A discussion of the formation of ultra-fine grains in low-carbon steels based on FE analysis

A FE analysis was performed to study the formation of ultra-fine grains in a new hot rolling process. It was verified in this paper that ultra-fine grains were caused by high level undercooling and high level strain. The level of undercooling and the level of strain of the strip during this new rolling process were studied quantitatively with FE analysis. It was found that the critical undercooling to achieve ultra-fine grain was about 190 K. Compression experiments were done with a schedule involving rapid cooling before deformation to achieve high level undercooling. Ultra-fine grains were achieved in compressed experiments and the critical undercooling to obtain ultra-fine grains was about 200 K, similar to that calculated by FE analysis. (C) 2002 Elsevier Science B.V. All rights reserved.

[1]  T. Ishikawa,et al.  Metallurgical Features of Steel Plates with Ultra Fine Grains in Surface Layers and their Formation Mechanism , 1999 .

[2]  Y. Matsumura,et al.  Evolution of Ultrafine-grained Ferrite in Hot Successive Deformation , 1987 .

[3]  B. Mintz.  Role of silicon in influencing strength and impact behaviour of ferrite and its likely influence at ultrafine grain size , 2000 .

[4]  A. Howe.  Ultrafine grained steels: industrial prospects , 2000 .

[5]  R. Priestner,et al.  Processing of steel for ultrafine ferrite grain structures , 2000 .

[6]  G. Kelly,et al.  Ultrafine ferrite formation during hot strip rolling , 2000 .

[7]  P. Hodgson,et al.  Ultrafine ferrite in low carbon steel , 1999 .

[8]  P. Hodgson,et al.  Nucleation sites for ultrafine ferrite produced by deformation of austenite during single-pass strip rolling , 2001 .

[9]  P. Hodgson,et al.  Microstructure and microtexture of ultrafine ferrite formed in 0.1%C steel using new strip rolling process , 2000 .

[10]  P. Hodgson,et al.  Analysis and characterisation of ultra-fine ferrite produced during a new steel strip rolling process , 1999 .

[11]  P. Hodgson,et al.  Formation of ultra-fine ferrite in hot rolled strip: potential mechanisms for grain refinement , 2001 .

[12]  P. Hodgson,et al.  Ferrite grain coarsening during transformation of thermomechanically processed C–Mn–Nb austenite , 1992 .

[13]  J. E. Lewis,et al.  Importance of deformation induced ferrite and factors which control its formation , 1997 .

[14]  P. Hodgson,et al.  The Production and Mechanical Properties of Ultrafine Ferrite , 1998 .

[15]  D. Kwon,et al.  Transformation strengthening by thermomechanical treatments in C-Mn-Ni-Nb steels , 1995 .

[16]  F. J. Humphreys,et al.  Processing to ultrafine grain structures by conventional routes , 2000 .

[17]  B. Mintz,et al.  Hot ductility of steels and its relationship to the problem of transverse cracking in continuous casting , 2010 .