Temperature Dependent Power Modeling of Photovoltaics

Abstract Photovoltaic (PV) systems in the USA are often perceived as useful only in warm and sunny climate regions. However, PV systems can be installed and operated in cold regions as well, including places that get snow. Sunlight is the source of electricity, and thermal heat is not required to generate electricity in PV systems. Given similar irradiation conditions, lower PV-cell temperatures can lead to increases in efficiency, which leads to an increase in power generation, thus allowing the user to benefit more from the PV technology. This study focuses on the relationship between the level of energy production and varying temperatures. Two models have been developed to show temperature effect on photovoltaic systems, using transient systems simulation (TRNSYS), a FORTRAN-based modular program to assess solar conversion and heat transfer. The first model (Model A) ignores temperature and the other (Model B) takes it into consideration. In Model A, the efficiency was assumed to be constant through the year. In Model B, the temperature and the resulting efficiency change of the PV cells are defined according to deviations from the nominal operating cell temperature (NOCT), using equations from the literature. These two models were executed for 236 cities across the USA by using second-generation Typical Meteorological Year (TMY) data. These two models calculate discrete outputs of power density, given irradiance and temperature conditions. Comparative analyses were made between these two models. The power output differences for 236 cities across the USA were used to generate contour maps indicating a continuous surface of differences between these two models. Comparing Model B relative to Model A power outputs increase during the months of November to February for the Northeast and the Midwest regions of the USA (16% -20%), whereas they decrease slightly in May to August (-4%). On the other hand, power outputs decrease considerably from May to August for the South and Southwest of the USA (-12% - 15%), whereas they increase slightly from December to February (5%). Geospatial trends show two different behaviours in winter time and in summer time due to ambient temperature.

[1]  Wouter Buytaert,et al.  Human impact on the hydrology of the Andean páramos , 2006 .

[2]  D. L. Evans,et al.  Cost studies on terrestrial photovoltaic power systems with sunlight concentration , 1977 .

[3]  G. Gordillo,et al.  Performance monitoring results of the first grid-connected BIPV system in Colombia , 2008 .

[4]  W. Beckman,et al.  Solar Engineering of Thermal Processes , 1985 .

[5]  E. Skoplaki,et al.  ON THE TEMPERATURE DEPENDENCE OF PHOTOVOLTAIC MODULE ELECTRICAL PERFORMANCE: A REVIEW OF EFFICIENCY/ POWER CORRELATIONS , 2009 .

[6]  Dhirayut Chenvidhya,et al.  Estimating operating cell temperature of BIPV modules in Thailand , 2009 .

[7]  Hongxing Yang,et al.  Investigation of conjugate heat transfer in a photovoltaic wall , 2004 .

[8]  Li Zhu,et al.  Effect of urban climate on building integrated photovoltaics performance , 2007 .

[9]  J. L. Balenzategui,et al.  Estimation of photovoltaic module yearly temperature and performance based on Nominal Operation Cell Temperature calculations , 2004 .

[10]  D. Marks,et al.  A comparison of geostatistical procedures for spatial analysis of precipitation in mountainous terrain , 1992 .

[11]  Jimmy Royer,et al.  Photovoltaics in cold climates , 1999 .

[12]  Michael Edward Hohn,et al.  An Introduction to Applied Geostatistics: by Edward H. Isaaks and R. Mohan Srivastava, 1989, Oxford University Press, New York, 561 p., ISBN 0-19-505012-6, ISBN 0-19-505013-4 (paperback), $55.00 cloth, $35.00 paper (US) , 1991 .

[13]  Sulaiman Shaari,et al.  Photovoltaics in buildings: A case study for rural England and Malaysia , 1998 .

[14]  E. Skoplaki,et al.  A simple correlation for the operating temperature of photovoltaic modules of arbitrary mounting , 2008 .

[15]  E. Skoplaki,et al.  Operating temperature of photovoltaic modules: A survey of pertinent correlations , 2009 .

[16]  Gilles Notton,et al.  Calculation of the polycrystalline PV module temperature using a simple method of energy balance , 2006 .

[17]  M. Muller.  Measuring and Modeling Nominal Operating Cell Temperature (NOCT) , 2010 .

[18]  Mark W. Davis,et al.  Evaluating building integrated photovoltaic performance models , 2002, Conference Record of the Twenty-Ninth IEEE Photovoltaic Specialists Conference, 2002..

[19]  A. Fiksel,et al.  Developments to the TRNSYS simulation program , 1995 .

[20]  Joseph Kuitche,et al.  Nominal Operating Cell Temperature (NOCT): Effects of module size, loading and solar spectrum , 2009, 2009 34th IEEE Photovoltaic Specialists Conference (PVSC).