Experimental study of a squeeze film damper with eccentric circular orbits

An experiment was carried out to investigate the distribution of oil pressure within a squeeze film damper. The damper was made so that its operation turned out to be as simple as possible, in order to highlight the main causes of practical deviation from theoretical prediction, with particular reference to cavitating mechanisms and regardless of inertia effects. The journal of the damper was given an eccentric orbital precession, with adoption of two distinct values of the offset. A groove placed laterally to the film secured the oil feeding. An outlet plenum at the opposite side of the film was operated with two different levels of exposure to the ambient air. Observation of the oil pressure was restricted to the film section midway between the inlet and outlet border by means of three piezoelectric transducers plus a strain gauge sensor. Theoretical prediction with a simple isoviscous short bearing uncavitated model was shown to be a significant reference for the experimental data. Analysis of the pressure levels and shape of the pressure waves made it possible to recognize operating conditions with the presence of tensile stresses and rupture of the film. The latter conditions were chiefly due to vapor cavitation. In many circumstances, spikes with tensile strength preceded the ruptured region. Air entrainment and its effects proved to be restricted at high frequency regimes with very low supply pressures and coexisted with vapor cavitation. The influence of moderate orbital distortion on pressure signals was highlighted. Significant differences in the pressure behavior from one sensor location to the other, for the same operating conditions, were frequently observed.

[1]  Luis San Andrés,et al.  Analysis of Squeeze Film Dampers Operating With Bubbly Lubricants , 2000 .

[2]  Sergio E. Diaz,et al.  Reduction of the Dynamic Load Capacity in a Squeeze Film Damper Operating With a Bubbly Lubricant , 1998 .

[3]  J. M. Vance,et al.  A Density Correlation for a Two-Phase Lubricant and its Effect on the Pressure Distribution© , 1990 .

[4]  John M. Vance,et al.  Actively Controlled Bearing Dampers for Aircraft Engine Applications , 2000 .

[5]  B. R. Reason,et al.  A Study of Tensile Stresses in a Journal-Bearing Oil Film , 1976 .

[6]  G. Adiletta,et al.  The squeeze Film Damper over four decades of investigations. Part I: Characteristics and operating features , 2002 .

[7]  J. Y. Zhao,et al.  Unbalance Response of a Flexible Rotor Supported by a Squeeze Film Damper , 1998 .

[8]  D. E. Brewe,et al.  Theoretical Modeling of the Vapor Cavitation in Dynamically Loaded Journal Bearings , 1986 .

[9]  E. H. Smith.  The Influence of Surface Tension on Bearings Lubricated With Bubbly Liquids , 1980 .

[10]  Luis San Andrés,et al.  A model for squeeze film dampers operating with air entrainment and validation with experiments , 2001 .

[11]  Jiazhong Zhang,et al.  Calculation and bifurcation of fluid film with Cavitation Based on variational inequality , 2001, Int. J. Bifurc. Chaos.

[12]  D. Briceno,et al.  The effect of air entrapment on the performance of squeeze film dampers: Experiments and analysis , 1999 .

[13]  John M. Vance,et al.  Cavitation Leading to a Two Phase Fluid in a Squeeze Film Damper , 1989 .

[14]  J. Nikolajsen.  Viscosity and Density Models for Aerated Oil in Fluid-Film Bearings© , 1999 .

[15]  Andras Z. Szeri,et al.  On the flow of emulsions in tribological contacts , 1996 .

[16]  Eric J. Hahn,et al.  Effects of Gas Entrainment on Squeeze Film Damper Performance , 1987 .

[17]  J. F. Walton,et al.  Experimental Observation of Cavitating Squeeze-Film Dampers , 1987 .

[18]  B. J. Hamrock,et al.  High-speed motion picture camera experiments of cavitation in dynamically loaded journal bearings , 1983 .

[19]  O. Pinkus,et al.  Theory of Hydrodynamic Lubrication , 1962 .

[20]  Sergio E. Diaz,et al.  Air Entrainment Versus Lubricant Vaporization in Squeeze Film Dampers: An Experimental Assessment of Their Fundamental Differences , 2001 .

[21]  Lelio Della Pietra.  Analytical and Experimental Investigation of Squeeze-Film Dampers Executing Circular Orbits , 2000 .

[22]  E. Hahn,et al.  Density and Viscosity Models for Two-Phase Homogeneous Hydrodynamic Damper Fluids , 1986 .

[23]  K. Rajagopal,et al.  Lubrication With Binary Mixtures: Bubbly Oil , 1993 .

[24]  Luis San Andrés,et al.  Flow Visualization and Forces From a Squeeze Film Damper Operating With Natural Air Entrainment , 2003 .

[25]  John A. Tichy,et al.  An Experimental and Theoretical Study of Cavitation in a Finite Submerged Squeeze Film Damper , 1990 .

[26]  R. E. Craine,et al.  CONTINUUM THEORIES OF MIXTURES: BASIC THEORY AND HISTORICAL DEVELOPMENT , 1976 .

[27]  L. Andrés,et al.  Measurements of Pressure in a Squeeze Film Damper with an Air/Oil Bubbly Mixture , 1998 .

[28]  John M. Vance,et al.  Cavitation Regimes in Squeeze Film Dampers and Their Effect on the Pressure Distribution , 1990 .

[29]  David E. Brewe,et al.  Simultaneous pressure measurement and high-speed photography study of cavitation in a dynamically loaded journal bearing , 1994 .