Broadband Active Balun Using Combined Cascode–Cascade Configuration

A new configuration is proposed for an active balun, which uses a cascode and cascade pair with the shared input transistor. It is designed in the IBM 8HP 130-nm BiCMOS process, which operates over a broad bandwidth up to 17 GHz where the imbalance of the differential output is less than 1.8 dB in amplitude and less then 10 in phase, over the input's dynamic range of -25-5 dBm, under the dc power consumption of 198.8 mW. The circuit contains no internal dc blocking capacitors so that the bandwidth's lower end frequency best extends as close to dc as possible. The circuit contains only one line inductor with the value of 0.2 nH, and the compacted layout is expected to fit in limited chip areas as small as 0.2 mm times 0.2 mm, which makes them well suited for built-in self-test applications, as well as general differential circuits requiring compact-sized broadband baluns.

[1]  William R. Eisenstadt,et al.  SPICE-based mixed-mode S-parameter calculations for four-port and three-port circuits , 2006, IEEE Transactions on Computer-Aided Design of Integrated Circuits and Systems.

[2]  Katsuhiko Araki,et al.  A Novel Broadband Active Balun , 2003, 2003 33rd European Microwave Conference, 2003.

[3]  Yongnan Xuan,et al.  Computer-aided design of microwave frequency doublers using a new circuit structure , 1993 .

[4]  A. Platzker,et al.  A novel MMIC biphase modulator with variable gain using enhancement-mode FETS suitable for 3 V wireless applications , 1994, Proceedings of 1994 IEEE Microwave and Millimeter-Wave Monolithic Circuits Symposium.

[5]  William R. Eisenstadt,et al.  Lumped passive circuits for 5GHz embedded test of RF SoCs , 2004, 2004 IEEE International Symposium on Circuits and Systems (IEEE Cat. No.04CH37512).

[6]  Dylan F. Williams,et al.  A General Waveguide Circuit Theory , 1992, Journal of research of the National Institute of Standards and Technology.

[7]  T. Tokumitsu,et al.  A miniaturized, broadband MMIC frequency doubler , 1990, IEEE International Digest on Microwave Symposium.

[8]  Tao Zhang,et al.  On-chip microwave test circuits for production IC measurements , 2004, 64th ARFTG Microwave Measurements Conference, Fall 2004..

[9]  Fujiang Lin,et al.  Novel active differential phase splitters in RFIC for wireless applications , 1998, RFIC 1998.

[10]  William R. Eisenstadt,et al.  Embedded loopback test for RF ICs , 2005, IEEE Transactions on Instrumentation and Measurement.

[11]  I. D. Robertson,et al.  Monolithic MESFET distributed baluns based on the distributed amplifier gate-line termination technique , 1997 .

[12]  T. Tokumitsu,et al.  A minaturized broad-band MMIC frequency doubler , 1990 .

[13]  Deukhyoun Heo,et al.  A 5GHz LNA with new compact gain controllable active balun for ISM band applications , 2004, Proceedings. 7th International Conference on Solid-State and Integrated Circuits Technology, 2004..

[14]  Kazuki Tateoka,et al.  A GaAs single balanced mixer MMIC with built-in active balun for personal communication systems , 1995, IEEE 1995 Microwave and Millimeter-Wave. Monolithic Circuits Symposium. Digest of Papers.

[15]  W. Eisenstadt,et al.  Combined differential and common-mode scattering parameters: theory and simulation , 1995 .

[16]  J. Dunsmore.  New methods & non-linear measurements for active differential devices , 2003, IEEE MTT-S International Microwave Symposium Digest, 2003.