Ma,et al.  CFD predictions of wake-stabilised jet flames in a cross-flow , 2013 .

[22]  Jin-hua Sun,et al.  Kinetic triplet determination and modified mechanism function construction for thermo-oxidative degradation of waste polyurethane foam using conventional methods and distributed activation energy model method , 2019, Energy.

[23]  Gunnar Heskestad,et al.  Turbulent jet diffusion flames: consolidation of flame height data , 1999 .

[24]  C. W. Leung,et al.  Pollutant emission and noise radiation from open and impinging inverse diffusion flames , 2012 .

[25]  Mohsen Sheikholeslami,et al.  Heat transfer improvement in a double pipe heat exchanger by means of perforated turbulators , 2016 .

[26]  Gunnar Heskestad,et al.  Luminous heights of turbulent diffusion flames , 1983 .

[27]  Manhou Li,et al.  Smoke spread characteristics inside a tunnel with natural ventilation under a strong environmental wind , 2018, Tunnelling and Underground Space Technology.

[28]  R. B. Williamson,et al.  Ignition Sources In Room Fire Tests And Some Implications For Flame Spread Evaluation , 1991 .

[29]  Davood Domiri Ganji,et al.  Heat transfer enhancement in an air to water heat exchanger with discontinuous helical turbulators; experimental and numerical studies , 2016 .

[30]  Jie Ji,et al.  Predicting heat fluxes received by horizontal targets from two buoyant turbulent diffusion flames of propane burning in still air , 2018 .