Brush Seal Performance and Durability Issues Basedon T-700 Engine Test Results

The integrity and performance of brush seals have been established. Severe bench and engine tests have shown high initial wear or rub-in rates, material smearing at the interface, and bristle and rub-runner wear, but the brush seals did not fail. Short-duration (46 hr) experimental T-700 engine testing of the compressor discharge seal established over 1-percent engine performance gain (brush versus labyrinth). Long-term gains were established only as leakage comparisons, with the brush at least 20 percent better at controlling leakage. Long-term materials issues, such as wear and ultimately seal life, remain to be resolved. Future laeeds are cited for materials and analysis tools that account for heat generation, thermomechanical behavior, and tribological pairing to enable original equipment manufacturers to design high-temperature, high-surface-speed seals with confidence.

[1]  R. J. Richmond Advanced Earth-to-Orbit Propulsion Technology 1992 , 1992 .

[2]  E. Atkinson,et al.  Effects of material choices on brush seal performance , 1992 .

[3]  Robert C. Hendricks,et al.  Relative performance comparison between baseline labyrinth and dual-brush compressor discharge seals in a T-700 engine test , 1994 .

[4]  J. G. Ferguson,et al.  Brushes as High Performance Gas Turbine Seals , 1988 .

[5]  Robert L. Mullen,et al.  A Bulk Flow Model of a Brush Seal System , 1991 .

[6]  Robert C. Hendricks,et al.  Flow visualization and motion analysis for a series of four sequential brush seals , 1992 .

[7]  Paul Nelson,et al.  Evaluation of brush seals for limited-life engines , 1990 .

[8]  Robert C. Hendricks,et al.  INTEGRITY TESTING OF BRUSH SEAL IN SHROUD RING OF T-700 ENGINE , 1993 .

[9]  H. L. Stocker,et al.  Aerodynamic performance of conventional and advanced design labyrinth seals with solid-smooth abradable, and honeycomb lands. [gas turbine engines] , 1977 .

[10]  D. Childs,et al.  Rotordynamic and leakage characteristics of a 4-stage brush seal , 1992 .

[11]  R. Flower,et al.  Brush seal development system , 1990 .

[12]  J. Derby,et al.  Tribopair evaluation of brush seal applications , 1992 .

[13]  V. V. Kudriavtsev,et al.  A Numerical Simulation of a Brush Seal Section and Some Experimental Results , 1993 .

[14]  Robert C. Hendricks,et al.  Brush seal low surface speed hard-rub characteristics , 1993 .

[15]  Robert C. Hendricks,et al.  Brush seal leakage performance with gaseous working fluids at static and low rotor speed conditions , 1992 .