Plasma density limits during Ohmic L mode and ELMing H mode operation in DIII-D

The density limits were determined in Ohmic and L mode discharges over a wide range of parameters: BT = 0.8-2.1 T, Ip = 0.5-1.9 MA, an elongation of 1.09 to 1.92, Zeff < 2, Pbeam 8 MW and ne,max 1.2 × 1020 m-3. The density limits in ELMing H mode discharges were also determined and found to be comparable with those of the Ohmic and L mode discharges. In Ohmic plasmas, the density limit increased linearly with Ip and decreased with minor radius (~1/a2.4); the density limit showed little, if any, dependence on either BT or plasma elongation. These results are in good qualitative agreement with Greenwald density limit scaling, (ne,max(1020 m-3) ~ Ip (MA)/a2 (m)). In discussing the density limits of detached plasmas, the 'effective' minor radius must be considered. The density limit data for L and H mode discharges were also consistent with Greenwald scaling. The density limits in the L and H modes were insensitive to the heating power. In the Ohmic and L mode cases, rotating MHD modes, typically with m/n=2/1, existed in high density discharges with no perceptible adverse impact on particle confinement until they locked, precipitating global disruptive behaviour. To date, the data show that the ELMing H mode density limit is not disruptive in itself

[1]  J. R. Myra,et al.  Stability optimization in tandem mirrors , 1984 .

[2]  A. Gibson.  Radiation limits to tokamak operation , 1976 .

[3]  D. N. Hill,et al.  Divertor heat flux reduction by D2 injection in DIII-D , 1992 .

[4]  L. Lao,et al.  Reconstruction of current profile parameters and plasma shapes in tokamaks , 1985 .

[5]  G. Staebler.  Transport modelling of divertor bias experiments , 1991 .

[6]  D. N. Hill,et al.  D III-D divertor target heat flux measurements during ohmic and neutral beam heating , 1988 .

[7]  P. C. Stangeby,et al.  Plasma boundary phenomena in tokamaks , 1990 .

[8]  F. Perkins,et al.  On the Murakami density limit in tokamaks and reversed‐field pinches , 1985 .

[9]  M. Nagami,et al.  Observation of cold, high-density plasma near the Doublet III limiter , 1982 .

[10]  T. Petrie,et al.  Impurity profiles for H-mode discharges in DIII-D , 1990 .

[11]  W. A. Peebles,et al.  Modifications in turbulence and edge electric fields at the L–H transition in the DIII‐D tokamak , 1991 .

[12]  N. Ohyabu.  Density limit in tokamaks , 1979 .

[13]  D. E. Perkins,et al.  Infrared thermography of the DIII‐D divertor targets , 1988 .

[14]  S. Wolfe,et al.  A new look at density limits in tokamaks , 1988 .

[15]  M. Hughes,et al.  A study of the effect of impurity radiation from the peripheral plasma of a tokamak reactor , 1981 .

[16]  T. Petrie,et al.  Scaling of energy confinement with minor radius, current and density in Doublet III Ohmically heated plasmas , 1982 .

[17]  Tadashi Sekiguchi,et al.  Plasma Physics and Controlled Nuclear Fusion Research , 1987 .

[18]  L. Berry,et al.  Some observations on maximum densities in tokamak experiments , 1976 .

[19]  Y. Sokolov,et al.  ITER: Concept definition , 1989 .

[20]  K. F. Mast,et al.  Disruptions in JET , 1989 .

[21]  Vallet,et al.  Stabilization of tokamak Ohmic discharges at the density limit by means of the ergodic divertor. , 1991, Physical review letters.

[22]  S. Wolfe,et al.  Marfe: an edge plasma phenomenon , 1984 .

[23]  C. Bush,et al.  Phenomenology of MARFEs in TFTR , 1987 .

[24]  J. Manickam,et al.  Attainment of high confinement in neutral beam heated divertor discharges in the PDX tokamak , 1984 .

[25]  Lao,et al.  Study of giant edge-localized modes in DIII-D and comparison with ballooning theory. , 1988, Physical review letters.

[26]  James F. Drake,et al.  Marfes: Radiative condensation in tokamak edge plasma , 1987 .

[27]  M. Keilhacker,et al.  Confinement Studies in L and H-Type ASDEX Discharges , 1984 .

[28]  W. Schneider,et al.  Thermal instabilities and poloidal asymmetries in the tokamak edge plasma , 1986 .