CFD simulations of compressed air two stage rotary Wankel expander – Parametric analysis

Abstract A small scale volumetric Wankel expander is a powerful device for small-scale power generation in compressed air energy storage (CAES) systems and Organic Rankine cycles powered by different heat sources such as, biomass, low temperature geothermal, solar and waste heat leading to significant reduction in CO 2 emissions. Wankel expanders outperform other types of expander due to their ability to produce two power pulses per revolution per chamber additional to higher compactness, lower noise and vibration and lower cost. In this paper, a computational fluid dynamics (CFD) model was developed using ANSYS 16.2 to simulate the flow dynamics for a single and two stage Wankel expanders and to investigate the effect of port configurations, including size and spacing, on the expander’s power output and isentropic efficiency. Also, single-stage and two-stage expanders were analysed with different operating conditions. Single-stage 3D CFD results were compared to published work showing close agreement. The CFD modelling was used to investigate the performance of the rotary device using air as an ideal gas with various port diameters ranging from 15 mm to 50 mm; port spacing varying from 28 mm to 66 mm; different Wankel expander sizes (r = 48, e = 6.6, b = 32) mm and (r = 58, e = 8, b = 40) mm both as single-stage and as two-stage expanders with different configurations and various operating conditions. Results showed that the best Wankel expander design for a single-stage was (r = 48, e = 6.6, b = 32) mm, with the port diameters 20 mm and port spacing equal to 50 mm. Moreover, combining two Wankel expanders horizontally, with a larger one at front, produced 8.52 kW compared with single-stage which gave 4.75 kW power output at the same operating conditions. Also, a maximum isentropic efficiency of 91% was calculated with inlet pressure of 6 bar and inlet temperature of 400 K at 7500 rpm for the two-stage compared to the 87.25% for the single-stage.

[1]  Paul A. Erickson,et al.  An experimental investigation of hydrogen-enriched gasoline in a Wankel rotary engine , 2014 .

[2]  S. D. Probert,et al.  Expansion machine for a low power-output steam Rankine-cycle engine , 1991 .

[3]  S. D. Probert,et al.  Wankel engines as steam expanders: Design considerations , 1991 .

[4]  Luigi Martorano,et al.  Experimental and Numerical Analysis of the Valve Timing Effects on the Performances of a Small Volumetric Rotary Expansion Device , 2014 .

[5]  S. D. Probert,et al.  Rotary Wankel engines as expansion devices in steam Rankine-cycle engines , 1991 .

[6]  David C. Walther,et al.  The design of ARCTIC : A rotary compressor thermally insulated μcooler , 2007 .

[7]  Yu Han,et al.  The Numerical Investigation on the Performance of Rotary Engine with Leakage, Different Fuels and Recess sizes , 2013 .

[8]  Wen Wang,et al.  Effects of leakage and friction on the miniaturization of a Wankel compressor , 2011 .

[9]  Bernhard Geringer,et al.  Implementation of a Rotary Engine (Wankel Engine) in a CFD Simulation Tool with Special Emphasis on Combustion and Flow Phenomena , 2015 .

[10]  Marco Antonelli,et al.  A study on the rotary steam engine for distributed generation in small size power plants , 2011 .

[11]  Vincenzo Delle Site,et al.  Wankel engine for hybrid powertrain , 1995 .

[12]  Hong Xue,et al.  Experimental and numerical investigation of the fluid flow in a side-ported rotary engine , 2015 .

[13]  Jae Wan Park,et al.  A numerical investigation on the efficiency of range extending systems using Advanced Vehicle Simula , 2011 .

[14]  Paul A. Erickson,et al.  An experimental study of a hydrogen-enriched ethanol fueled Wankel rotary engine at ultra lean and full load conditions , 2016 .

[15]  Richard Franz Ansdale,et al.  The Wankel RC engine : design and performance , 1968 .

[16]  Wei Wang,et al.  Miniaturization limitations of rotary internal combustion engines , 2016 .

[18]  Luigi Martorano,et al.  Analysis of a Low Concentration Solar Plant with Compound Parabolic Collectors and a Rotary Expander for Electricity Generation , 2014 .

[19]  Daniel C. H. Yang,et al.  Design of rotary engines from the apex seal profile (Abbr.: Rotary engine design by apex seal) , 2013 .

[20]  Lung-Jieh Yang,et al.  Design of a small wankel engine , 2012, 2012 7th IEEE International Conference on Nano/Micro Engineered and Molecular Systems (NEMS).

[21]  Yasuo Moriyoshi,et al.  Numerical Analysis of Combustion and Flow Inside a Small Rotary Engine for Developing an Unmanned Helicopter , 2007 .

[22]  F. P. Brito,et al.  Analysis of four-stroke, Wankel, and microturbine based range extenders for electric vehicles , 2012 .

[23]  Umberto Desideri,et al.  Operating maps of a rotary engine used as an expander for micro-generation with various working fluids , 2014 .

[24]  Daniel C. H. Yang,et al.  Wide and multiple apex seals for the rotary engine , 2014 .