Effect of process variables on melt velocity profiles in extrusion process using single screw plastics extruder

Abstract Single screw extruders are used to generate a continuous flow of molten polymer in many industrial polymer processes. The melt velocity profile as extruded is important in determining the properties of the final product and influences process related phenomena such as die swell and the onset of sharkskin. The factors that influence the velocity profile would be expected to be the melt temperature (this affecting the viscosity of the melt), the screw and die geometry, and the output rate from the extruder. In the present work a thermocouple mesh sensor coupled with a cooled stainless tube has been used to determine velocity profiles in melts exiting from the screw of a single screw extruder. The results show that the technique can be used successfully to determine velocity profiles in the extrusion process. It was found that the main influence on the magnitude of the melt velocity was the extruder screw speed. Melt temperature, and hence melt viscosity, were found to have little effect on the velocity profiles measured. The flow in the centre of the duct was retarded slightly owing to the flow across the screw tip and no rotational component of flow was observed. The velocity profiles measured seemed to be reasonably stable, only small changes being observed in the velocity profiles as the melt flowed along a duct of uniform cross-section, although these changes were limited in nature. Die diameter and length had a limited effect on the velocity profiles generated, although the die entry angle did have a significant effect on the shape of the velocity profile at higher screw speeds.