Influence of motor rotating speed on shaft voltage of brushless DC motor with insulated rotor driven by PWM inverters

The brushless DC motors are also becoming popular in air conditioning fan motors, and protection of bearing from electro-erosion is becoming a major challenge in the North Europe market in particular. The bearing electro-erosion is caused when the bearing lubricant is dielectrically broken down, making current run on the inner race and outer race of the bearing. As a countermeasure, we verified that shaft voltage was suppressed by the insulated rotor. Air conditioning fan motors are known to generate the necessary wind for cooling the heat exchanger and its motor rotating speed. It was also confirmed that the shaft voltage increased as the motor rotating speed increased. This paper describes the shaft voltage falls below the dielectric breakdown voltage of the bearing grease in the actual operating speed range and is also verified that insulated rotors are effective for suppressing electro-erosion with respect to changes in rotating speed.

[1]  M. M. Swamy,et al.  Common mode current attenuation techniques for use with PWM drives , 2001 .

[2]  Shigeo Morimoto,et al.  Approaches to suppressing shaft voltage in brushless DC motor driven by PWM inverter , 2011, 2011 International Conference on Electrical Machines and Systems.

[3]  Satoshi Ogasawara,et al.  Active Cancellation of the Common-Mode Voltage Produced by a Voltage-Source PWM Inverter , 1997 .

[4]  A. Muetze,et al.  Influence of Motor Operating Parameters on Discharge Bearing Current Activity , 2010, IEEE Transactions on Industry Applications.

[5]  Y. Murai,et al.  Leakage current reduction for a high-frequency carrier inverter feeding an induction motor , 1992 .

[6]  Doyle F. Busse,et al.  An evaluation of the electrostatic shielded induction motor: a solution for rotor shaft voltage buildup and bearing current , 1996, IAS '96. Conference Record of the 1996 IEEE Industry Applications Conference Thirty-First IAS Annual Meeting.

[7]  Annette Muetze,et al.  Calculation of Circulating Bearing Currents in Machines of Inverter-Based Drive Systems , 2004, IEEE Transactions on Industrial Electronics.

[8]  R. Schiferl,et al.  Circuit model for shaft voltage prediction in induction motors fed by PWM-based AC drives , 2003 .

[9]  Thomas A. Lipo,et al.  Modeling of motor bearing currents in PWM inverter drives , 1995 .

[10]  Hirofumi Akagi,et al.  Identification and Discussion of the Origin of a Shaft End-to-End Voltage in an Inverter-Driven Motor , 2010, IEEE Transactions on Power Electronics.

[11]  A. von Jouanne,et al.  A dual-bridge inverter approach to eliminating common mode voltages and bearing and leakage currents , 1997, PESC97. Record 28th Annual IEEE Power Electronics Specialists Conference. Formerly Power Conditioning Specialists Conference 1970-71. Power Processing and Electronic Specialists Conference 1972.

[12]  Satoshi Ogasawara,et al.  Analysis of Shaft Voltage and Bearing Current in an Inverter-Fed Nongrounded Motor , 2007 .

[13]  A. Binder,et al.  Calculation of Motor Capacitances for Prediction of the Voltage Across the Bearings in Machines of Inverter-Based Drive Systems , 2007, IEEE Transactions on Industry Applications.

[14]  Yves Gemeinder,et al.  Investigation of influence of bearing load and bearing temperature on EDM bearing currents , 2010, 2010 IEEE Energy Conversion Congress and Exposition.