Numerical study on thermal behaviors of a solar chimney incorporated with PCM

Abstract The thermal behaviors of a solar chimney incorporating with organic phase change material (PCM) RT-42 unit under different heat fluxes are studied in this paper. For the numerical model, effective heat capacity method is employed to analyze the performance of RT-42, while the average thermo-physical property approach is used to describe the PCM/fins component. The PCM behaviors during its melting and solidification processes, absorber surface temperature, mass flow rate, and inlet and outlet air temperature difference have been investigated. The numerical results give good agreements with the experimental results. The comprehensive investigations under various heat fluxes from 100 to 800 W/m 2 are carried out by using the verified model. The numerical results show that the performance of the system deteriorates sharply once the heat flux is or lower than 500 W/m 2 , but not big improvement if the heat flux is higher than 700 W/m 2 . Therefore, the performance of the system is highly dependent on the solar radiation. The application of high effective thermal conductivity enhancers can further improve the performance of the chimney under lower solar radiation.

[1]  Jyotirmay Mathur,et al.  Experimental investigations on solar chimney for room ventilation , 2006 .

[2]  Claude-Alain Roulet,et al.  Natural ventilation for passive cooling: measurement of discharge coefficients , 1998 .

[3]  Luisa F. Cabeza,et al.  Use of microencapsulated PCM in concrete walls for energy savings , 2007 .

[4]  S. Burek,et al.  Air flow and thermal efficiency characteristics in solar chimneys and Trombe Walls , 2007 .

[5]  Jyotirmay Mathur,et al.  SUMMER-PERFORMANCE OF INCLINED ROOF SOLAR CHIMNEY FOR NATURAL VENTILATION , 2006 .

[6]  M. Bhandari,et al.  Solar chimney for enhanced stack ventilation , 1993 .

[7]  Zhanxiu Chen,et al.  Experimental Study on the Thermal Storage Performance and Preparation of Glycerin Mixtures Used in the Phase Change Wall , 2008, 2010 WASE International Conference on Information Engineering.

[8]  L. Chow,et al.  Thermal conductivity enhancement for phase change storage media , 1989 .

[9]  Luisa F. Cabeza,et al.  Experimental study of using PCM in brick constructive solutions for passive cooling , 2010 .

[10]  Jiang Yi,et al.  Modeling and experimental study on an innovative passive cooling system—NVP system , 2003 .

[11]  Cristina H. Amon,et al.  PCM thermal control unit for portable electronic devices: experimental and numerical studies , 2003 .

[12]  Carson C. Chow,et al.  Performance of a solar chimney , 2003 .

[13]  J. Su,et al.  Fabrication and properties of microencapsulated-paraffin/gypsum-matrix building materials for thermal energy storage , 2012 .

[14]  Yvan Dutil,et al.  A review on phase-change materials: Mathematical modeling and simulations , 2011 .

[15]  Ruzhu Wang,et al.  An overview of phase change material slurries: MPCS and CHS , 2010 .

[16]  S. Whitaker.  The method of volume averaging , 1998 .

[17]  J. Martı´-Herrero,et al.  Dynamic physical model for a solar chimney , 2007 .

[18]  M. Macias,et al.  Application of night cooling concept to social housing design in dry hot climate , 2006 .

[19]  Ramadan Bassiouny,et al.  An analytical and numerical study of solar chimney use for room natural ventilation , 2008 .

[20]  Luca A. Tagliafico,et al.  Dynamic thermal models and CFD analysis for flat-plate thermal solar collectors - A review , 2014 .

[21]  J. Darkwa,et al.  Enhanced laminated composite phase change material for energy storage , 2011 .

[22]  R. Lehtiniemi,et al.  Numerical and experimental investigation of melting and freezing processes in phase change material storage , 2004 .

[23]  Shuli Liu,et al.  Experimental study on thermal performance of a solar chimney combined with PCM , 2014 .

[24]  Takahiko Miyazaki,et al.  The effects of solar chimneys on thermal load mitigation of office buildings under the Japanese climate , 2006 .

[25]  Luigi Marletta,et al.  A methodology for investigating the effectiveness of PCM wallboards for summer thermal comfort in buildings , 2013 .