A PZT-based smart aggregate for seismic shear stress monitoring

A lead zirconate titanate (PZT)-based smart aggregate (SA) is proposed for seismic shear stress monitoring in concrete structures. This SA uses a d15-mode PZT as the sensing element. A calibration test is designed in which a cyclic shear stress with a dominant frequency of the earthquake response spectrum is applied on the two opposite sides of the proposed SA using a specially designed loading mold. The test is repeated on six copies of the proposed SA. The maximum applied shear stress is larger than the shear strength of ordinary concrete to allow measurements during failure. The output voltage of the SA is experimentally verified as varying linearly with the applied stress in the loading range. The sensitivity of the proposed SA to the applied stress under the given boundary conditions is examined. The calibrated sensitivity value is then compared with the calculated value, which is obtained by computing the stress distribution in the SA using finite element analysis (FEA). The calculated values and the calibrated values are approximately the same, indicating that the established finite element (FE) model is reliable. Monotonic loading is also applied on the proposed SA to induce cracks between the SA and the loading mold, and the SA’s response to cracking processes is examined. It is found that the proposed SA underestimates the cracking process. This study demonstrates that the proposed SA can be used in monitoring the overall shear stress development process in concrete during a seismic event.

[1]  Jinping Ou,et al.  Strain sensing properties of cement-based sensors embedded at various stress zones in a bending concrete beam , 2011 .

[2]  L. Chernozatonskii,et al.  Graphene-based semiconductor nanostructures , 2013 .

[3]  Alaa G Sherif,et al.  INVESTIGATION OF PRE-AND POSTCRACKING SHEAR BEHAVIOR OF PRESTRESSED CONCRETE BEAMS USING INNOVATIVE MEASURING TECHNIQUES , 2004 .

[4]  Jack P. Moehle,et al.  Collapse of a nonductile concrete frame: Shaking table tests , 2009 .

[5]  Gangbing Song,et al.  Concrete early-age strength monitoring using embedded piezoelectric transducers , 2006 .

[6]  Xiaoming Yang,et al.  Test on sensor effect of cement matrix piezoelectric composite , 2005 .

[7]  Gangbing Song,et al.  Multi-functional smart aggregate-based structural health monitoring of circular reinforced concrete columns subjected to seismic excitations , 2010 .

[8]  Jinping Ou,et al.  Embedded piezoresistive cement-based stress/strain sensor , 2007 .

[9]  Jinping Ou,et al.  Modeling of piezoresistivity of carbon black filled cement-based composites under multi-axial strain , 2010 .

[10]  Gangbing Song,et al.  Progressive collapse of a two-story reinforced concrete frame with embedded smart aggregates , 2009 .

[11]  Kenneth J. Elwood,et al.  Collapse of a nonductile concrete frame: Evaluation of analytical models , 2009 .

[12]  Raimundo Delgado,et al.  Shear effects on hollow section piers under seismic actions: experimental and numerical analysis , 2009 .

[13]  H. Shiohara.  New Model for Shear Failure of RC Interior Beam-Column Connections , 2001 .

[14]  Jack P. Moehle,et al.  Experimental Study on Dynamic Behavior of Multi-Story Reinforced Concrete Frames with Non-Seismic Detailing , 2009 .

[15]  Zhongxian Li,et al.  Application of Cement-Based Piezoelectric Sensors for Monitoring Traffic Flows , 2006 .

[16]  Gangbing Song,et al.  Smart Aggregate-Based Damage Detection of Circular RC columns under Cyclic Combined Loading , 2010 .

[17]  Amr S. Elnashai,et al.  Importance of shear assessment of concrete structures detailed to different capacity design requirements , 2008 .

[18]  Terje Haukaas,et al.  Classification and Seismic Safety Evaluation of Existing Reinforced Concrete Columns , 2007 .

[19]  J. Feng,et al.  Measurement of concrete internal strain using a three-dimensional transducer system , 2005 .

[20]  Jack P. Moehle,et al.  Dynamic collapse analysis for a reinforced concrete frame sustaining shear and axial failures , 2008 .

[21]  Basile G. Rabbat,et al.  Notes on ACI 318-08, building code requirements for structural concrete : with design applications , 2008 .

[22]  Gangbing Song,et al.  An overheight vehicle–bridge collision monitoring system using piezoelectric transducers , 2007 .

[23]  Gangbing Song,et al.  Health monitoring of reinforced concrete shear walls using smart aggregates , 2009 .

[24]  Laura N. Lowes,et al.  Probabilistic model for failure initiation of reinforced concrete interior beam–column connections subjected to seismic loading , 2011 .

[25]  Jinping Ou,et al.  Experimental study on use of nickel powder-filled Portland cement-based composite for fabrication of piezoresistive sensors with high sensitivity , 2009 .