Numerical study of the influence of foundation compressibility and reinforcement stiffness on the behavior of reinforced soil walls

Abstract Most geosynthetic and metallic reinforced soil walls are designed assuming that the wall foundation is rigid and/or does not influence the magnitude and distribution of reinforcement loads under operational conditions. This assumption may not apply to walls constructed over compliant (compressible) foundations. This paper describes the results of a series of numerical simulations that were carried out on idealized 3·6, 6, and 9 m-high modular block walls seated on foundations having four different compressibility values. The walls were constructed with two reinforcement materials having very different stiffness values but the same tensile strength. The results of simulations show that as foundation stiffness decreases, reinforcement loads increase. However, for the two reinforcement materials in this study, the influence of axial stiffness of the reinforcement had a greater effect on wall performance than the foundation stiffness for walls subjected to operational (working stress) conditions at end of construction.

[1]  Richard J. Bathurst,et al.  A new working stress method for prediction of reinforcement loads in geosynthetic walls , 2003 .

[2]  Wei F. Lee,et al.  New Method for Prediction of Loads in Steel Reinforced Soil Walls , 2004 .

[3]  Richard J. Bathurst,et al.  Reinforcement loads in geosynthetic walls and the case for a new working stress design method , 2005 .

[4]  Poul V. Lade,et al.  Overview of Constitutive Models for Soils , 2005 .

[5]  Kianoosh Hatami,et al.  Development and verification of a numerical model for the analysis of geosynthetic-reinforced soil segmental walls under working stress conditions , 2005 .

[6]  D. Wood,et al.  Soil constitutive models: evaluation, selection and calibration , 2005 .

[7]  Kianoosh Hatami,et al.  Numerical Model for Reinforced Soil Segmental Walls under Surcharge Loading , 2006 .

[8]  Richard J. Bathurst,et al.  Refinement of K-stiffness Method for geosynthetic-reinforced soil walls , 2008 .

[9]  Kianoosh Hatami,et al.  Numerical Study of Reinforced Soil Segmental Walls Using Three Different Constitutive Soil Models , 2009 .

[10]  Richard J. Bathurst,et al.  Influence of reinforcement stiffness and compaction on the performance of four geosynthetic-reinforced soil walls , 2009 .

[11]  Richard J. Bathurst,et al.  Facing Displacements in Geosynthetic Reinforced Soil Walls , 2010 .

[12]  Richard J. Bathurst,et al.  Influence of foundation compressibility on reinforcement loads in geosynthetic reinforced soil walls , 2012 .

[13]  Alejandro Josa,et al.  Vertical-Facing Loads in Steel-Reinforced Soil Walls , 2013 .

[14]  Richard J. Bathurst,et al.  Comparison of Working Stress and Limit Equilibrium Behavior of Reinforced Soil Walls , 2013 .

[15]  Richard J. Bathurst,et al.  Performance of an 11 m high block-faced geogrid wall designed using the K-stiffness method , 2014 .